Unifrax Australia Pty. Ltd.
326 Settlement Road
Thomastown, VIC 3074
ZIRCON WASH
ACN 093 625 757
Ph: (03) 9463 0000 Fax: (03) 9464 1176
MATERIAL SAFETY DATA SHEET
Classified as Hazardous according to criteria of Worksafe Australia
1. IDENTIFICATION OF MATERIAL & SUPPLIER
Product Name: Zircon Wash
Other Names: Castcoat ZW
Zircoat W
UN Number: None allocated
DG Classification: None allocated
Hazchem Code: None allocated
Poisons Schedule
Number: None allocated
Product Use: Refractory coating
Manufacturer/Supplier: Unifrax Australia Pty. Ltd.
(Manufactured for Unifrax Australia by other producers
using similar products).
Contact: See page 6
2. HAZARDS IDENTIFICATION
Flammability
Fire Hazards: Non flammable
Explosive Hazards: Non explosive
Health Hazards: Irritating to eyes, skin, respiratory system.
Authorised by: Alan Smith
Version: 1.4
Control Status: Controlled Document
Created on: 01/08/07 1
Unifrax Australia Pty. Ltd.
326 Settlement Road
Thomastown, VIC 3074
ZIRCON WASH
ACN 093 625 757
Ph: (03) 9463 0000 Fax: (03) 9464 1176
MATERIAL SAFETY DATA SHEET
Classified as Hazardous according to criteria of Worksafe Australia
3. COMPOSITION AND INFORMATION ON INGREDIENTS
Name CAS Proportion%
Zirconium Silicate 14940-68-2 > 60% Wt/Wt
Mineral clay 1302-78-9 < 10% Wt/Wt
PVA Polymer 25067-02-1 < 10% Wt/Wt
Water 7732-18-5 10-<30% Wt/Wt
Additives/preservative Non-hazardous < 1% Wr/Wt
4. FIRST AID MEASURES
Ingestion: Seek medical advice. Drink plenty of water DO NOT
induce vomiting.
Eye: If this material gets into eyes, irrigate immediately and
wash continuously for at least fifteen (15) minutes with
fresh running water.
Ensure irrigation under eyelids by occasionally lifting the
upper and lower lids. If irritation continues contact a
hospital without delay.
Removal of contact lenses after an eye injury should be
undertaken by skilled personnel.
Skin: Wash affected areas with water and soap. Remove any
adhering solids
Seek medical attention in the event irritation
Inhalation: Remove exposed person/s from source of exposure to
fresh air. If symptoms persist, seek medical advice.
ADVICE TO DOCTOR: Treat symptomatically.
Authorised by: Alan Smith
Version: 1.4
Control Status: Controlled Document
Created on: 01/08/07 2
Unifrax Australia Pty. Ltd.
326 Settlement Road
Thomastown, VIC 3074
ZIRCON WASH
ACN 093 625 757
Ph: (03) 9463 0000 Fax: (03) 9464 1176
MATERIAL SAFETY DATA SHEET
Classified as Hazardous according to criteria of Worksafe Australia
5. FIRE FIGHTING MEASURES.
Fire Explosion Hazard: Not Flammable and not explosive.
Hazardous Reactions/ Refer to SAFE HANDLING INFORMATION
Decomposition Products
Hazchem Code: None Allocated.
6. ACCIDENTAL RELEASE MEASURES
Spills or Release Contain liquid spills within a bund, use absorbent such
To the Environment as soil and sawdust or vermiculite. Pick up large quantities
with a shovel and place in containers.
7. HANDLING & STORAGE
Storage Precautions: Store in a cool dry place.
Safe Handling: Use gloves, eye protection and appropriate clothing &
footwear.
8. EXPOSURE CONTROLS & PERSONAL PROTECTION
Exposure Standards None assigned
Engineering Controls
Ventilation Use in a well ventilated or local exhaust ventilation
required general exhaust is adequate under normal
operating conditions. Local exhaust ventilation may be
required in special circumstances.
PERSONAL PROTECTION If inhalation risk of overexposure exists, wear SAA
approved respirator (air purifying type).
Authorised by: Alan Smith
Version: 1.4
Control Status: Controlled Document
Created on: 01/08/07 3
Unifrax Australia Pty. Ltd.
326 Settlement Road
Thomastown, VIC 3074
ZIRCON WASH
ACN 093 625 757
Ph: (03) 9463 0000 Fax: (03) 9464 1176
MATERIAL SAFETY DATA SHEET
Classified as Hazardous according to criteria of Worksafe Australia
8. Exposure Controls & Personal Protection cont鈥檇:
SAA approved respirator (supplied air type) may be
required in special circumstances.
Correct is essential to ensure adequate protection
Respiratory Protection General exhaust is adequate under normal operating
conditions.
If Inhalation risk of over exposure exists, wear SAA
approved respirator (air purifying type)
Eye Protection No special equipment needed when handling small
quantities.
Contact lenses may pose a special hazard, soft lenses
may absorb irritants and concentrate them.
Skin No special equipment needed when handling small
quantities.
Wear chemical protective gloves for prolonged contact.
Always wash hands before smoking, eating, drinking or
using the toilet.
Glove Type Rubber or PVA.
Clothing Overalls or similar protective apparel. Work clothes should
be laundered separately.
Footwear Safety footwear as appropriate.
9. PHYSICAL & CHEMICAL PROPERTIES
Appearance: Light Purple Vapour Pressure: N/A
Specific Gravity: 2.3 鈥? 2.4 Kg/Lt Solubility in Water: Insoluble in
Melting Point: N/A (or Alcohol) water or
Flash Point: N/A alcohol. Can
1000C
Boiling Point: be diluted with
Flammability Limits: N/A water.
Authorised by: Alan Smith
Version: 1.4
Control Status: Controlled Document
Created on: 01/08/07 4
Unifrax Australia Pty. Ltd.
326 Settlement Road
Thomastown, VIC 3074
ZIRCON WASH
ACN 093 625 757
Ph: (03) 9463 0000 Fax: (03) 9464 1176
MATERIAL SAFETY DATA SHEET
Classified as Hazardous according to criteria of Worksafe Australia
10. STABILITY & REACTIVITY
Stability: Stable under normal conditions of use.
Hazardous Reactions N/A
Decomposition Products
11. TOXICOLOGICAL INFORMATION
N/A
12. ECOLOGICAL INFORMATION
N/A
13. DISPOSAL CONSIDERATIONS
Waste should be placed in containers, plastic bags or other methods which prevent liquid
or dust emission, and disposed of in accordance with the local waste disposal authority
requirements.
14. TRANSPORT INFORMATION
No special transport requirements are necessary.
UN Number None Allocated
Shipping Name None Allocated
DG Class None Allocated
Packaging Group None Allocated
Hazchem Code None Allocated
Poisons Schedule Not Scheduled
Authorised by: Alan Smith
Version: 1.4
Control Status: Controlled Document
Created on: 01/08/07 5
Unifrax Australia Pty. Ltd.
326 Settlement Road
Thomastown, VIC 3074
ZIRCON WASH
ACN 093 625 757
Ph: (03) 9463 0000 Fax: (03) 9464 1176
MATERIAL SAFETY DATA SHEET
Classified as Hazardous according to criteria of Worksafe Australia
15. REGULATORY INFORMATION
Hazard Category: Harmful, irritant.
Poisons Schedule: Not scheduled.
16. OTHER INFORMATION
+61 3 9463 0000
Contact: During Business Hours Ph:
Customer Service Toll Free: Ph: 1300 797 888
Emergency / After Hours Contact: Alan Smith
Ph: 0409 288 916
References: Replaces MSDS dated 27 March 2007.
NOTICE: The information presented herein is based on data considered to be accurate
as of the date of preparation of this Material Safety Data Sheet. However, no
warranty or representation, express or implied, is made as to the accuracy or
completeness of the foregoing data and safety information, nor is any
authorisation given or implied to practise any patented invention without licence.
In addition, no responsibility can be assumed by the vendor for any damage or
injury resulting from abnormal use, from any failure to adhere to recommended
practices, or from any hazards inherent in the nature of the product.
鈥︹?nd of Report鈥︹??
Authorised by: Alan Smith
Version: 1.4
Control Status: Controlled Document
Created on: 01/08/07 6
|