EMS CATALOG NO: 19230/19240
EMS PRODUCT: PIPES
DATE: 12/28/2000
PAGE NUMBER: One of 3
MATERIAL SAFETY DATA SHEET
The information contained herein is based on data considered
accurate. However, no warranty is expressed or implied
regarding the accuracy of these data or the results to be
obtained from the use thereof.
Electron Microscopy Sciences assumes no responsibility for
personal injury or property damage to vendees, users or
third parties caused by the material. Such vendees or users
assume all risks associated with the use of the material.
ELECTRON MICROSCOPY SCIENCES
321 MORRIS ROAD
P.O. BOX 251
FORT WASHINGTON, PA 19034 24 HOUR EMERGENCY PHONE NUMBER
(215) 646-1566 CHEMTREC: (800) 424-9300
_________________________________________________________________
FOR PRODUCT AND SALES INFORMATION
_________________________________________________________________
CONTACT ELECTRON MICROSCOPY SCIENCES OFFICE ABOVE.
_________________________________________________________________
PRODUCT IDENTIFICATION
_________________________________________________________________
PRODUCT NAME: PIPES, 1.5 Sodium Salt
SYNONYMS: Piperazine-N,N-Bis 2-Ethanesulfonic Acid
1.5 Sodium
CAS NUMBER: 100037-69-2
OSHA REGULATED COMPONENTS: No Hazardous Components
_________________________________________________________________
TOXICITY HAZARDS
_________________________________________________________________
No data available.
_________________________________________________________________
HEALTH HAZARD DATA
_________________________________________________________________
HEALTH HAZARDS ACUTE/CHRONIC:
May be harmful by inhalation, ingestion or skin absorption. May
cause irritation.
SIGNS & SYMPTOMS OF EXPOSURE: No data available.
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: No data available.
EMERGENCY/FIRST AID PROCEDURES:
If ingested and conscious rinse out mouth with copious amounts of
water. In case of contact with skin, flush with copious amounts
of water for at least 15 minutes. Remove contaminated clothing
and shoes. Wash before re use. If inhaled move victim to fresh
air. If breathing is difficult give oxygen. If not breathing
administer artificial respiration. In case of contact with eyes,
flush with copious amounts of water for at least 15 minutes.
Lift upper and lower lids to assure adequate flushing. In all
cases call a physician immediately.
________________________________________________________________
FIRE AND EXPLOSION HAZARD DATA
_________________________________________________________________
FLASH POINT: N/A
EXTINGUISHING MEDIA: Carbon dioxide, dry chemical powder,
alcohol, or polymer foam.
SPECIAL FIRE FIGHTING PROCEDURES:
Wear self contained breathing apparatus and protective clothing
to prevent contact with skin and eyes.
UNUSUAL FIRE AND EXPLOSION HAZARDS:
Emits toxic fumes under fire conditions.
_________________________________________________________________
PHYSICAL/CHEMICAL CHARACTERISTICS
_________________________________________________________________
BOILING POINT: N/A
SPECIFIC GRAVITY: N/A
VAPOR PRESSURE: Unknown
VAPOR DENSITY: N/A
APPEARANCE AND ODOR: White powder
_________________________________________________________________
REACTIVITY DATA
_________________________________________________________________
STABILITY: Stable.
CONDITIONS TO AVOID: No data available.
INCOMPATIBILITY: Strong oxidizing agents.
HAZARDOUS DECOMPOSITION
2
PRODUCTS: Toxic fumes of CO2, CO, Nitrogen and
Sulfur oxides
HAZARDOUS POLYMERIZATION: Will not occur.
_________________________________________________________________
SPILL OR LEAK PROCEDURES
_________________________________________________________________
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED:
Wear protective equipment. Sweep up, place in a sealed
container and hold for waste disposal. Avoid raising dust.
Ventilate area and wash spill site after cleanup is complete.
WASTE DISPOSAL METHOD:
Observe all Federal, State and local regulations. Dissolve or
mix with a combustible solvent and burn in a chemical incinerator
equipped with an after burner and scrubber.
STORAGE/HANDLING PRECAUTIONS:
Avoid inhalation. Avoid contact with eyes, skin and clothing.
Avoid prolonged or repeated exposure. Wash thoroughly after
handling. Keep tightly closed. Store in a cool dry place.
LABEL PRECAUTIONARY STATEMENTS: No data available.
_________________________________________________________________
EMPLOYEE PROTECTION INFORMATION
_________________________________________________________________
RESPIRATORY PROTECTION: Wear approved NIOSH/MSHA respirator.
VENTILATION: Mechanical exhaust required.
PROTECTIVE GLOVES: Chemical resistant gloves.
EYE PROTECTION: Chemical safety goggles.
OTHER PROTECTIVE EQUIPMENT: Safety shower and eye bath.
Protective clothing.
鈥?
3
|