READ SAFETY DIRECTIONS BEFORE OPENING OR USING
HERBICIDE
Active Constituent: 750 g/kg TRIFLOXYSULFURON SODIUM
For the control of Winter Grass, Ryegrass, Clover, Burr Medic and Nutgrass in Turf as per Directions for Use.
B
GROUP HERBICIDE
APVMA Approval No: 56687/25/1203 Pack size: 25 g (5 x 5 g)
GENERAL INSTRUCTIONS 2. Fill vat no more than 25% full with clean water before
adding MONUMENT. Begin agitating vat contents vigorously
MONUMENT is a selective herbicide for application after
and continue agitation during entire mixing and spraying
emergence of weeds, for control of certain weeds in
operations.
established turf. MONUMENT is a water dispersible granule
3. Water soluble sachets should be added to the tank first
formulation that must be thoroughly and uniformly mixed in
after water. Allow sachet to completely dissolve and
water and applied as a spray.
contents to fully disperse into the mix water.
The degree of control resulting from application of
4. Pour required amount of MONUMENT steadily into vat.
MONUMENT is primarily dependent upon weed species, weed
Allow vigorous bypass agitation to completely disperse
size at application, environmental conditions, amount of
product. DO NOT dump product into vat all at once.
MONUMENT applied, and growing conditions. Weed control is
5. After adding required quantity of MONUMENT and
greatly improved when weeds have emerged, ample soil
obtaining complete dispersion, continue to fill vat to desired
moisture exists, and weeds are actively growing, than when
level for spraying.
the soil is dry and weeds are under stress from lack of
6. Add required quantity of non-ionic surfactant if using and
moisture. Growth of susceptible weeds is inhibited soon after
continue agitation.
application of MONUMENT. The leaves of susceptible plants
7. Thorough agitation (preferably mechanical) of the spray
normally turn yellow, red or purple after several days, followed
liquid is essential during the addition of the product and
by necrosis and death of the growing point. Complete plant
during the entire spraying operation. Recirculate if left to
death generally occurs 2 to 4 weeks after application,
stand.
depending on the weed species, growing conditions etc.
NB Spray solution should NOT be left standing in the vat
Apply to actively growing weeds during early stages of
overnight.
development for best results. For optimum performance avoid
mowing for 1 to 2 days prior to and following application. Application
Ground application: Spray nozzles should be uniformly
Resistant Weeds Warning spaced and of the same size, and should provide accurate
MONUMENT Herbicide is a member of the sulfonylurea group and uniform application. Use spray nozzles that produce a
of herbicides and has the ALS Inhibitor mode of action. For medium spray quality. To ensure accuracy, calibrate sprayer
weed resistance management this product is a Group B at the beginning of the season before use and recalibrate
herbicide. Some naturally occuring weed biotypes resistant to frequently. Apply at a volume of 400 to 800 litres of water per
MONUMENT and other sulfonylurea herbicides may exist hectare. Higher volumes should be used for severe weed
through normal genetic variability in any weed population. infestations to ensure adequate spray coverage. It is
The resistant individuals can eventually dominate the weed recommended that a non-ionic surfactant be added to the
population if these herbicides are used repeatedly. These spray solution at 0.25 to 0.5% v/v ratio. Good weed coverage
resistant weeds will not be controlled by MONUMENT or other with the spray mixture is essential for optimum weed control.
Group B herbicides. Since the occurrence of resistant weeds Observe sprayer nozzles frequently during the spraying
is difficult to detect prior to use, Syngenta Crop Protection Pty operation to ensure that the spray pattern is uniform. Avoid
Limited accepts no liability for any losses that may result from overlapping of spray runs. Boom height for broadcast
the failure of MONUMENT to control the resistant weeds. application should not exceed 60 cm above the leaf blades of
Advice as to strategies and alternative treatments that can be the turf. Avoid application under conditions when uniform
used should be obtained from your local supplier, consultant, coverage cannot be obtained or when spray drift may occur.
local Department of Agriculture, Primary Industries DO NOT apply aerially or through any type of irrigation system
Department or a Syngenta representative. or equipment.
Rainfastness
Mode of Action
MONUMENT is rainfast within 3 hours of application.
MONUMENT controls weeds by inhibiting a biochemical
process that produces certain essential amino acids necessary Instructions to Avoid Spray Drift
for plant growth. The inhibited enzyme system is acetolactate DO NOT allow spray to drift onto adjacent turf sites or
synthase (ALS). ornamental plants as even small amounts may injure sensitive
plants. When drift may be a problem, take steps to reduce
Mixing spray drift including:
MONUMENT mixes readily with water - no pre-mixing is DO NOT spray if wind speed is greater than 10 km/hr or if
required. winds are gusting.
If pH of water carrier is less than 5.5, use a buffer solution to Use extreme caution when conditions are favourable for drift,
raise pH to near 7.0. DO NOT mix MONUMENT with acid ie high temperatures and low relative humidity, especially
forming compounds in the spray vat. when sensitive plants are located nearby. All plants not listed
This product must be mixed with water and applied by as turf species on this label should be considered as sensitive
suitable spray equipment. plants.
1. Clean the spray tank before using. If it is contaminated with If sensitive plants are downwind, extreme caution must be
other materials, mixing problems and/or clogging may used under all conditions. Drift from applications of this
occur, or injury to the turf may result. herbicide is likely to result in damage to sensitive plants
1 of 3
43
adjacent to the treatment site. This damage can occur at Replanting interval
levels below the concentrations that can be detected with DO NOT replant any crop or ornamentals to treated areas
chemical analysis. other than turfgrasses listed in Directions for Use for a period
DO NOT apply when a temperature inversion exists. If an of 12 months after application.
inversion condition is suspected, consult with local weather
services before making an application. PRECAUTION
Use nozzles that provide a uniform droplet size and produce Re-entry Period: DO NOT allow entry into treated areas until
medium to coarse droplets (250 to 400 microns VMD) that the spray has dried, unless wearing cotton overalls buttoned
are less likely to result in spray drift. to the neck and wrist (or equivalent clothing), chemical
Use flat fan nozzles. resistant gloves and footwear. Clothing must be laundered
If conditions favour drift, recalibrate sprayer by reducing spray after each day鈥檚 use.
pressures and increasing spray volumes to produce larger
droplets. PROTECTION OF CROPS, NATIVE AND OTHER NON-TARGET
Apply as close to surface of target turf as practical to obtain a PLANTS
good spray pattern for adequate coverage according to the This product is very highly toxic to non-target plants including
manufacturer鈥檚 recommendations. Ground applications are aquatic plants. DO NOT apply under weather conditions or
limited to a nozzle height of 60 cm above the ground. If this from spraying equipment that may cause spray to drift onto
is not possible or desirable, and the nozzle height is greater nearby susceptible plants/crops, cropping lands, pastures and
than 60 cm, then DO NOT apply within 10 metres downwind other non-target plants or natural and impounded lakes, dams
of bent grass greens. or other waterways. Avoid applications to areas where
DO NOT apply unless there is a 30 metre downwind buffer product may accumulate under the drip line of trees or where
distance between the treated areas and native vegetation. product may come into contact with roots of desirable plants.
DO NOT apply unless there is a 10 metre downwind buffer See Instructions to Avoid Spray Drift section above.
distance between the area being sprayed and natural
waterbodies. PROTECTION OF WILDLIFE, FISH, CRUSTACEANS AND
ENVIRONMENT
Sprayer Cleanup DO NOT contaminate streams, rivers or waterways with the
Thoroughly clean spray equipment using the following chemical or used containers. DO NOT apply if heavy rain is
procedure when you have finished spraying highly active forecast.
materials such as sulfonylurea products. Start with a
thoroughly cleaned sprayer before beginning the next job. STORAGE AND DISPOSAL
1. Mix only as much spray solution as needed. Immediately Store in the closed, original container in a dry, cool, well
after spraying, clean equipment thoroughly using this ventilated area out of direct sunlight.
procedure. Wear appropriate protective clothing. Rinse containers before disposal. Add rinsings to spray tank.
As a first step, flush tank, hoses, boom and nozzles with DO NOT dispose of undiluted chemicals on site. Dispose of at
clean water. a local authority landfill. If no landfill is available, bury the
2. Prepare a cleaning solution of 300 mL of household containers below 500 mm in a disposal pit specifically
ammonia per 100 L of water. Ensure ammonia used is marked and set up for this purpose clear of waterways,
fresh as it can degrade significantly over time resulting in a desirable vegetation and tree roots. Empty containers and
reduction in cleaning ability. product should not be burnt.
3. When available, use a pressure washer to clean the inside of
the spray tank with this solution. Take care to wash all parts SAFETY DIRECTIONS
of the tank, including the inside top surface and lid. Will irritate the eyes and skin. Avoid contact with eyes and
4. Completely fill the sprayer with the cleaning solution to skin. Wash hands after use.
ensure contact of the cleaning solution with all internal When preparing spray wear:
surfaces of the tank and plumbing. Start agitation in the 鈥? cotton overalls buttoned to the neck and wrist (or
sprayer and thoroughly recirculate the cleaning solution for equivalent clothing), and
at least 15 minutes. All visible deposits must be removed 鈥? elbow-length PVC gloves.
from the spraying system and in cases where there is the After each day鈥檚 use wash gloves and contaminated clothing.
possibility of heavy build up of residues the cleaning
solution may need to be left in the tank for extended FIRST AID
periods to ensure adequate decontamination of the tank. If poisoning occurs, contact a doctor or Poisons Information
5. Flush hoses, spray lines and nozzles for at least 1 minute Centre. Phone 131 126.
with the cleaning solution.
6. Dispose of rinsate from steps 1 to 5 in an appropriate MATERIAL SAFETY DATA SHEET
manner. If additional hazard information is required refer to the
7. Repeat steps 2 to 5. Material Safety Data Sheet. For a copy phone 1800 067 108
8. Remove nozzles, screens and strainers and clean separately or visit our website at www.syngenta.com.au
in the cleaning solution after completing the above
procedures. Be careful with filters, as they are a main MANUFACTURER鈥橲 WARRANTY AND EXCLUSION OF
source of contamination. LIABILITY
9. Rinse the complete spraying system with clean water. Syngenta has no control over storage, handling and manner of
The above method is only effective if the cleaning solution use of this product. Where this material is not stored, handled
comes into contact with every surface or contact point that or used correctly and in accordance with directions, no
may contain even minute sulfonylurea herbicide residues. In express or implied representations or warranties concerning
some boom sprayers this may not be physically possible and this product (other than non-excludable statutory warranties)
hence it may be advisable to use a different boomsprayer will apply. Syngenta accepts no liability for any loss or
that has not been used to spray sulfonylurea herbicides, damage arising from incorrect storage, handling or use.
when spraying sensitive crops or turf species.
庐 Registered trademark of a Syngenta Group Company
Compatibility
As formulations of other manufacturers鈥? products are beyond
the control of Syngenta Crop Protection, and water quality
varies with location, all mixtures should be tested prior to
mixing commercial quantities.
2 of 3
44
DIRECTIONS FOR USE
Restraints: DO NOT apply by air or through any type of irrigation equipment.
DO NOT apply when the turf or weeds are not actively growing.
DO NOT apply to turf under stress.
DO NOT apply to golf course putting greens.
DO NOT apply to Ryegrass, Fescue, Bentgrass, Kikuyu, Buffalo, Paspalum spp, Centipede Grass or any
other turf species not listed in the table below (unless listed under weeds controlled).
DO NOT apply to newly seeded, sodded or sprigged turf. Delay application until turf is at 100%
cover and root system is developed beyond a 5 cm depth.
Situation Weeds Controlled Rate Critical Comments
Established turf as Burr Medic 15 g/ha For best results apply with a minimum
named: (Medicargo polymorpha) water volume of 400 to 800 L/ha.
Common Couch The addition of a quality non-ionic
(Cynodon dactylon), Nutgrass 20 g/ha surfactant at a rate of 0.25鈥?0.5% v/v is
Hybrid Couch (Cyperus rotundus) recommended.
(Cynodon dactylon x A repeat application may be needed in
Cynodon transvaalensis), Wintergrass 30 g/ha 4 to 6 weeks.
Zoysia (Poa annua), Allow at least 6 weeks between last
(Zoysia japonica), Ryegrass application and overseeding with cool
Durban Grass (Lolium perenne) season grasses for winter cover.
(Dactyloctenium australe), Transient discolouration may occur when
Qld Blue Couch Clover 40 g/ha applied to Zoysia and Qld Blue Couch.
(Digitaria didactyla) (Trifolium repens)
NOT TO BE USED FOR ANY PURPOSE, OR IN ANY MANNER, CONTRARY TO THIS LABEL UNLESS AUTHORISED UNDER
APPROPRIATE LEGISLATION.
WITHHOLDING PERIOD
DO NOT GRAZE TREATED TURF/LAWN OR FEED TURF/LAWN CLIPPINGS FROM ANY TREATED AREA TO
POULTRY OR LIVESTOCK
3 of 3
45
|