UltraBreak
Page 1 of 3
MATERIAL SAFETY DATA SHEET
SECTION I: IDENTIFICATION OF PRODUCT
UltraBreak
PRODUCT NAME:
Defoamer
PRODUCT USE:
Alkanol and Surfactant blend in mineral oil
CHEMICAL FAMILY:
WORK PLACE HAZARDOUS MATERIALS INFORMATION SYSTEM (WHMIS)
D-2B B-3
WHMIS CLASSIFICATION:
Skin and eye irritant, Combustible Liquid
WORK PLACE HAZARD:
TRANSPORTATION OF DANGEROUS GOODS (TDG)
Not Regulated
SHIPPING NAME:
N/A
TDG CLASSIFICATION:
N/A
UN NUMBER (PIN):
N/A
PACKING GROUP:
SECTION II: HAZARDOUS INGREDIENTS
INGREDIENT PERCENT CAS NUMBER LD Oral-Rat OSHA PEL ACGIH TLV
(50)
2-ethyl-hexanol 10-30% 104-76-6 2049 mg/kg N/A N/A
SECTION III: TOXICOLOGICAL PROPERTIES
ROUTE OF ENTRY: [XX] SKIN [XX] EYE CONTACT [XX] INHALATION [XX] INGESTION
May cause irritation, redness and swelling on contact.
EYE CONTACT:
Repeated or prolonged contact may cause irritation and dermatitis.
SKIN CONTACT:
May cause nausea, vomiting, diarrhea, weakness, increased salivation and
INGESTION:
rhinitis. If large amounts are ingested, depression of central nervous system
may occur.
May cause anaesthetic effect or dizziness if inhaled. High vapour
INHALATION:
concentrations may cause headaches, drowsiness, unconsciousness and
other central nervous systems effects including death.
SECTION IV: FIRST AID MEASURES
Wash exposed area with soap and water for at least fifteen minutes. If irritation
SKIN CONTACT:
or adverse symptoms develop, seek medical attention.
Immediately flush eyes with running water for at least 15 minutes. If irritation or
EYE CONTACT:
adverse symptoms develop, seek medical attention.
Do not induce vomiting. Get patient to physician immediately.
INGESTION:
UltraBreak
Page 2 of 3
MATERIAL SAFETY DATA SHEET
Remove to fresh air. If not breathing, give artificial respiration, preferably
INHALATION:
mouth-to-mouth. If breathing is difficult, give oxygen. Call a physician.
SECTION V: PHYSICAL DATA
Green Liquid, Sweet Odour
APPEARANCE AND ODOUR:
0.890 g/m鲁
SPECIFIC GRAVITY:
N/A
BOILING POINT (掳C):
N/A
MELTING POINT (掳C):
N/D
pH:
Insoluble
SOLUBILITY IN WATER:
N/D
PERCENT VOLATILE BY VOLUME:
N/A
EVAPORATION RATE:
Not Established
VAPOUR PRESSURE (mm Hg):
N/A
VAPOUR DENSITY (Air = 1):
SECTION VI: FIRE AND EXPLOSION HAZARD DATA
81掳C
FLASH POINT:
N/A
FLAMMABLE LIMITS:
Dry chemical, foam, water fog, CO2
EXTINGUISHING MEDIA:
Respirators required for fire fighting personnel.
SPECIAL FIRE FIGHTING PROCEDURES:
N/A
UNUSUAL FIRE AND EXPLOSION HAZARDS:
SECTION VII: REACTIVITY DATA
STABILITY: Stable [XX] Unstable [ ]
Strong oxidizers.
INCOMPATIBILITY (CONDITIONS TO AVOID):
Carbon dioxide and carbon monoxide.
HAZARDOUS DECOMPOSITION PRODUCTS:
Will Not Occur [XX] May Occur [ ]
HAZARDOUS POLYMERIZATION:
SECTION VIII: PREVENTIVE MEASURES
SPECIAL PROTECTION INFORMATION
Suggest NIOSH/MESA approved air purifying respirator with organic
RESPIRATORY PROTECTION:
vapour.
Use adequate ventilation to control exposures.
VENTILATION:
Suggest neoprene or rubber gloves.
PROTECTIVE GLOVES:
Suggest safety glasses with side shields. Use chemical goggles if
EYE PROTECTION:
splashes could occur.
OTHER PROTECTIVE EQUIPMENT: Chemical resistant clothing.
UltraBreak
Page 3 of 3
MATERIAL SAFETY DATA SHEET
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING
Wash thoroughly after handling. Avoid prolonged or frequent contact when handling material. Avoid
contact with eyes, skin or clothing. Avoid breathing vapours, mist, fume, or dust. Wear protective
equipment and launder contaminated clothing before reuse. Use with adequate ventilation. Keep
container closed when not in use. Store in cool and dry location away from oxidizing agents.
STEPS TO BE TAKEN IN CASE THE MATERIAL IS SPILLED OR RELEASED
Use appropriate safety equipment. Contain spill to prevent pollution of water sources and sewers.
Absorb in dry, inert, material (sand, clay, sawdust, etc.) and transfer to disposal container non-sparking
equipment.
WASTE DISPOSAL METHOD
Containers should not be reused. Dispose of waste according to federal, provincial, and local
regulations.
SECTION IX: PREPARATION
THE INFORMATION CONTAINED HEREIN IS GIVEN IN GOOD FAITH, BUT NO WARRANTY,
EXPRESSED OR IMPLIED, IS MADE.
DATE PRINTED: April 6, 2006 BY: MILLENNIUM TECHNOLOGIES LTD.
DATE MODIFIED: June 6, 2005 APPROVED BY:
SUPERSEDES: October 1, 2003
24 HOUR
403-252-5904
PHONE:
|