Ultrafoam
Page 1 of 3
MATERIAL SAFETY DATA SHEET
SECTION I: IDENTIFICATION OF PRODUCT
Ultrafoam
PRODUCT NAME:
Foaming Agent
PRODUCT USE:
Mixed Anionic and Zwitterionic Surfactants
CHEMICAL FAMILY:
WORK PLACE HAZARDOUS MATERIALS INFORMATION SYSTEM (WHMIS)
D1B D2A D2B B-2
WHMIS CLASSIFICATION:
Skin and eye irritant, Flammable liquid, Toxic, Materials
WORK PLACE HAZARD:
causing other toxic effects.
TRANSPORTATION OF DANGEROUS GOODS (TDG)
Flammable Liquid, N.O.S (methanol)
SHIPPING NAME:
3
TDG CLASSIFICATION:
1993
UN NUMBER (PIN):
III
PACKING GROUP:
SECTION II: HAZARDOUS INGREDIENTS
INGREDIENT PERCENT CAS NUMBER LD(50) Oral-Rat OSHA PEL LD(50) Dermal
Rabbit
Hexalene Glycol 1-5% 107-41-5 3700 mg/kg CL 25ppm 8560mg/kg
Methanol 7-13% 67-56-1 5628 mg/kg TWA 200ppm 15.8 g/kg
Cocamidopropyl Betaine 5-10% 70851-07-9 4 mL/kg N/A N/A
Sodium C14-C16 Olefin Sulfonate 7-13% 68439-57-6 3800 mg/kg N/A N/A
Ammonium C8-10 Alkyl Ether 3-7% 68891-29-2 N/A N/A N/A
Sulfonate
SECTION III: TOXICOLOGICAL PROPERTIES
ROUTE OF ENTRY: [XX] SKIN [XX] EYE CONTACT [XX] INHALATION [XX] INGESTION
Repeated or prolonged contact may cause irritation, redness, pain, and blurred vision.
EYE CONTACT:
May cause mild irritation, redness cracking and drying.
SKIN CONTACT:
Not recommended. It is poisonous, causes nausea, headache, visual disturbances
INGESTION:
ranging from double vision to unconsciousness and death.
Inhalation of this product may cause irritation of mucous membranes. High levels may
INHALATION:
cause headache, sleepiness, nausea, giddiness, loss of consciousness, digestive and
Ultrafoam
Page 2 of 3
MATERIAL SAFETY DATA SHEET
visual disturbances and death.
SECTION IV: FIRST AID MEASURES
Wash exposed area with soap and water for at least fifteen minutes. If irritation or
SKIN CONTACT:
adverse symptoms develop, seek medical attention.
Immediately flush eyes with running water for at least 15 minutes. If irritation or
EYE CONTACT:
adverse symptoms develop, seek medical attention.
Do not induce vomiting. Dilute by giving two glasses of water or milk. Never give
INGESTION:
anything by mouth to an unconscious person. Call a physician.
Remove to fresh air. If not breathing, give artificial respiration, preferably mouth-to-
INHALATION:
mouth. If breathing is difficult, give oxygen. Call a physician.
SECTION V: PHYSICAL DATA
Clear to straw coloured, alcohol odour
APPEARANCE AND ODOUR:
1.01
SPECIFIC GRAVITY:
N/A
BOILING POINT (掳C):
<-15掳C
MELTING POINT (掳C):
7.0 鈥? 9.0
pH:
Miscible
SOLUBILITY IN WATER:
N/D
PERCENT VOLATILE BY VOLUME:
N/D
EVAPORATION RATE:
N/D
VAPOUR PRESSURE (mm Hg):
N/D
VAPOUR DENSITY (Air = 1):
SECTION VI: FIRE AND EXPLOSION HAZARD DATA
28掳C TCC
FLASH POINT:
N/A
FLAMMABLE LIMITS:
Dry chemical, foam, water fog, CO2
EXTINGUISHING MEDIA:
Respirators required for fire fighting personnel.
SPECIAL FIRE FIGHTING PROCEDURES:
Not Known
UNUSUAL FIRE AND EXPLOSION HAZARDS:
SECTION VII: REACTIVITY DATA
STABILITY: Stable [XX] Unstable [ ]
Strong oxidizers.
INCOMPATIBILITY (CONDITIONS TO AVOID):
Ultrafoam
Page 3 of 3
MATERIAL SAFETY DATA SHEET
Carbon oxides, sulphur oxides, smoke on combustion.
HAZARDOUS DECOMPOSITION PRODUCTS:
Will Not Occur [XX] May Occur [ ]
HAZARDOUS POLYMERIZATION:
SECTION VIII: PREVENTIVE MEASURES
SPECIAL PROTECTION INFORMATION
Suggest NIOSH/MESA approved air purifying respirator with organic
RESPIRATORY PROTECTION:
vapour.
General Mechanic, 10 changes per hour.
VENTILATION:
Suggest neoprene or rubber gloves.
PROTECTIVE GLOVES:
Suggest safety glasses with side shields.
EYE PROTECTION:
OTHER PROTECTIVE EQUIPMENT: Chemical resistant clothing.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING
Wash thoroughly after handling. Avoid prolonged or frequent contact when handling material. Avoid
contact with eyes, skin or clothing. Avoid breathing vapours, mist, fume, or dust. Wear protective
equipment and launder contaminated clothing before reuse. Use with adequate ventilation. Keep
container closed when not in use. Store in cool and dry location away from heat, sparks, flame, and
oxidizing agents.
STEPS TO BE TAKEN IN CASE THE MATERIAL IS SPILLED OR RELEASED
Use appropriate safety equipment. Dike to contain spill to prevent pollution of water sources and
sewers. Absorb in dry, inert, material (sand, clay, sawdust, etc.) and transfer to disposal container non-
sparking equipment.
WASTE DISPOSAL METHOD
Containers should not be reused. Dispose of waste according to federal, provincial, and local
regulations.
SECTION IX: PREPARATION
THE INFORMATION CONTAINED HEREIN IS GIVEN IN GOOD FAITH, BUT NO WARRANTY,
EXPRESSED OR IMPLIED, IS MADE.
DATE PRINTED: April 6, 2006 BY: MILLENNIUM TECHNOLOGIES LTD.
DATE MODIFIED: June 6, 2005 APPROVED BY:
SUPERSEDES: October 1, 2003
24 HOUR PHONE: 403-252-5904
|