Page 1





APG                                                                                                Material Safety Data Sheet

Analytical Products Group, Inc.                                                                       Date prepared on: 9/14/95



2730 Washington Blvd., Belpre, OH 45714                                                               Last revised on: 1/20/08

740-423-4200 800-272-4442 Fax 740-423-5588

                                                                                                      Page 1



Section I: Product Identification



CATALOG NUMBER: 2100/4190/4192-4193                                 PRODUCT NAME: Acid Extractables







Section II - Hazardous Ingredients/Identity Information



Chemical Name                                                       CAS Reg. No.                     OSHA PEL (TWA)                    % Composition*



Acetone                                                             67-64-1                          750 ppm                           >99%



A table of the compounds possible in this acid extractable

standard is attached. Data included in the table are

formulas, CAS numbers, oral LD 50 values for rats and

PEL/TWA values if available. Total concentration of all

phenols in the standard is less than 1%.



Section III - Physical/Chemical Characteristics of Hazardous Ingredients

Acetone

BOILING POINT: 56 C (132 F) @ 760 mm Hg                                        SPECIFIC GRAVITY: 0.79 (water=1)

VAPOR PRESSURE: 181 (20 C)                             SOLUBILITY IN WATER: Complete                APPEARANCE/ODOR: Clear, colorless liquid, sweet

                                                                                                    odor (acetone)







Section IV - Fire and Explosion Hazard Data



FLASH POINT (Method used): -18 C (-2 F) Closed           AUTO IGNITION TEMPERATURE: 464 C (869 F)                FLAMMABLE LIMITS LEL 2.5%         UEL 13%

Cup.

EXTINGUISHING MEDIA: Use alcohol foam, dry chemical or carbon dioxide (water may be ineffective). Use extinguisher media appropriate for surrounding fire.

SPECIAL FIRE FIGHTING PROCEDURES: Firefighters should wear proper protective equipment and self-contained breathing apparatus with full face piece operated in

positive mode. Move containers from fire area if it can be done without risk. Use water to keep fire exposed containers cool.

UNUSUAL FIRE AND EXPLOSION HAZARDS: Vapors may flow along surfaces to distant ignition sources and flash back. Closed containers exposed to heat may

explode. Contact with strong oxidizers may cause fire.





Section V - Reactivity Data



                                    Unstable              Stable               Conditions to Avoid: Heat, flame, other sources of ignition.

             STABILITY:

INCOMPATIBILITY (Materials to avoid):

Strong oxidizing agents, strong bases, halogen acids and halogen compounds, caustics, amines and ammonia, chlorine and chlorine compounds, strong acids, esp.

sulfuric, nitric, hydrochloric.

HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide, carbon dioxide, toxic fumes of chlorine.



       HAZARDOUS                  May Occur              Will Not Occur        Conditions to Avoid: NA

     POLYMERIZATION:





Section VI - Health Hazard Data



ROUTES OF              Inhalation? YES                                Skin? YES                                      Ingestion? YES

ENTRY

HEALTH HAZARDS (Acute and Chronic): ACUTE: Irritation of the nose and throat.      CHRONIC: Kidney damage, liver damage.



COMPONENTS LISTED AS CARCINOGENS OR POTENTIAL CARCINOGENS: Total of acid extractable compounds are less than 1%. Some are on the IARC list.



SIGNS AND SYMPTOMS OF EXPOSURE: Irritation of skin, eyes, nose and throat. Headache, dizziness, vomiting, nausea, central nervous system despression, low

blood pressure and respiratory failure. Prolonged contact may cause dermatitis.



MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: Skin disorders, eye disorders, chronic respiratory disease.



EMERGENCY AND FIRST AID PROCEDURES: Seek medical assistance for treatment, observation and support if necessary. EYE CONTACT: Flush with water for

15 minutes. Seek medical attention. SKIN CONTACT: Wash with soap and water, use protective creams. INHALATION: Remove to fresh air, if not breathing give

artificial respiration. If breathing difficult, give oxygen, obtain medical assistance.

                                                                                                                                                               Page 2

Section VII - Precautions for Safe Handling and Use



STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Diluted standard can be absorbed with sand or other non-combustible absorbent material

and placed into a container for later disposal. Sample solutions should be absorbed with charcoal or other organic absorbent and incinerated. Flush area with water.



WASTE DISPOSAL METHOD: Dispose in accordance with all applicable federal, state, and local regulations.



PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Keep container tightly closed. Store in a cool, dry, well ventilated, flammable liquid storage area.

Isolate from incompatible materials.



OTHER PRECAUTIONS* Do not heat or evaporate analytical standards to dryness.







Section VIII - Control Measures



RESPIRATORY PROTECTION (Please specify): Respiratory protection required if airborne concentration exceeds PEL (750 ppm). At concentrations up to 5000 ppm a

chemical cartridge respirator with an organic vapor cartridge is recommended. Above this level, self -contained breathing apparatus is recommended. (20,000 ppm is

immediately dangerous to life or health).



VENTILATION: Local exhaust



PROTECTIVE GLOVES: Butyl rubber gloves.                                              EYE PROTECTION: Safety glasses or goggles.



OTHER PROTECTIVE EQUIPMENT: N/A



EMERGENCY WASH FACILITIES: Maintain eye wash and quick drench showers in work area.







The information stated in this Material Safety Data Sheet (MSDS) is believed to be correct on the date of publication and must not

be considered all conclusive. The information has been obtained only by a search of available literature and is only a guide for

handling the chemicals. Persons not specifically and properly trained should not handle this chemical or its container. This

MSDS is provided without any warranty expressed or implied, including merchantability or fitness for any particular purpose.



This product is furnished for laboratory use ONLY! Our standards may not be used as drugs, cosmetics, agricultural or pesticidal

products, food additives or as house hold chemicals.



* Various Government agencies (i.e., Department of Transportation, Occupational Safety and Health Administration,

Environmental Protection Agency, and others) may have specific regulations concerning the transportation, handling, storage or

use of this product which may not be contained herein. The customer or user of this product should be familiar with these

regulations.







Hazardous Components of the Acids Standard:



Chemical                                           CAS #                     % by Weight                             LD50

4-Chloro-3-methylphenol                           59-50-7                      <0.1%                              1830 mg/kg

2-Chlorophenol                                    95-57-8                      <0.1%                              670 mg/kg

2,4-Dichlorophenol                                120-83-2                     <0.1%                              580 mg/kg

2,4-Dimethylphenol                                105-67-9                     <0.1%                              3200 mg/kg

2,4-Dinitrophenol                                 51-28-5                      <0.1%                              30 mg/kg

2-Methyl-4,6,dinitrophenol                        534-52-1                     <0.1%                              10 mg/kg

2-Nitrophenol                                     88-75-5                      <0.1%                              334 mg/kg

4-Nitrophenol                                     100-02-7                     <0.1%                              202 mg/kg

Pentachlorophenol                                 87-86-5                      <0.1%                              50 mg/kg

Phenol                                            108-95-2                     <0.1%                              317 mg/kg

2,4,6-Trichlorophenol                             88-06-2                      <0.1%                              820 mg/kg