MATERIAL SAFETY DATA SHEET
MANUFACTURER: LIFE AUTOMOTIVE PRODUCTS, INC. No.: 1 OF 6
1210 MIDAS COVE STE 101
CORDOVA, TN 38018
EMERGENCY CONTACT: CHEMTREC
EMERGENCY PHONE NUMBER: 800-424-9300
PRODUCT NAME: MIGHTY TOTAL INTAKE CLEANER
PRODUCT CODE No.: SB300 ISSUE DATE: 01/01/05
HMIS HAZARD INDEX: HMIS RATINGS:
HAZARDOUS 4-SEVERE HEALTH 2
MATERIALS 3-SERIOUS FLAMMABILITY 3
IDENTIFICATION 2-MODERATE REACTIVITY 0
SYSTEM 1-SLIGHT PERSONAL PROTECTION*
0-MINIMAL *SEE SECTION VII
NFPA HAZARD RATINGS:
4-EXTREME
3-HIGH
2-MODERATE
1-SLIGHT
0-INSIGNIFICANT
SECTION I
COMPONENTS PRODUCT IDENTIFICATION
CAS No. TLV OSHA %
COMPLEX BLEND OF:
HETEROCYCLIC AMINES AZEOTROPED WITH
PRIMARY ALKYL AMINE, ACETRONILRILE, AND
DEIONIZED WATER. (N/A) 40 ppm 100% A.I.
DIMETHYL ETHER (DME) 115-10-6 1000ppm (DuPont) 70/30
SECTION II
PHYSICAL PROPERTIES
BOILING POINT VAPOR DENSITY (AIR+1) % VOLATILE ODOR
WIDE RANGE > 3.0 100 AMMONIACAL
% SOL. IN WATER SPECIFIC GRAVITY Ph RANGE APPEARANCE
100% conc. 0.963 Conc. 12.2 TO 12.8 STRAW 鈥? YELLOW
EVAPORATION RATE (N BUTYL ACETATE=1) VAPOR PRESSURE (mm Hg OR PSIG)
N/A AEROSOL 鈥? 60 PSIG @ 70 Deg. F.
PRODUCT NAME: MIGHTY TOTAL INTAKE CLEANER PAGE No.: 2 OF 6
PRODUCT CODE No. SB300 ISSUE DATE: 01/01/05
SECTION III
FIRE AND EXPLOSION DATA
FLASHPOINT (METHOD USED): FLAMABLE LIMITS:
-41 C TOC (DME) 3.4 L.E.L. 18.0 U.E.L.
SPECIAL FIRE FIGHTING PROCEDURES:
EVACUATE ALL PERSONNEL FROM DANGER AREA. COOL SURROUNDING AREA WITH
WATER SPRAY. WEAR SELF-CONTAINED BREATHING APPARATUS. WEAR FULL
PROTECTIVE EQUIPMENT. EXPLODING AEROSOL UNITS, CAN BECOME DANGEROUS
MISSILES.
UNUSUAL FIRE AND EXPLOSION HAZARD:
FIRE FIGHTERS SHOULD WEAR SPECIAL PROTECTIVE EQUIPMENT AND WEAR A SELF-
CONTAINED BREATHING APPARATUS. SMOKE OF UNBURNED MATERIALS CAN
CONTAIN OXIDES OF NITROGEN.
EXTINGUISHING AGENTS:
WATER SPRAY, CARBON DIOXIDE, DRY CHEMICAL OR FOAM.
SECTION IV
ROUTES OF ENTRY: INHALATION ( X ) SKIN ( X ) EYES ( X ) INGESTION ( X )
INHALATION:
OVER EXPOSURE BY INHALATION MAY CAUSE CHEST TIGHTNESS OR PAIN, NAUSEA,
VOMITING, FLUSHING CONFUSION, DROWSINESS, UNCONSCIOUS, CONVULSIONS
AND GROSS OVER EXPOSURE MAY CAUSE DEATH.
SKIN CONTACT:
MAY CAUSE BURNING, IRRITATION, REDNESS AND SWELLING.
EYE CONTACT:
EYE IRRITANT AND CAUSES TEARING, BLURRING OF VISION AND PAIN.
INGESTION:
RESPIRATORY TRACT (TRACHEA AND ESOPHAGUS) IRRITANT WITH THE SAME
SYMPTOMS AS OVER EXPOSURE OR BREATHING.
PRODUCT NAME: MIGHTY TOTAL INTAKE CLEANER PAGE No.: 3 OF 6
PRODUCT CODE No. SB300 ISSUE DATE: 01/01/05
SECTION V
EMERGENCY AND FIRST AID PROCEDURES
INHALATION:
IMMEDIATELY REMOVE TO FRESH AIR. IF NOT BREATHING, GIVE ARTIFICIAL
RESPIRATION. IF BREATHING IS DIFFICULT, GIVE OXYGEN. CALL A PHYSICAN.
SKIN CONTACT:
IMMEDIATELY FLUSH WITH PLENTY OF WATER. REMOVE CONTAMINATED
CLOTHING AND WASH. GET MEDICAL ATTENTION IF NEEDED.
EYE CONTACT:
IMMEDIATELY FLUSH WITH PLENTY OF WATER FOR AT LEAST 15 MINUTES. CALL A
PHYSICIAN.
INGESTION:
IMMEDIATELY GIVE TWO (2) GLASSES OF WATER AND INDUCE VOMITING. DO NOT
GIVE SYRUP OF IPECAC. NEVER GIVE ANYTHING BY MOUTH TO AN UNCONSCIOUS
PERSON. CALL A PHYSICIAN.
COMMENTS:
SEE CAUTION UNDER VENTILATION.
SECTION VI:
REACTIVITY DATA
STABILITY: STABLE ( X ) UNSTABLE ( )
MATERIALS TO AVOID:
OXYGEN, OXIDIZERS, ACIDS, CARBON DIOXIDE, AND UV.
HAZARDOUS POLYMERIZATION: MAY OCCUR ( ) WILL NOT OCCUR ( X )
HAZARDOUS DECOMPOSITION PRODUCTS:
CARBON DIOXIDE, CARBON MONOXIDE, AMMONIA, NITROGEN OXIDES.
CONDITIONS TO AVOID:
HIGH TEMPERATURES, SPARKS AND OPEN FLAME. AUTOIGNITION AT 350
Deg. C. AEROSOL CONTAINERS MAY RUPTURE ABOVE 150 Deg. F.
PRODUCT NAME: MIGHTY TOTAL INTAKE CLEANER PAGE No.: 4 OF 6
PRODUCT CODE No. SB300 ISSUE DATE: 01/01/05
SECTION VII
SPECIAL PROTECTION INFORMATION
VENTILATION: 鈥淐AUTION EXHAUST HAZARD鈥?
TESTS SHOW THAT A SERIES OF TOXIC CHEMICALS FORM, FROM UNBURNED FUELS,
ADDITIVES, AND ENGINE FOG AND ARE FOUND IN THE EXHAUST DURING THE
PRODUCT NAME: INTAKE UPPER ENGINE CLEANER PAGE No.: 4 OF 6
PRODUCT CODE No.: 17020 ISSUE DATE: 01/01/05
ENGINE 鈥? RUNNING CHEMICAL CLEANING PROCEDURE. MAKE SURE THE EMISSION
VAPORS ARE EXHAUSTED OUTSIDE THE WORK PLACE AND THE WIND IS NOT
CARRYING VAPORS TOWARD ANY PEOPLE. VAPORS CONTAIN HIGH LEVELS OF
NITROGEN OXIDES.
RESPIRATORY PROTECTION:
IF VENTILATION PRECAUTIONS ARE NOT POSSIBLE, THEN USE A NIOH/MSHA
APPROVED RESPIRATOR FOR THE REMOVAL OF AMMONIA, NITROGEN OXIDES,
CARBON MONOXIDE, AND CARBON DIOXIDE.
PROTECTIVE GLOVES:
WEAR THIN LATEX GLOVES. USE CARE WHEN USING.
EYE PROTECTION:
WEAR CHEMICAL SPLASH GOGGLES.
OTHER PROTECTIVE EQUIPMENT:
WIPE SHIN DRY WITH CLEAN SHOP TOWEL AND WASH WITH WATER BEFORE EATING
OR LEAVING WORK AREA.
SECTION VIII
SPILL AND LEAK PROCEDURES
PRECAUTIONS IN CASE OF A LEAK OR SPILL:
REMOVE SOURCE OF SPARKS OR FLAME. EVACUATE PERSONNEL. DIKE SPILL.
THOROUGHLY VENTILATE AREA. USE SELF-CONTAINED BREATHING APPARATUS
DURING CLEAN UP. REMOVE FREE LIQUID FOR RE-USE OR RECLAMATION.
PRECAUTIONS IN CASE OF A LEAK OR SPILL:
REMOVE SOURCE OF SPARKS OR FLAME. EVACUATE PERSONNEL. DIKE SPILL.
THOROUGHLY VENTILATE AREA. USE SELF-CONTAINED BREATHING APPARATUS
DURING CLEAN UP. REMOVE FREE LIQUID FOR RE-USE OR RECLAMATION.
WASTE DISPOSAL METHOD:
PRODUCT IS VERY WATER SOLUBLE AND NOT SUITABLE TO DISPOSE IN WASTE OIL.
WHEN DELUTED WITH HIGH VOLUMES OF WATER THE PRODUCT IS NONTOXIC.
HOWEVER, DISPOSE IN ACCORDANCE WITH FEDERAL, STATE, AND LOCAL
REGULATIONS.
PRODUCT NAME: MIGHTY TOTAL INTAKE CLEANER PAGE No.: 5 OF 6
PRODUCT CODE No. SB300 ISSUE DATE: 01/01/05
SECTION IX
STORAGE AND SPECIAL PRECAUTIONS
HANDLING AND STORAGE PRECAUTIONS:
STORE IN A VENTILATED AREA. STORE AWAY FROM SPARKS AND FLAME. DO NOT
STORE ABOVE 120 Deg. F.
OTHER PRECAUTIONS:
KEEP OUT OF REACH OF CHILDREN. NO SMOKING OR EATING IN HANDLING OR USE
AREA. INHALING PARTIALLY OXIDIZED VAPORS THROUGH CIGARETTES COULD BE
LETHAL.
NOTES TO PHYSICIAN FOR SYMPTOMATIC TREATMENT:
PHYSICIANS TREAT SYMPTOMS OBSERVED.
SECTION X
TRANSPORTATION INFORMATION
Hazard Class: ORM-D SUB CLASS III
UN/NA Code:
Packing Group:
Bill of Lading Description:
Labels Required:
Placards Required:
SECTION XI
REGULATORY INFORMATION
Listed below are the hazard categories for SARA Section 311/312 (40 CFR 370):
Immediate Hazard: - Delayed Hazard: - Fire Hazard: -
Pressure Hazard: - Reactivity Hazard: -
Reporting Requirements of SARA Section 313 (40 CFR 372): The reportable quantity for this
material is 5,000 pounds. Any spill or other release, or substantial treat of release, of this material
to air, water, or land (unless entirely contained in the workplace) equal to or in excess of the
reportable quantity must be reported immediately to the National Response Center (800- 424-
8802) as required by U.S. Federal Law. Also contact appropriate state and local regulatory
agencies.
PRODUCT NAME: MIGHTY TOTAL INTAKE CLEANER PAGE No.: 6 OF 6
PRODUCT CODE No. SB300 ISSUE DATE: 01/01/05
Alkyl Nitriles and Methylpyrrolidone are listed with the Toxic Substance Control Act (TSCA).
State Regulations: Neither the product or its components are listed with the States of California,
Massachusetts, or Pennsylvania.
Canadian Environmental Protection Act: This product is not listed on the Domestic Substance List.
Canadian Workplace Hazardous Materials Information Systems (WHMIS):
The following Canadian Workplace Hazardous Information System (WHMIS) categories apply to
this product:
Compressed Gas: - Flammable/Combustible: Oxidizer: -
Acutely Toxic: - Other Toxic Effects: - Biohazardous: -
Corrosive: - Dangerously Reactive: -
Disclaimer: 鈥淚nformation contained in this publication, while accurate to the best of the knowledge
and belief of LIFE AUTOMOTIVE PRODUCTS, INC. it is not intended and should not be
construed as a warranty or representation for which LIFE AUTOMOTIVE PRODUCTS, INC.
assumes legal responsibility. Any information or advise obtained from LIFE AUTOMOTIVE
PRODUCTS, INC. otherwise than by means of this publication and whether relating to LIFE
AUTOMOTIVE PRODUCTS, INC. materials or other materials, is also given in good faith.
However, it remains at all times the responsibility of the customer to ensure that LIFE
AUTOMOTIVE PRODUCTS, INC. materials are suitable for the particular purpose intended,
except where LIFE AUTOMOTIVE PRODUCTS, INC. has given specific directions for use in LIFE
AUTOMOTIVE PRODUCTS, INC. finished Products.
Insofar as materials not manufactured or supplied by LIFE AUTOMOTIVE PRODUCTS, INC. are
used in conjunction with or instead of LIFE AUTOMOTIVE PRODUCTS, INC. materials, the
customer should ensure that he has received from the manufacturer or supplier all technical data
and other information relating to such materials before incorporating or using them in a LIFE
AUTOMOTIVE PRODUCTS, INC. Product. LIFE AUTOMOTIVE PRODUCTS, INC. accepts no
liability whatsoever (except otherwise provided by law) arising out of the use of information
supplied, the application, adaptation or processing of the products described herein, the use of
other materials in lieu of LIFE AUTOMOTIVE PRODUCTS, INC. material or the use of LIFE
AUTOMOTIVE PRODUCTS, INC. material in conjunction with other materials, except as directed
by LIFE AUTOMOTIVE PRODUCTS, INC..鈥?
|