PIRS Page 1 of 5
MATERIAL SAFETY DATA SHEET TRUST-X CUTOFF WHEEL
DATE OF
08/22/2000
ISSUE:
SUPERCEDES: 04/20/2000
SECTION I - GENERAL INFORMATION
Chemical Name & Synonyms: Trade Name & Synonyms:
RESINOID BONDED METALLIC ABRASIVE TRUST-X CUTOFF WHEEL
Chemical Family: Formula Mixture: X
CUT OFF WHEEL, ABRASIVE
Manufacturer's Name:
DYNA SYSTEMS A PARTSMASTER CO DIV OF NCH
Address:
P.O. BOX 655326
DALLAS, TEXAS 75265-5326
Prepared By: Product Code Number Emergency Phone Number
a santiago/Chemist 97600221 972-438-1381
SECTION II - HAZARDOUS INGREDIENTS
THE HAZARDS PRESENTED BELOW ARE THOSE OF THE INDIVIDUAL COMPONENTS
Chemical Name (Ingredients) Hazard TLV PEL STEL CAS #
ALUMINA SEE SC.VI 10 MG/M3 10 MG/M3 N/A 1344-28-1
SILICON DIOXIDE NUIS. DUST 10 MG/M3 6 MG/M3 N/A 7631-86-9
CRYOLITE IRRITANT 2.5MG/M3 2.5 MG/M3 N/A 15096-52-3
CALCIUM METASIL IRRITANT NOT EST. NOT EST. N/A 13983-17-0
SILICON CARBIDE NUIS. DUST 10 MG/M3 10 MG/M3 N/A 409-21-2
IRON OXIDE SEE SEC.VI 5 MG/M3 10 MG/M3 N/A 1309-37-1
PREPREG FIBER (FIBERGLASS) IRRITANT 10 MG/M3 10 MG/M3 N/A NOT APPLIC
SECTION III - PHYSICAL DATA
N/A 2.0
Boiling Point (f): Specific Gravity (H20=1):
N/A DARK BROWN TO BLACK
Vapor Pressure (MM HG): Color:
0 SLIGHT PHENOLIC ODOR
Vapor Density (Air=1): Odor:
N/A N/A
PH @ 100% : Clarity
0 0
% Volatile by Volume: Evaporation Rate (BU A/C=1):
<1% Viscosity: SOLID
H20 Solubility:
http://pirs.nch.com/MSDSPrintPage.asp 8/28/00
PIRS Page 2 of 5
SECTION IV - FIRE AND EXPLOSION HAZARD
Flash Point: Flammable Limits: LEL: UEL:
N/A / N/A N/A N/A
Extinguishing Media:
Foam: Alcohol Foam: CO2: X Dry Chemical: Water Spray: X Other:
Special Fire Fighting Procedures:
FIREFIGHTERS SHOULD WEAR SELF CONTAINED BREATHING APPARATUS TO AVOID INHALATION OF SMOKE
OR VAPORS
Unusual Fire and Explosion Hazards:
NONE
>
NFPA Hazard Rating: (0=Insignificant 1=Slight 2=Moderate 3=High 4=Extreme)
Health: 2 Flamability: 0 Reactivity: 0 Special:
SECTION V - HEALTH HAZARD DATA
Threshold Limit Value:
NOT ESTABLISHED FOR MIXTURE. SEE SECTION II. NOT ESTABLISHED FOR MIXTURE. SEE SECTION II.
Effects of Overexposure:
-Acute(Short Term Exposure)
INHALATION: METALIC DUST INHALATION CAUSES COUGHING, IRRITATION OF THE NOSE, THROAT AND
MUCOUS MEMBRANES. INGESTION: GASTROINTESTINAL DISTURBANCES SKIN: PHENOLIC RESINS CAN
CAUSE SKIN IRRITATION/RASH EYE: METAL FRAGMENTS WILL CAUSE EYE DAMAGE OTHER POTENTIAL
HEALTH RISKS: DURING USE ON SOME MATERIALS, ELEVATED SOUND LEVELS MAY BE CREATED WHICH
AFFECT HEARING.
-Chronic (Long Term Exposure)
-CHRONIC- INHALATION: MAY AFFECT BREATHING CAPACITY INGESTION: NO KNOWN ADVERSE EFFECTS,
BUT INGESTION NOT RECOMMENDED. SKIN: NOT ABSORBED THROUGH SKIN; MAY CAUSE ABRASIONS. EYE:
DUST MAY IRRITATE EYES. OTHER POTENTIAL HEALTH RISKS: DURING USE ON SOME MATERIALS ELEVATED
SOUND LEVELS MAY BE CREATED WHICH AFFECT HEARING. CHRONIC HIGH LEVEL EXPOSURE TO SILICA
DUST CAN CAUSE PULMONARY FIBROSIS. IRON EXPOSURE CAN CAUSE METAL FEVER.
Inhalation: X Ingestion: Absorption:
Primary Routes of Entry:
Emergency and First Aid Procedures:
-Inhalation:
REMOVE TO FRESH AIR; APPLY ARTIFICIAL RESPIRATION AS NEEDED. OBTAIN FIRST AID OR MEDICAL
ASSISTANCE.
-Eye Contact:
WASH WITH LARGE AMOUNTS OF WATER. OBTAIN FIRST AID OR MEDICAL ASSISTANCE IF NEEDED. DO NOT
WEAR CONTACT LENSES.
-Skin Contact:
http://pirs.nch.com/MSDSPrintPage.asp 8/28/00
PIRS Page 3 of 5
WASH AFFECTED AREAS WITH PLENTY OF SOAP AND WATER.
-Ingestion:
OBTAIN FIRST AID OR MEDICAL ASSISTANCE IF NEEDED
-Notes to Physician:
NONE OTHER THAN STATED ON THE PREVIOUS PROCEDURES.
SECTION VI - TOXICITY INFORMATION
Product Contains Chemicals Listed as Carcinogen or Potential Carcinogen By:
IARC: No NTP: No OSHA: No ACGIH: No OTHER: Yes
ALUMINUM OXIDE: INHALATION OF FINELY DIVIDED PARTICLES MAY CAUSE LUNG DAMAGE (SHAVER'S DISEA
IRON OXIDE: POISON BY SUBCUTANEOUS ROUTE AND QUESTIONABLE CARCINOGEN. THIS PRODUCT CONTAINS
ALL CHEMICALS IN THIS PRODUCT ARE LISTED, OR ARE EXEMPT FROM LISTING,
ON THE TSCA INVENTORY.
SECTION VII - REACTIVITY DATA
Stable: X Unstable:
Stability:
Incompatibility (Materials to Avoid):
NONE TO AVOID
Hazardous Decomposition Products:
IN USE, DUST AND DECOMPOSING RESIN FUMES ARE GENERATED.
May Occur: Will Not Occur:
Hazardous Polymerization:
SECTION VIII - SPILL OR LEAK PROCEDURES
Steps to be Taken if Material is Released or Spilled:
GRINDING AND CUT OFF WHEELS IF DROPPED OR DAMAGED CAN CAUSE SERIOUS BODILY INJURY. AVOID
USAGE IF PRODUCT HAS BEEN DROPPED OR FALLEN SOLID ABRASIVE DISKS POSE NO SPILL/LEAK
HAZARDS. USE NORMAL CLEAN UP/ SWEEPING PROCEDURES. KEEP DUST METAL RESIDUE OFF SKIN.
Waste Disposal Method(s):
SANITARY LAND FILL OR INCINERATION IN ACCORDANCE WITH LOCAL, STATE AND FEDERAL REGULATIONS.
Neutralizing Agent:
N/A
SECTION IX - SPECIAL PROTECTION INFORMATION
http://pirs.nch.com/MSDSPrintPage.asp 8/28/00
PIRS Page 4 of 5
Required Ventilation:
LOCAL ECHAUST: VENTILATION, AVOID CONTACT WITH SPARKS. USE WHEEL GUARDS, DO NOT WEAR
CONTACT LENSES.
Respiratory Protection:
MSHA - NIOSH APPROVED RESPIRATORS, IF TLVS'S ARE EXCEEDED.
Glove Protection:
SPARK PROOF
Eye Protection:
FACE SHIELD. USE WHEEL GUARDS. DO NOT WEAR CONTACT LENSES.
Other Protection:
SAFETY SHOES, FIRE PROOF CLOTHING, HEAD PROTECTION
SECTION X - STORAGE AND HANDLING INFORMATION
Indoors: Outdoors: Heated: Refrigerated:
Storage Temperature:
Minimum Temperature: N/A Maximum Temperature: N/A
Precautions to be taken in Handling and Storing:
HANDLE CAREFULLY. WHEELS SHALL NOT BE STORED SUBJECT TO WATER OR SOLVENTS, HIGH HUMIDITY
OR FREEZING TEMPERATURES.
Other Precautions:
COMPLY WITH ANSI B7.3 SAFETY, USE AND CARE OF ABRASIVE WHEELS. COMPLY WITH RPM RATING ON
EACH PRODUCT.
SECTION XI - REGULATORY INFORMATION
Chemical Name CAS Number Upper % Limit
ALUMINA 1344-28-1 20
Those Ingredients listed above are subject to the reporting requirements of 313 of Title III & of the Superfund
Amendments and Reauthorization Act of 1986 and 40 CFR part 372.
CALIFORNIA PROPOSITION 65
WARNING: This product contains the following chemical(s) know to the State of California to cause (1)Cancer or (2)Birth
Defects or other reproductive harm. THIS PRODUCT CONTAINS NONE
SECTION XII - REFERENCES
http://pirs.nch.com/MSDSPrintPage.asp 8/28/00
PIRS Page 5 of 5
1. SAX'S DANGEROUS PROPERTES OF INDUSTRIAL MATERIALS, TENTH EDITION
RICHARD J. LEWIS, SR.
2. TSCA, TOXIC SUBSTANCE INVENTORY, APRIL 2000.
3. IARC, INTERNATIONAL AGENCY FOR RESEARCH ON CANCER.
4. TITLE III SECTION 313 OF THE SUPERFUND AMENDMENTS AND REAUTHORIZATION
ACT, SARA, APRIL, 2000.
THE INFORMATION CONTAINED HEREIN IS BASED ON DATA CONSIDERED ACCURATE IN LIGHT OF CURRENT
FORMULATION. HOWEVER, NO WARRANTY IS EXPRESSED OR IMPLIED REGARDING THE ACCURACY OF
THESE DATA OR THE RESULTS TO BE OBTAINED FROM THE USE THEREOF.
DYNA SYSTEMS A PARTSMASTER CO DIV OF NCH assumes no responsibility for personal injury or property damage
caused by the use, storage, or disposal of the product in a manner not recommended on the product label. Users
assume all risks associated with such unrecommended use,storage or disposal of the product."
http://pirs.nch.com/MSDSPrintPage.asp 8/28/00
|