warco premium lubricants msds sheets 1
Warco Premium Lubricants
(MSDS) MATERIAL SAFETY DATA
SHEET
WARCO GEAR OIL GL-1 SAE
85W-90
SECTION 1 MATERIAL IDENTIFICATION
PRODUCT 鈥? WARCO GEAR OIL GL-1 SAE 85W-90
NOV 25, 2006
MANUFACTURER WARCO Products, Inc.
12505 SW Herman Rd
Tualatin, OR 97062
PHONE NUMBERS
Emergency (Chemtrec) (800) 424-9300
CHEMICAL FAMILY Petroleum Hydrocarbon; Blend Stock
CHEMICAL NAME Mixture
PRODUCT CODE LAP2147
PRODUCT FAMILY Gear Oil
CHEMICAL FORMULA Mixture
CAS NUMBER Mixture (Refer to Section 2)
SYNONYMS Gear Oil, Petroleum Lubricating Oil
NFPA CODES Flammability 1 Reactivity 0 Health 1
0 = Least 1 = Slight 2 = Moderate 3 = High 4 = Extreme
warco premium lubricants msds sheets 1
warco premium lubricants msds sheets 2
SECTION 2 HAZARDOUS
COMPONENTS
Ingredients CAS # WT. %
Refined Petroleum Oil(s) Refer to Section 13 >97
Proprietary Additives Mixture <3
SECTION 3 SHIPPING INFORMATION
Shipping Name Petroleum Lubricating Oil
Hazard Class Non-hazardous liquid
UN Number Not Applicable
Proper Shipping Name Not Applicable
Hazard Label Not Applicable
Reportable Quantity Not Applicable
Not Determined
Boiling Point
Not Determined
Vapor Pressure
SECTION 4 PHYSICAL DATA
Not Determined
Vapor Density
Negligible
Solubility in water
Amber liquid
Appearance
Mild petroleum odor
Odor
.88 - .90 @ 60潞F Water = 1
Specific Gravity
Not Determined
Evaporation Rate
Not Determined
Freezing Point
14.5 cST @ 212潞F (100潞C)
Viscosity
warco premium lubricants msds sheets 2
warco premium lubricants msds sheets 3
SECTION 5 FIRE AND EXPLOSION HAZARD
DATA
>400潞F, 204潞C (COC, ASTM D92)
Flash Point
Auto Ignition
Not Determined
Temperature
LEL Not Established
Flammable Limits
(% by Volume in Air) UEL Not Established
CO2, dry chemical, foam, or water fog.
Extinguishing Media
Water may be ineffective in fighting an oil fire unless used by experienced fire fighters.
Product will float and can be reignited on surface of water.
Special Fire Fighting Procedures
Evacuate area of all unnecessary personnel. Shut off source, if possible. Use
NIOSH/MSHA approved self-contained breathing apparatus and other protective
equipment and/or garments described in Section 9 if conditions warrant. Water fog or
spray may be used to cool exposed containers and equipment.
For large storage fires involving this material and/or other lubricating products, do not
enter any enclosed or confined space without full protective equipment including self-
contained breathing apparatus to protect against potential hazardous combustion or
decomposition products, and oxygen deficiencies.
Fire and Explosion Hazards - Carbon oxides and various hydrocarbons formed when
burned. Water may cause frothing.
warco premium lubricants msds sheets 3
warco premium lubricants msds sheets 4
SECTION 6 REACTIVITY HAZARD DATA
Stable
Stability
Extreme Heat, open flames or sparks
Conditions to Avoid
Strong oxidizing agents
Incompatibility
Hazardous polymerization is not expected to occur.
Polymerization
Hazardous Combustion / Decomposition Products
Carbon oxides and various hydrocarbons formed when burned 鈥? traces of sulfur oxides.
SECTION 7 HEALTH HAZARD DATA
TWA 5mg/M鲁
OSHA PEL and ACGIH TVL - Oil Mist, Mineral
STEL 10 mg/M鲁 - Ceiling
None established
Exposure Limits
See Below
Effects of Exposure
Inhalation Not expected to be toxic by inhalation. However, breathing mineral oil mist at
levels above the TLV may cause respiratory irritation and possible discomfort. Elevated
mists concentrations above applicable workplace exposure levels may cause lung
damage. Incidental mists/vapors are the Major Route of Entry.
Ingestion Generally of a low order of toxicity. Not expected to be a problem when ingested.
Upon ingestion of large quantities, slight gastrointestinal discomfort, diarrhea and
headache may occur. Small doses may produce irritation and/or diarrhea. If aspirated
into the lungs, liquid can cause severe lung damage or death. If uncomfortable seek
medical assistance.
Skin Contact Material expected to cause no more than minor skin irritation following prolonged
and/or repeated contact. Wash contact areas with soap and water.
Eye Contact Flush thoroughly with water. If irritation characterized by pain, swelling, redness or
blurred vision, call a physician. Contact with heated material may cause thermal burns.
Injection Injection under the skin, in muscle or into the blood stream can cause irritation,
inflammation, swelling or serious, permanent tissue damage. Seek medical attention
immediately.
Chronic Effects Prolonged and/or frequent contact may cause drying, cracking (dermatitis) or
folliculitis and may cause irritation.
warco premium lubricants msds sheets 4
warco premiumEMERGENCY and FIRST AID
lubricants msds sheets 5
SECTION 8
PROCEDURES
Inhalation If respiratory discomfort or irritation occurs due to inhalation of oil mist, move person to
fresh air. Vaporization is not expected at ambient temperatures. Contact a physician immediately if
illness or adverse symptoms develop.
Eye Contact Immediately flush eyes with a large amount of cool, clean, low-pressure water while
occasionally lifting and lowering eyelids. If irritation or adverse symptoms continues, seek medical
attention. Thermal burns require immediate medical attention.
Skin Contact Remove contaminated clothing and wash affected skin area thoroughly with soap and
water. Launder soiled clothing. If skin irritation develops or persists, seek medical attention.
Ingestion If material is swallowed and adverse symptoms develop, seek medical attention
immediately. Induce vomiting only upon the advice of a physician. Never give anything by mouth to a
person who is not fully conscious. If spontaneous vomiting is about to occur, place victim's head below
knees. Upon ingestion, there is a low to moderate risk of aspiration. Careful gastric lavage may
be considered to evacuate large quantities of material.
Injection Injuries - Subcutaneous injection is a medical emergency. Seek medical attention
immediately. Inadequate treatment can result in ischemia and gangrene. Early symptoms may be
SECTION 9 CONTROL and PROTECTIVE
MEASURES
minimal.
Storage and handling Store in an adequate ventilated area to control exposure. Special ventilation is
necessary only if unusual operating conditions create mist concentrations in excess of the TLV. Avoid
water contamination and extreme temperatures to minimize product degradation.
Respiratory Protection Not applicable for intended use. However, if unusual operating conditions
create mist concentrations in excess of the TLV, an approved NIOSH/MSHA respirator is
recommended.
Eye Protection Chemical face shield or protective goggles can reduce the possibility of accidental
eye contact.
Skin Protection Impervious protection gloves can minimize skin exposures where prolonged or
repeated exposures can occur.
This is a general recommendation based upon general information as to normal uses and
conditions. However when special or unusual uses or conditions exist, it is suggested that an
expert assistance of an industrial hygienist be sought for special equipment.
warco premium lubricants msds sheets 5
warco premium lubricants msds sheets 6
SECTION 10 SPILL and LEAK PROCEDURES
Take proper precautions to ensure your own health and safety before
attempting spill control or clean up.
Precautions if material is spilled or released
Wear protective equipment and/or garments described in Section 9 if exposure conditions warrant.
Shut off source, if possible and contain spill. Clean up spills as soon as possible. Absorb large
spills with commercially available absorbent materials, such as absorbent clay or other dry inert
materials. Keep out of water sources and sewers. Comply with all Federal, State, and Local
regulations in reporting spill and cleanup. Provide adequate ventilation.
Waste Disposal Method
Place contaminated material in disposable containers. Material must be disposed of in accordance
with Federal, State, and Local regulations. Contact the RCRA Superfund Hotline directly @
(800) 424-9346, a regional US EPA office, or a permitted waste management facility to provide
guidance concerning case specific disposal issues.
]
SECTION 11 REGULATORY INFORMATION
Comprehensive Environmental Response, Compensation and Liability Act
(CERCLA) Section 102 Hazardous Substances
As defined by CERCLA, the term "hazardous substance" does not include petroleum, including crude
oil or any fraction thereof which is not otherwise specifically listed or designated as a hazardous
substance.
Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA)
Section 313 - Toxic Chemicals
This product does not contain greater than 1.0% of any chemical substance of Section 313 of Title III
of Superfund Amendments and Reauthorization Act of 1986 (SARA) and 40 CFR Part 372.
Components CAS# Concentration %
warco premium lubricants msds sheets 6
warco premium lubricants msds sheets 7
Section 311/312 - Hazard Categories
This product may meet one or more of the criteria for the hazard categories defined in 40 CFR Part
370 as established by Sections 311 and 312 of SARA as indicated below.
Immediate (Acute) Health Hazard No Fire Hazard No
Delayed (Chronic) Health Hazard No Reactive Hazard No
Sudden Release of Pressure Hazard No
SECTION 11 REGULATORY INFORMATION
(continued)
Section 302 - Extremely Hazardous Substances
This product is not known to contain any components in concentrations greater than one percent that
are listed as Extremely Hazardous Substances in 40CFR Part 355 pursuant to the requirements of
Section 302(a) of SARA.
Clean Water Act (CWA)
Under the CWA, discharge of crude oil and petroleum products to surface water without proper
Federal and State permits must be reported immediately to the National Response Center at
(800) 424-8802.
RCRA Classification - Unadulterated Product as a Waste
Prior to disposal, consult your Environmental contact to determine if TCLP (Toxicity Characteristic
Leaching Procedure, EPA Test Method 1311) is required. Reference 40 CFR Part 261.
Toxic Substances Control Act (TSCA)
This product is in U.S. commerce, and listed in the TSCA Inventory of Chemicals; hence, it may be
subject to applicable TSCA provisions and restrictions.
Ecological Information
Ecotoxicity - No data available.
Environmental Fate - Ecological effects testing has not been conducted on this product. However,
plants and animals may experience harmful or fatal effects when coated with petroleum-based
products. Petroleum-based (mineral) lube oils will normally float on water. In stagnant or slow-flowing
waterways, an oil layer can cover a large surface area. As a result, this oil layer might limit or
eliminate natural atmospheric oxygen transport into the water. With time, if not removed, oxygen
warco premium lubricants msds sheets 7
warco premium lubricants msds sheets 8
depletion in the waterway might be enough to cause a fish kill or create an anaerobic environment.
SECTION 12 LABELING
NOTE
This product has been determined not to be a physical or a health hazard as defined by the OSHA
Hazard Communication Standard.
Avoid prolonged skin contact with used motor oil. Prolonged contact with used motor oil has been
shown to cause cancer in laboratory animals.
After draining oil, wash skin thoroughly with soap and water. Clean oil-soaked clothing before reuse.
warco premium lubricants msds sheets 8
SECTION 13 warco premium lubricants msds sheets
REFINED PETROLEUM OILS 9
The products listed on page one of this MSDS contain one or more of the following base oils.
Chemical / Common Name CAS No.
Solvent Refined, Heavy Paraffinic Distillate 64741-88-4
Solvent Refined Residuum 64742-01-4
Hydrotreated Heavy Paraffinic Distillate 64742-54-7
Hydrotreated Residual Oils (Petroleum) 64742-57-0
Hydrotreated Paraffinic Base Oil 64742-58-1
Solvent Dewaxed Residual Oil 64742-62-7
Solvent Dewaxed, Heavy Paraffinic Distillate 64742-65-0
Hydrotreated Neutral Lubricating Oil 72623-87-1
Hydrotreated Bright Stock Lubricating Oil 72623-83-7
This product is FOR INDUSTRIAL USE ONLY. KEEP OUT OF REACH OF CHILDREN.
SECTION 14 NOTES
DO NOT TAKE INTERNALLY
Warco Products, Inc., believes that the information and recommendations contained herein (including
data and statements) are accurate as of the date hereof. No warranty of fitness for any particular
purpose, warranty of merchantability, or any other warranty, expressed or implied, is made concerning
the information provided herein. The information provided herein relates only to the specific product
designated and may not be valid where such product is used in combination with any other
materials or in any process. Further, since the conditions and methods of use of the product and
of the information referred to herein are beyond the control of Warco Products, Inc. Warco
Products, Inc. expressly disclaims any and all liability as to any results obtained or arising from any
use of the product or reliance on such information.
warco premium lubricants msds sheets 9
|