WARCO PREMIUM LUBRICANTS
MATERIAL SAFETY DATA SHEET
WARCO POWER STEERING FLUID
1 of 6
Any Questions Call: Emergency Telephone: NFPA/HMIS Hazard Code
(24 HOURS)
4=Extreme Health=0/0
Warco Products Inc.
3=High Fire=1/1
CHEMTREC
(A subsidiary of API
2=Moderate Reactivity=0/0
(800) 424 9300
International Inc.)
1=Slight Personal
12505 SW Herman Rd. .
Protection Index: NA
0=Insignificant
Tualatin, OR 97062 USA
Tel: (503) 692-3800
I. Ingredients/Identification Information
CAS Number
Components (Specific Chemical Identity: Common Name(s))
Solvent Dewaxed, Heavy Paraffinic Distillate 64742-65-0
Solvent Dewaxed Residual Oil 64742-62-7
Solvent Refined Residuum 64742-01-4
Hydrotreated Middle Naphthenic, Distillate 64742-46-7
Hydrotreated Paraffinic Base Oil 64742-58-1
Hydrotreated Residual Oils (Petroleum) 64742-57-0
Solvent Refined, Heavy Paraffinic Distillate 64741-88-4
Solvent Refined, Light Paraffinic Distillate 64741-89-5
Hydrotreated Heavy Paraffinic Distillate 64742-54-7
Hydrotreated Light Paraffinic Distillate 64742-55-8
Hydrotreated Neutral Lubricating Oil 72623-87-1
Hydrotreated Bright Stock Lubricating Oil 72623-83-7
Power steering fluid, Lubricating Oils
Synonyms:
Mixture
Chemical Name:
Petroleum Hydrocarbon; Blend Stock
Chemical Family:
II. Physical/Chemical Characteristics
Not Determined .86 - .88 @ 60潞F
Boiling Point: Specific Gravity (H20=1)
Negligible > 1 g/ml Air = 1
Vapor Pressure: (mm Hg) Vapor Density (Air=1)
Negligible >374潞F, 190潞C
Solubility in Water Flash Point (Method
(COC, ASTM D92)
Used)
Red liquid; Lube Oil Odor
Appearance and Odor:
Shipping Name Petroleum Lubricating Oil
Shipping Information
Hazard Class Non-hazardous liquid
UN Number Not Applicable
Proper Shipping Name Not Applicable
Hazard Label Not Applicable
Reportable Quantity Not Applicable
WARCO PREMIUM LUBRICANTS
MATERIAL SAFETY DATA SHEET
WARCO POWER STEERING FLUID
2 of 6
To avoid product degradation, water contamination should be avoided
Handling and Storage:
and minimum feasible handling temperatures should be maintained.
Periods of exposure to high temperatures (>200 F) should be minimized.
Product degradation may increase health hazard risks.
Slightly combustible: OSHA/NFPA Class-IIIB Combustible liquid. When
Fire and Explosion
heated above its flash point, this material will release flammable vapors
Hazards
which can burn in the open or be explosive in confined spaces if exposed
to an ignition source. Mists or sprays may be flammable at temperatures
below the normal flash point. Keep away from extreme heat and open
flame.
Dry chemical and carbon dioxide. Foam and water fog are effective but
Fire Extinguishing Media
cause frothing.
For fires involving this material, do not enter any enclosed or confined fire
Special Firefighting
space without proper protective equipment. This may include self
Procedures
contained breathing apparatus to protect against the hazardous effects of
combustion products and oxygen deficiencies. If firefighters cannot work
upwind to the fire, respiratory protective equipment must be worn. Cool
tanks and container exposed to fire with water. Burning liquid will float on
water. Notify appropriate authorities if liquid enters sewer/waterways.
III. Health Hazards
Not expected to present a significant health hazard upon short-term
Summary of Acute Hazards
exposure
Route of Exposure Signs and Symptoms
Not expected to be toxic by inhalation. However, breathing mineral oil
Inhalation
mist at levels above the TLV may cause respiratory irritation and
possible discomfort. Elevated mists concentrations above applicable
workplace exposure levels may cause lung damage. Incidental
mists/vapors are the Major Route of Entry.
Flush thoroughly with water. This product can cause mild, transient,
Eye Contact
eye irritation with short-term contact with liquid or sprays. If irritation
occurs, call a physician.
No significant adverse health effects are expected to occur upon short-
Skin Absorption
term exposure
Material expected to cause no more than minor skin irritation following
Skin Irritation
prolonged and/or repeated contact. Wash contact areas with soap and
water.
Generally of a low order of toxicity. Not expected to be a
Ingestion
problem when ingested. Upon ingestion of large quantities,
slight gastrointestinal discomfort, diarrhea and headache may
occur. Small doses may produce irritation and/or diarrhea. If
aspirated into the lungs, liquid can cause severe lung damage or
death. If uncomfortable seek medical assistance.
WARCO PREMIUM LUBRICANTS
MATERIAL SAFETY DATA SHEET
WARCO POWER STEERING FLUID
3 of 6
Prolonged and/or repeated contact with this material may produce skin
Chronic Hazards
irritation and inflammation.
Injection Injuries - Subcutaneous injection is a medical emergency.
Special Health Effects
Seek medical attention immediately. Inadequate treatment can
result in ischemia and gangrene. Early symptoms may be minimal.
Emergency and First Aid Procedures
If respiratory discomfort or irritation occurs due to inhalation of oil mist,
Inhalation
move person to fresh air. Vaporization is not expected at ambient
temperatures. Contact a physician immediately if illness or adverse
symptoms develop
Immediately flush eyes with a large amount of cool, clean, low-
Eye Contact
pressure water while occasionally lifting and lowering eyelids. If
irritation or adverse symptoms continues, seek medical attention.
Remove contaminated clothing and wash affected skin area
Skin Contact
thoroughly with soap and water. Launder soiled clothing. If skin
irritation develops or persists, seek medical attention.
If material is swallowed and adverse symptoms develop, seek
Ingestion
medical attention immediately. Induce vomiting only upon the
advice of a physician. Never give anything by mouth to a person
who is not fully conscious. If spontaneous vomiting is about to
occur, place victim's head below knees. Upon ingestion, there
is a low to moderate risk of aspiration. Careful gastric
lavage may be considered to evacuate large quantities of
material.
Subcutaneous injection is a medical emergency. Seek medical
Injection Injuries
attention immediately. Inadequate treatment can result in ischemia
and gangrene. Early symptoms may be minimal.
Prolonged and/or repeated contact with this material may produce skin
Chronic Hazards
irritation and inflammation.
IV. Protective Equipment and Other Control Measures
Not applicable for intended use. However, if unusual operating conditions
Respiratory
create mist concentrations in excess of the TLV, an approved NIOSH/MSHA
respirator is recommended.
Chemical face shield or protective goggles can reduce the possibility of
Eye
accidental eye contact.
Impervious protection gloves can minimize skin exposures where prolonged or
Skin
repeated exposures can occur.
Use adequate ventilation to keep oil mists of this material below applicable
Engineering Controls
standard(s).
This is a general recommendation based upon general information as to
Other Hygienic and
normal uses and conditions. However when special or unusual uses or
Work Practices
conditions exist, it is suggested that an expert assistance of an industrial
hygienist be sought for special equipment.
WARCO PREMIUM LUBRICANTS
MATERIAL SAFETY DATA SHEET
WARCO POWER STEERING FLUID
4 of 6
VI. Spill, Disposal and Regulatory Information
Contain spill and prevent it from entering all water bodies, if possible.
Precautions if Material is
Safely stop flow of spill. Evacuate non-essential personnel from
Spilled or Released
immediate spill area due to slipping hazards. In urban area, cleanup as
soon as possible. In natural environments, cleanup on advice from
ecologists. This material will float on water. Absorbent materials and
pads can be used. Comply with all applicable laws. Spills may need to
be reported to the National Response Center (800 424 8802). The
spilled material and any soil or water which it has contacted may be
hazardous to animal/aquatic life.
Maximize product recovery for reuse or recycling. Conditions of use
Waste Disposal Methods
may cause this material to become a 鈥渉azardous waste,鈥? as defined by
state or federal laws. Use approved treatment, transporters, and
disposal sites in compliance with all applicable laws. If spill is
introduced into a waste water treatment system, chemical and
biodegradable if gradually exposed to microorganisms. Potential
treatment and disposal methods include land farming, incineration and
land disposal, if permitted.
U.S. Department of Transportation (DOT)
Transportation
Hazard Class Non-regulated
Classifications
Shipping Name Petroleum Lubricant
Identification Number Not applicable
WARCO PREMIUM LUBRICANTS
MATERIAL SAFETY DATA SHEET
WARCO POWER STEERING FLUID
5 of 6
Regulatory Information
Comprehensive Environmental Response, Compensation and Liability Act
(CERCLA) Section 102 Hazardous Substances
As defined by CERCLA, the term "hazardous substance" does not include petroleum, including crude oil or
any fraction thereof which is not otherwise specifically listed or designated as a hazardous substance.
Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA)
Section 313 - Toxic Chemicals
This product does contain toxic chemicals of Section 313 of Title III of Superfund Amendments and
Reauthorization Act of 1986 (SARA) and 40 CFR Part 372.
Components CAS# Concentration %
Zinc Compounds 68649-42-3 <2
Section 311/312 - Hazard Categories
This product may meet one or more of the criteria for the hazard categories defined in 40 CFR Part 370 as
established by Sections 311 and 312 of SARA as indicated below.
Immediate (Acute) Health Hazard No Fire Hazard No
Delayed (Chronic) Health Hazard No Reactive Hazard No
Sudden Release of Pressure Hazard No
Section 302 - Extremely Hazardous Substances
This product is not known to contain any components in concentrations greater than one percent that are
listed as Extremely Hazardous Substances in 40CFR Part 355 pursuant to the requirements of Section
302(a) of SARA.
Clean Water Act (CWA)
Under the CWA, discharge of crude oil and petroleum products to surface water without proper Federal and
State permits must be reported immediately to the National Response Center at (800) 424-8802.
RCRA Classification 鈥? Unadulterated Product as a Waste
Prior to disposal, consult your Environmental contact to determine if TCLP (Toxicity Characteristic Leaching
Procedure, EPA Test Method 1311) is required. Reference 40 CFR Part 261.
Toxic Substances Control Act (TSCA)
This product is in U.S. commerce, and listed in the TSCA Inventory of Chemicals; hence, it may be subject to
applicable TSCA provisions and restrictions.
WARCO PREMIUM LUBRICANTS
MATERIAL SAFETY DATA SHEET
WARCO POWER STEERING FLUID
6 of 6
Ecological Information
Ecotoxicity - No data available.
Environmental Fate 鈥? Ecological effects testing has not been conducted on this
product. However, plants and animals may experience harmful or fatal effects
when coated with petroleum-based products. Petroleum-based (mineral) lube oils
will normally float on water. In stagnant or slow-flowing waterways, an oil layer can
cover a large surface area. As a result, this oil layer might limit or eliminate
natural atmospheric oxygen transport into the water. With time, if not removed,
oxygen depletion in the waterway might be enough to cause a fish kill or create an
anaerobic environment.
Disclaimer of Liability
The information in this Safety Sheet was obtained from sources which we believe are reliable. HOWEVER, THE
INFORMATION IS PROVIDED WITHOUT ANY WARRANTY, EXPRESS OR IMPLIED, REGARDING ITS
CORRECTNESS. The conditions or methods of handling, storage, use and disposal of the product are beyond our
control and may be beyond our knowledge. FOR THIS AND OTHER REASONS, WE DO NOT ASSUME ANY
RESPONSIBILITY AND EXPRESSLY DISCLAIM LIABILITY FOR LOSS, DAMAGE OR EXPENSE ARISING OUT
OF OR IN ANY WAY CONNECTED WITH THE HANDLING, STORAGE, USE OR DISPOSAL OF THE PRODUCT.
This safety sheet was prepared and is to be used only for this product. If the product is used as a component in
another product, this safety sheet may not be applicable. SOME OF THE INFORMATION PRESENTED AND
CONCLUSIONS DRAWN HEREIN ARE FROM SOURCES OTHER THAN DIRECT TEST DATA ON THE MIXTURE
ITSELF.
|