QUICK IDENTIFIER
(as used in label and list)
DC 200 Fluid
MATERIAL SAFETY DATA SHEET
________________________________________________________________________________
SECTION I PRODUCT IDENTIFICATION
________________________________________________________________________________
COMMON NAME PRODUCT MODEL NUMBER
Dow Corning 200 Fluid DC200
PRODUCT FILE NUMBER PRODUCT USE
920:405-DC200-10 Fill Fluid
MANUFACTURER'S NAME EMERGENCY PHONE NUMBERS
Dow Corning 1-800-424-9300 (US), 1-703-527-3887 (International)
ADDRESS ENGINEERING CONTROL DATA
South Saginaw Road MSDS - A35812-1, Rev. K, EO 5806
Drawing 鈥? A34046
CITY, STATE, ZIP DATE PREPARED
Midland, Michigan 48686 3-2-05
________________________________________________________________________________
SECTION II HAZARDOUS INGREDIENTS
________________________________________________________________________________
1.Chemical Name: Polydimethylsiloxane (Silicone)
CAS No: 63148-62-9
OSHA/PEL: NE
ACGIH/TLV: NE
%: 100
________________________________________________________________________________
SECTION III PHYSICAL & CHEMICAL DATA
________________________________________________________________________________
BOILING POINT SPECIFIC GRAVITY (H2O=1) VAPOR PRESSURE (mmHg)
300掳 F 149掳 C 0.94 <5
VAPOR DENSITY (AIR=1) SOLUBILITY IN WATER REACTIVITY IN WATER
NA less than 0.1% None
EVAPORATION RATE MELTING POINT pH
less than 1% NA - Pour Point = -100掳C NA
APPEARANCE & ODOR
clear liquid, very little odor
________________________________________________________________________________
10920 Madison Avenue Cleveland, Ohio 44102 (216) 281-1100 FAX (216) 281-0228 Page 1 of 4
www.meriam.com
________________________________________________________________________________
SECTION IV FIRE & EXPLOSION DATA
________________________________________________________________________________
FLASH POINT METHOD USED FLAMMABLE LIMITS (in Air % by Vol.) LEL UEL
325掳 F/163掳 C Open cup ND ND
AUTO-IGNITION TEMPERATURE EXTINGUISHER MEDIA
Not Determined Water spray, CO2, Dry Chemical, Foam
SPECIAL FIRE FIGHTING PROCEDURES
Evacuate area of all unnecessary personnel. Use NIOSH/MSHA approved self-contained breathing apparatus and other
protective equipment.
UNUSUAL FIRE AND EXPLOSION HAZARDS
None
________________________________________________________________________________
SECTION V REACTIVITY DATA
________________________________________________________________________________
STABILITY CONDITION TO AVOID
Stable None
INCOMPATIBILITY (Materials to Avoid)
Oxidizing material can cause a reaction. Also, strong acids and bases may react with this product.
HAZARDOUS DECOMPOSITION PRODUCTS
Silicon dioxide, carbon dioxide, and traces of incompletely burned carbon products. Traces of formaldehyde may form
during fire or very high heat conditions.
HAZARDOUS POLYMERIZATION CONDITIONS TO AVOID
Will not occur none
________________________________________________________________________________
SECTION VI HEALTH HAZARDS
________________________________________________________________________________
ACUTE
EYES
May cause mild irritation, redness, and tearing.
SKIN CONTACT
Single prolonged exposure (hours) causes no known effect. Several repeated, prolonged exposures may cause slight
irritation.
INGESTION
Amounts transferred to the mouth by fingers, etc., during normal operations should not cause injury.
INHALATION
No irritation nose or throat expected. No injury is likely from relatively short exposures.
CHRONIC EFFECTS OF EXPOSURE
No known adverse chronic health effects, but unnecessary exposure to any chemical should be avoided. This product, as
with any chemical, may enhance allergic conditions on certain people. To the best of our knowledge there are no medical
conditions that might be aggravated by exposure to this product.
________________________________________________________________________________
QUICK IDENTIFIER - DC 200 Fluid Page 2 of 4
CHEMICAL LISTED AS CARCINOGEN OR POTENTIAL CARCINOGEN
National Toxicology Program I.A.R.C. Monographs OSHA
NA NA NA
________________________________________________________________________________
SECTION VII EMERGENCY & FIRST AID PROCEDURE
________________________________________________________________________________
EYES
Immediately flush eyes with plenty of water for at least 15 minutes while holding eyelids open.
SKIN CONTACT
Remove contaminated clothing and wash with soap and water. Wash contaminated clothes.
INHALATION
Not a problem.
INGESTION
Not a problem.
________________________________________________________________________________
SECTION VIII SPILL OR LEAK PROCEDURES
________________________________________________________________________________
RESPONSE TO SMALL SPILLS
Absorb with absorbent material. Dispose of properly.
WASTE DISPOSAL
Place in an appropriate disposal facility in compliance with Federal, State, and Local regulations.
________________________________________________________________________________
SECTION IX SPECIAL PROTECTION INFORMATION
________________________________________________________________________________
RESPIRATORY PROTECTION
Not typically required. If exposure exceeds permissible exposure limits, wear a self-contained breathing apparatus in
compliance with NIOSH/MSHA specifications. Comply with 29 CFR 1910.134
VENTILATION
General (mechanical) room ventilation is generally satisfactory.
PROTECTIVE GLOVES
Not generally required.
EYE PROTECTION
Wear chemical goggles if there is likelihood of contact with eyes.
ADDITIONAL PROTECTIVE CLOTHING OR EQUIPMENT
Eye wash fountains and safety showers should be available for emergency use.
________________________________________________________________________________
QUICK IDENTIFIER - DC 200 Fluid Page 3 of 4
________________________________________________________________________________
SECTION X TRANSPORTATION
________________________________________________________________________________
Proper Shipping Name: NA
Hazard Class or Division: NA
Identification Number: NA
Packing Group: NA
Packing Authorization: NA
IATA Packing Instructions: NA
________________________________________________________________________________
SECTION XI SPECIAL PRECAUTIONS
________________________________________________________________________________
-THIS PRODUCT IS FOR INDUSTRIAL AND LABORATORY USE ONLY
-Do not store in open, unlabeled or mislabeled containers.
-Store in cool, dry place with adequate ventilation.
-Keep away from flames and high temperatures.
-For personal hygiene protection, we recommend that employees wash
thoroughly after handling product. Always wash up before eating, smoking,
and using toilet facilities.
-Keep out of reach of children.
-HMIS rating HEALTH - 0 FLAMMABILITY - 1 REACTIVITY - 0
________________________________________________________________________________
DISCLAIMER OF LIABILITY
The information contained herein is, to the best of our knowledge and belief, accurate. However, since the conditions of handling and use are beyond our control, we make no
guarantee of the results, and assume no liability for damages incurred by use of this material. All chemicals may present unknown health hazards and should be used with
caution. Although certain hazards are described herein, we cannot guarantee that these are the only hazards that exist. Final determination of suitability of the chemical is
the sole responsibility of the user. User of any chemical should satisfy themselves that the conditions and methods of use assure that the chemical is used safely. NO
REPRESENTATIONS OR WARRANTIES, EITHER EXPRESS OR IMPLIED, OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE OR ANY OTHER
NATURE ARE MADE HEREUNDER WITH RESPECT TO THE INFORMATION CONTAINED HEREIN OR THE CHEMICAL TO WHICH THE INFORMATION REFERS. It is
the responsibility of the user to comply with all applicable federal, state, local laws and regulations.
________________________________________________________________________________
QUICK IDENTIFIER - DC 200 Fluid Page 4 of 4
|