**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 18516-37-5 |2-Methyl-1-undecene | 97.0 | 242-394-9 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
The toxicological properties of this material have not been fully
investigated.
Potential Health Effects
Eye:
No information regarding eye irritation and other potential effects
was found.
Skin:
No information regarding skin irritation and other potential effects
was found.
Ingestion:
The toxicological properties of this substance have not been fully
investigated.
Inhalation:
The toxicological properties of this substance have not been fully
investigated.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid immediately.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Use water
spray to keep fire-exposed containers cool. Combustible liquid.
Containers may explode when heated.
Extinguishing Media:
Use water spray to cool fire-exposed containers. For small fires,
use dry chemical, carbon dioxide, or water spray. For large fires,
use water spray, fog or regular foam. Cool containers with flooding
quantities of water until well after fire is out.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Clean up spills immediately,
observing precautions in the Protective Equipment section. Remove all
sources of ignition.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Use with adequate ventilation. Avoid
contact with eyes, skin, and clothing. Empty containers retain
product residue, (liquid and/or vapor), and can be dangerous. Keep
container tightly closed. Keep away from heat, sparks and flame.
Avoid ingestion and inhalation. Do not pressurize, cut, weld, braze,
solder, drill, grind, or expose empty containers to heat, sparks or
open flames.
Storage:
Keep away from heat, sparks, and flame. Keep away from sources of
ignition. Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Use adequate ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 18516-37-5:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: clear, colorless
Odor: None reported.
pH: Not available.
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: Not available.
Freezing/Melting Point: Not available.
Autoignition Temperature: Not available.
Flash Point: 72 deg C ( 161.60 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: Not available.
Solubility in water:
Specific Gravity/Density: .7570g/cm3
Molecular Formula: C12H24
Molecular Weight: 168.32
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Incompatible materials, strong oxidants.
Incompatibilities with Other Materials:
Oxidizing agents, bases.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 18516-37-5 unlisted.
LD50/LC50:
Not available.
Carcinogenicity:
2-Methyl-1-undecene -
Not listed by ACGIH, IARC, or NTP.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 28A After contact with skin, wash immediately with
plenty of water.
WGK (Water Danger/Protection)
CAS# 18516-37-5: No information available.
Canada
None of the chemicals in this product are listed on the DSL/NDSL list.
CAS# 18516-37-5 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 18516-37-5 is not listed on the TSCA inventory.
It is for research and development use only.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 12/31/1997 Revision #2 Date: 3/18/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
bis(2-Ethylhexyl) hydrogen phosphate, 95% (titr.)
| 298-07-7 |
|
Acriflavine Neutral, 13.3-15.8% Chlorine (on Dried Substance)
| 7782-50-5 |
|
p-Phenetidine, 98%
| 156-43-4 |
|
Cryptocyanine, 99% (UV-VIS)
| 4727-50-8 |
|
Methyl anthranilate
| 134-20-3 |
|
Phenylmercuric Nitrate, 62.75-63.50% Mercury
| 8003-05-2 |
|
Formaldehyde, 37 wt% solution in water, stabilized with 10-15%
| 50-00-0 |
|
2,4-Dimethyl-3-pentanol, 99+%
| 600-36-2 |
|
4-Bromochlorobenzene, 99%
| 106-39-8 |
|
Beta-Alanine, 98%
| 107-95-9 |
|
Tin (IV) Oxide, 99.995%
| 18282-10-5 |
|
Ethanesulfonic Acid, 99%
| 594-45-6 |
|
5-Methyl-3-heptanone, 98.5+%
| 541-85-5 |
|
m-Phenetidine, 98%
| 621-33-0 |
|
4-Dimethylaminobenzaldehyde, 98%
| 100-10-7 |
|
4-Dimethylaminobenzaldehyde, reagent acs
| 100-10-7 |
|
1,1,2,2-Tetrachloroethane, 97%
| 79-34-5 |
|
p-Phenylenediamine, 99+%
| 106-50-3 |
|
Hemin, bovine, crystalline, 98%
| 16009-13-5 |
|
2,6-Dimethylphenol, P.A.
| 576-26-1 |
|
beta-Methylstyrene, 99% trans, stabilized with 0.01% BHT
| 128-37-0 |
|
Diethyl Sulfate, 99%
| 64-67-5 |
|
3,5-Diiodosalicylic Acid, 97% (HPLC)
| 133-91-5 |
|
2-Sulfobenzoic Acid Cyclic Anhydride, Tech
| 81-08-3 |
|
1,5-Pentanediol, 98%
| 111-29-5 |
|
Dibenzyl Phosphate, 99%
| 1623-08-1 |
|
2-Methyl-1-undecene, 99+%
| 18516-37-5 |
|
2-Nitrobenzoic acid, 85-90%,(gc)
| 552-16-9 |
|
Lithium acetylide, ethylenediamine complex 85-92%
| 6867-30-7 |
|
3,3',4,4'-Benzophenonetetracarboxylic dianhydride, 96%
| 2421-28-5 |
|
trans-Cinnamaldehyde, 99%
| 104-55-2 |
|
Fullerene C70, 99+% (HPLC)
| 115383-22-7 |
|
3-Bromo-1-propanol, 98%
| 627-18-9 |
|
3-Nitrobenzyl chloride, 97+% (gc)
| 619-23-8 |
|
2,6-Diethylaniline, 98%
| 579-66-8 |
|
1,1,1-Trichloroethane, 93.5%, stabilized with ca. 5% 1,4-dioxane
| 71-55-6 |
|
Trimethyl Phosphate, 97%
| 512-56-1 |
|
2-(5-Bromo-2-Pyridylazo)-5-(Diethylamino)- Phenol, 97%
| 14337-53-2 |
|
Beta-Cyclodextrin Hydrate, 99% (HPLC)
| 68168-23-0 |
|
3,3'-Diethylthiadicarbocyanine Iodide, 99% (UV-VIS)
| 514-73-8 |
|
4-Methyl-1-cyclohexene, 99%
| 591-47-9 |
|
Mesityl oxide, 99%, mixt.of alpha- and bet a isomers(ca.93% alpha)
| 141-79-7 |
|
Butyl acrylate, 99+%, stabilized with 20 ppm MEHQ
| 141-32-2 |
|
Methyl diphenylphosphine, 99%
| 1486-28-8 |
|
2,5-Di-tert-butylhydroquinone
| 88-58-4 |
|
Orcinol, Monohydrate (Pract), 95% (UV-Vis)
| 6153-39-5 |
|
1-Iodohexane, 98+%,stabilized over copper
| 638-45-9 |
|
Octadecane, 99+% (gc)
| 593-45-3 |
|
Pamoic Acid, Disodium Salt Monohydrate, 98% (UV-Vis)
| 6640-22-8 |
|
Potassium fluoride
| 7789-23-3 |
|
|