101-55W175,SANTOPRENE THERMOPLASTIC RUBBER GENERAL PURPOSE G
CAS
:
NAME
:
*** proprietary ***
ADVANCED ELASTOMER SYSTEMS LP -- 101-55W175,SANTOPRENE THERMOPLASTIC RUBBER GE
=======================================================
Material Safety Data Sheet
=======================================================
MSDS Num: CJPTN
MSDS NAME: 101-55W175,SANTOPRENE THERMOPLASTIC RUBBER GENERAL PURPOSE G
Responsible Party
Name: ADVANCED ELASTOMER SYSTEMS LP
Address: 388 SOUTH MAIN ST
City: AKRON OH 44311
Info Phone: 330-849-5163
Emergency Phone Number: (800)424-9300
Chemtrec IND/Phone: (800)424-9300
Proprietary Ind: Y
Review Ind: Y
Published: Y
=======================================================
Contractor Summary
=======================================================
Name: ADVANCED ELASTOMER SYSTEMS LP
Address: 388 SOUTH MAIN ST
City: AKRON OH 44311
Phone: 330-849-5163
=======================================================
Ingredients
=======================================================
Name: *** PROPRIETARY ***
-----------------------------
=======================================================
Health Hazards Data
=======================================================
Route Of Entry Inds - Inhalation: YES
Skin: YES
Ingestion: NO
Carcinogenicity Inds - NTP: NO
IARC: YES
OSHA: NO
Effects of Exposure: INHALATION: INHALATION OF FUMES OR VAPORS DURING
PROCESSING MAY CAUSE RESPIRATORY TRACT IRRITATION. EYE CONTACT: PELLETS DO
NOT CAUSE SIGNIFICANT EYE IRRITATION. SKIN CONTACT: PELLETS DO NOT CAUSE SIG
NIFICANT SKIN IRRITATION.
Explanation Of Carcinogenicity: CARBON BLACK: IARC MONOGRAPHS, VOL 65, PG 149,
1996:GROUP 2B.
Signs And Symptions Of Overexposure: SEE HEALTH HAZARDS.
First Aid: ANSI APPROVED CHEMICAL WORKERS GOGGLES & FULL LENGTH FACESHIELD
(FP N). IMPERVIOUS GLOVES (FP N). ANSI APPROVED EYE WASH AND DELUGE SHOWER
(FP N). INHAL: IF FUMES ARE INHALED, REMOVE TO FRESH AIR. IF BREATHING IS
DIFFICULT, GET MEDICAL ATTENTION.
=======================================================
Handling and Disposal
=======================================================
Spill Release Procedures: SPILLED PRODUCT MAY CAUSE A SLIPPING HAZARD. IN CASE
OF SPILL OR LEAK, VACUUM OR SWEEP UP AND PLACE IN CLEAN, COVERED CONTAINERS
FOR RECYCLE OR DISPOSAL.
Waste Disposal Methods: WHEN DISCARDED, SANTOPRENE GEN PURPOSE THERMOPLASTIC
RUB IS NOT "HAZ WASTE" AS DEFINED IN 40 CFR 261, "IDENTIFICATION &
LISTING OF HAZ WASTE." RECYCLE OR BURN IN APPRVD INCINERATOR OR DISPOSE OF IN
AP PRVD CHEM LANDFILL I/A/W ALL APPLIC LOCAL, STATE & FED LAWS &
REGS. CONSULT YOUR ATTORNEY OR APPROP REGULATORY OFFICIALS FOR INFO ON SUCH
(SUPDAT)
Handling And Storage Precautions: AVOID LEAVING CONTAINER OPEN FOR PRLNGD
PERIODS TO PREVENT EXPOSURE TO HUMITIDY. SANTOPRENE GENERAL PURPOSE
THERMOPLASTIC RUBBER WILL PICK UP SMALL AMTS OF MOISTURE. STORE IN A COOL,
DRY PLACE. USUAL PRECS IN PELLET HANDLING SHOULD BE OBSERVED TO PREVENT
CONTAMINATION BY DIRT OR OTHER MATERIALS.
Other Precautions: HANDLE PELLETS I/A/W GOOD INDUS HYGIENE & SAFETY
PRACTICES. THESE PRACTICES INCLUDE AVOIDING UNNEC EXPOSURE & REMOVAL OF
MATL FROM EYES, SKIN & CLTHG. CAUTION! PROCESSING RELEASES VAPORS OR
FUMES WHIC H MAY CAUSE RESPIRATORY TRACT IRRITATION. AVOID BRTHNG PROCESSING
FUMES OR VAPORS. PROCESS USING ADE Q VENTILATION.
=======================================================
Fire and Explosion Hazard Information
=======================================================
Flash Point Text: SUPDAT
Extinguishing Media: WATER SPRAY OR ANY CLASS A EXTINGUISHING AGENT.
Fire Fighting Procedures: USE NIOSH APPROVED SCBA AND FULL PROTECTIVE EQUIPMENT
(FP N). CARBON MONOXIDE IS LIBERATED AS A TOXIC DECOMPOSITION PRODUCT WHEN
SANTOPRENE GENERAL PURPOSE THERMOPLASTIC RUBBER IS IGNITED.
Unusual Fire/Explosion Hazard: NONE KNOWN.
=======================================================
Physical/Chemical Properties
=======================================================
Spec Gravity: 0.95-0.98
Appearance and Odor: BLACK OR NATURAL (COLORABLE) PELLETS; SLIGHTLY RUBBERLIKE
ODOR.
=======================================================
Reactivity Data
=======================================================
Stability Indicator: YES & (STATE REG INFO)
Stability Condition To Avoid: THERMALLY STABLE TO 500F (260C).
Materials To Avoid: SANTOPRENE THERMOPLASTIC RUBBER MAY REACT W/STRONG
OXIDIZING CHEMS. IT ALSO REACT W/ACETAL RESINS AT TEMPS OF 425F(218C) &
ABOVE, PRODUCING DECOMP OF ACETAL RESIN & FORMALDEHYDE AS DECOMP PROD. DECOMP
OF HALOGENATED POLYMER
Hazardous Decomposition Products: SMOKE, CARBON MONOXIDE AND POSSIBLY
HYDROCARBONS MAY EVOLVE WHEN PROCESSING TEMPERATURES EXCEED 500F (260C) OR
WHEN SANTOPRENE GENERAL PURPOSE THERMOPLSATIC RUBBER IS IGNITED.
Hazardous Polymerization Indicator: NO
=======================================================
Toxicological Information
=======================================================
Toxicological Information: FOLLOWING INFO SUMMARIZES HUMAN EXPERIENCE &
RSLTS OF SCIENTIFIC INVESTIGATIONS REVIEWED BY HEALTH PROFESSIONALS FOR HAZ
EVALUATION OF SANTOPRENE GEN PURPOSE THERMOPLASTIC RUB. OCCUP EXPOS TO THIS
MAT L IN NORM HNDLG & STORAGE HAS NOT BEEN REPORTED TO CAUSE SIGNIFICANT
ADVERSE HUMAN HLTH EFTS. DUE TO ITS CHEM & PHYSICAL PROPERTIES.
SANTOPRENE GEN PURPOSE THERMOPLASTIC RUB DOES NOT APPEAR TO POSSESS ANY
TOXICOLOGICAL PROPERTIES WHICH WOULD REQ SPEC HNDLG OTHER THAN GOOD INDUS
HYGIENE & SFTY PRACTS EMPLOYED W/ANY INDUS MATL OF THIS TYPE. HOWEVER,
UNDER NORM PROCESSING CNDTNS, PROD WILL (STATE RE G INFO)
=======================================================
Ecological Information
=======================================================
Ecological: NO DATA AVAILABLE. STATE REG INFO: CANNOT BE PREDICTED BASED ON
CURRENT INFO. THESE PROCESS RELEASES MAY PRDCE RESP TRACT IRRIT WHERE SUCH
RELEASES ARE ALLOWED TO BUILD UP DUE TO INADEQUATE VENT IN GE NERAL WORK
AREA. THESE FUMES & VAPS, W/RPTD & PRLNGD EXPOSURE AT HIGH CONCS,
COULD CAUSE NAUS, DROW & HDCH, ESP IF SUCH EXPOSURES EXCEED CURRENT
EXPOSURE LIMITS (WHERE ESTABLISHED). GOOD INDUSTRIAL HY GIENE & SAFETY
PRACTICES SHOULD BE USED TO AVOID UNNEC EXPOSURES. TOXICOLOGICAL DATA - RSLTS
OF SINGLE EXPOSURE (ACUTE) ANIMAL STUDIES CONDUCTED ON REPRESENTATIVE GRADE
OF GENERAL (TRANSPORT INFO)
=======================================================
MSDS Transport Information
=======================================================
=======================================================
Regulatory Information
=======================================================
Sara Title III Information: SARA HAZARD NOTIFICATION - HAZARD CATEGORIES UNDER
CRITERIA OF SARA TITLE III RULES (40 CFR PART 370): N/A. SECTION 313
HAZARDOUS CHEMICAL(S): N/A. SECTION 313 INFO MUST BE INCLUDED IN ALL MSDSS
THAT ARE COPIED & DISTRIBUTED FOR THIS MATL.
Federal Regulatory Information: REPORTABLE QUANTITY (RQ) UNDER DOT (49 CFR)
& CERCLA REGS: N/A. HAZ CHEM(S) UNDER OSHA HAZ COMMUNICATION STANDARD:
BLACK GRADE CONTAIN CARBON BLACK: 2-3% WT RANGE. RATING: REACTIVITY-1;
HEALTH: 1 ; FLAMMABILITY: 1.ALLL COMPONENTS OF THESE PRODUCTS APPEAR ON THE
INVENTORY OF CHEMICAL SUBSTANCES PUBLISHED BY U.S. EPA/QUALIFY FOR TSCA:
POLYMER.
State Regulatory Information: NJ TRADE SECRET REGISTRY NO:
01122800003-5001P.MATLS TO AVOID: PHENOLIC RESINS MAY ALSO BE ACCELERATED
WHEN THEY ARE IN CONT W/SANTOPRENE THERMOPLASTIC RUBBER AT PROCESSING TEMPS.
THOROUGHLY PURGE PRO CESSING EQUIP W/POLYOLEFIN POLYMERS, INCL POLYPROPYLENE,
WHEN USING SAME EQUIP TO PROCESS SANTOPRENE THERMOPLASTIC RUBBER & ACETAL
RESINS, HALOGENATED POLYMERS & PHENOLIC RESINS. DO NOT MIX SANTOPRENE
THERMOPLASTIC RUBBER, ACETAL RESINS, HALOGENATED POLYMERS OR PHENOLIC RESINS
AT ELEV TEMPS. TOXIC I NFO: RELS FUMES & VAPS. COMPONENTS OF THESE RELS
MAY VARY W/PROCESSING TIMES & TEMPS & THEREFORE SPECIFIC COMPOSITION
(ECOLOGICAL INFO)
=======================================================
Other Information
=======================================================
Other Information: DATE MSDS INITIALLY PREPARED: 5/5/95. REVISION(S):
9/30/96-UPDATED CARBON BLACK INFO. 10/11/96-UPDATED POLYMER EXEMPTION INFO.
12/1/98-REVIEWED FOR ACCURACY; NO CHANGES MADE. FOR ADDNL NON-EMER INFO,
CNTCT PROD SFTY-(330)849-5163. HYGIENE PRACTS: WASH HANDS & CONTAM SKIN
THOROUGHLY AFTER HNDLG. PHYSICAL DATA - HARDNESS: 45 SHORE A TO 50 SHORE D.
NOTE: THESE PHYSICAL DATA ARE TYPICAL VALUES BASED O N MATL TESTED BUT MAY
VARY FROM SAMPLE TO SAMPLE. TYPICAL VALUES SHOULD NOT BE CONSTRUED AS
GUARANTEED ANALYSIS OF ANY SPECIFIC LOT OR AS SPECIFICATIONS FOR PROD.
=======================================================
HAZCOM Label
=======================================================
MSDS NAME: 101-55W175,SANTOPRENE THERMOPLASTIC RUBBER GENERAL PURPOSE G
Company: ADVANCED ELASTOMER SYSTEMS LP
Street: 388 SOUTH MAIN ST
City: AKRON OH
Zipcode: 44311
Health Emergency Phone: (800)424-9300
Label Required IND: Y
Date Of Label Review: 10/14/1999
Status Code: A
Origination Code: F
Chronic Hazard IND: Y
Eye Protection: YES
Skin Protection IND: YES
Signal Word: WARNING
Respiratory Protection: YES
Health Hazard: Moderate
Contact Hazard: Slight
Fire Hazard: None
Reactivity Hazard: None
Hazard And Precautions: ACUTE: INHALATION: INHALATION OF FUMES OR VAPORS DURING
PROCESSING MAY CAUSE RESPIRATORY TRACT IRRITATION. EYE CONTACT: PELLETS DO
NOT CAUSE SIGNIFICANT EYE IRRITATION. SKIN CONTACT: PELLETS DO NOT CA USE
SIGNIFICANT SKIN IRRITATION. CHRONIC: CANCER HAZ. CONTAINS CARBON BLACK WHICH
IS LISTED AS AN ANIMAL CARCINOGEN (FP N).
=======================================================
Disclaimer (provided with this information by the compiling agencies): This
information is formulated for use by elements of the Department of Defense.
The United States of America in no manner whatsoever expressly or implied
warrants, states, or intends said information to have any application, use or
viability by or to any person or persons outside the Department of Defense
nor any person or persons contracting with any instrumentality of the United
States of America and disclaims all liability for such use. Any person
utilizing this instruction who is not a military or civilian employee of the
United States of America should seek competent professional advice to verify
and assume responsibility for the suitability of this information to their
particular situation regardless of similarity to a corresponding Department
of Defense or other government situation.