=====================  Product Identification  =====================

MSDS NAME:D-703 DEVELOPER (SEE SUPPL DATA)
NIIN:00-782-2740
Kit Part:Y
MSDS Number: BFPPW
=== Responsible Party ===
Company:MET-L-CHEK COMPANY
Address:1639 EUCLID STREET
City:SANTA MONICA
State:CA
ZIP:90404-3770
Country:US
Info Phone Num:213-450-1111
Emergency Phone Num:213-450-1111
CAGE:98733
=== Contractor Identification ===
Company:MET-L-CHEK COMPANY
Address:1639 EUCLID ST
Box:00000
City:SANTA MONICA
State:CA
ZIP:90404
Country:US
Phone:310-450-1111/FAX 310452-4046
CAGE:98733

=============  Composition/Information on Ingredients  =============

Name:METHYL CHLOROFORM (1,1,1-TRICHLOROEHANE)  (SARA III)
CAS:71-55-6
RTECS #:KJ2975000
OSHA PEL:350 PPM/450 STEL
ACGIH TLV:350 PPM/450STEL;9192
EPA Rpt Qty:1000 LBS
DOT Rpt Qty:1000 LBS
Ozone Depleting Chemical:1

Name:ISOBUTANE/PROPANE MIXTURE (AS PROPELLANT)
OSHA PEL:1000PPM(PROPANE)
ACGIH TLV:ASPHYXIANT (PROPANE)

=====================  Hazards Identification  =====================

Routes of Entry: Inhalation:YES  Skin:YES  Ingestion:YES
Reports of Carcinogenicity:NTP:NO    IARC:NO	OSHA:NO
Health Hazards Acute and Chronic:MAY CAUSE MILD IRRITATION TO SKIN &
    RESP TRACT SYSTEM
Effects of Overexposure:INHAATION CAUSE IRRITATION TO NOSE AND
    RESPIRATORY SYSTEM.EARLY TO MODERATE CNS DEPRESSION MAY BE
    EVIDENCED BY DIZZ,GIDDINESS,HEADACHE,NAUSEA;EYES:VAPOR MAY CAUSE
    IRRITATION;SKIN:LIQUID CONTACT MAY IR RATATE MILDLY;INGESTION:MAY
    CAUSE IRRITATION TO MOUTH & GI TRACT.
Medical Cond Aggravated by Exposure:PRE-EXISTING SKIN,EYE,AND
    RESPIRATORY DISORDERS MAY BE AGGRAVATED.

=======================  First Aid Measures  =======================

First Aid:INHALATION:REMOVE TO FRESH AIR.GIVE CPR IF
    NEEDED;EYES/SKIN:FLUSH WITH RUNNING WATER FOR ATLEAST 15
    MINUTES.GET MEDICAL HELP IF IRRITATION OCCURS OR PERSISTS;
    INGESTION:GIVE LG QTY OF WATER.DO NOT IND UCE VOMITING.NOTHING BY
    MOUTH IF UNCONSCIOUS GET MEDICAL ATTENTION.

=====================  Fire Fighting Measures  =====================

Flash Point:N/R (AEROSOLS)
Lower Limits:2.0 (LIQ)
Upper Limits:15.0 (LIQ)
Extinguishing Media:WATER FOG,"ALCOHOL" FOAM,DRY CHEMICAL OR CO*2
Fire Fighting Procedures:CONTAINERS EXPOSED TO INTENSE HEAT FROM FIRES
    SHOULD BE COOLED WITH WATER SPRAY TO PREVENT VAPORS PRESSURE
    BUILD-UP.DON T STORE ABOVE 120F.
Unusual Fire/Explosion Hazard:AEROSOL CANS MAY RUPTURE/EXPOSED DUE TO
    VAPOR PRESSURE BUILD IF EXPOSE TO INTENSE HEAT.

==================  Accidental Release Measures  ==================

Spill Release Procedures:ELIMINATE IGNITION SOURCES.WEAR PROTECTV
    CLOTHING & APPROPRIATE RESPIRATOR.SOAKUP RESIDUE WITH ABSORBENT
    CLAY,SAND,EARTH, OR OTHER MATERIAL.PLACE RAGS & ABSORBED WASTE AND
    DAMAGED BUT EMPTY CANS IN DO T COVERED NON-LEAKING CONTAINERS.

======================	Handling and Storage  ======================

Handling and Storage Precautions:STORE AWAY FROM HOT PLACES & IGNITION
    SOURCES.DO NOT STORE OR HANDLE IN ALUMINUM EQUIPMENT AT TEMP ABOVE
    120F.
Other Precautions:DURING TRANSFER OF LIQUID IN BULK,GROUND THE HANDLING
    EQUIPMENT

=============  Exposure Controls/Personal Protection  =============

Respiratory Protection:USE NIOSH APPROVED RESPIRATOR IF EXPOSURE TLV
    LIMITS.
Ventilation:PER MFR,MECHANICAL(GEN) OR LOCAL EXHAUST TO MAINTAIN TLV OR
    REDUCE VAPORS.
Protective Gloves:CHEMICAL RESISTANT
Eye Protection:GOGGLES
Other Protective Equipment:EYE WASH FOUNTAINS AND SAFETY SHOWERS.
Work Hygienic Practices:WASH WITH SOAP & WATER BEFORE
    EATING,DRINKING,SMOKING OR USING TOILET FACILITIES
Supplemental Safety and Health
NSN OF 3 PARTS KIT UNDER TYPE I,METH C, LEVEL 3 OF MIL-I-25135,REV
    D;KIT CONSISTS OF PENETRANT,DEVELOPER,& REMOVER;I/A/W
    QPL-25135-15,THE MET-L-CHEK KIT MAY HAVE (1)FP-95,FP-98,OR FP-99
    PENETRANT,(2)  R-501 REMOVER,& (3) D-701 OR D-703
    DEVELOPER;KEY1:J7;THIS ENTRY DESCRIBES:D-703 DEVELOPER.

==================  Physical/Chemical Properties  ==================

HCC:V3
Spec Gravity:1.30-1.32(BULK)
Evaporation Rate & Reference:0.35 OF LIQ(ETHER=1.0)
Solubility in Water:APPRECIATE
Appearance and Odor:LIQUID BEFORE FILLING IN AEROSOL CANS IS MILKY
    WHITE LIQ WITH ETHER-LIKE ODOR.

=================  Stability and Reactivity Data  =================

Stability Indicator/Materials to Avoid:YES
STRONG OXIDIZING MATERIALS,CAUSTIC SODA,CASUTIC POTASH.
Stability Condition to Avoid:HEAT,SPARKS,IGNITION SOURCES
Hazardous Decomposition Products:CARBON MONOXIDE & UNIDENTIFIED ORGANIC
    COMPOUNDS,HYDROGEN CHLORIDE & TRACES OF PHOSGENS.

====================  Disposal Considerations  ====================

Waste Disposal Methods:DISPOSE OF AS EPA HAZARDOUS WASTE MANAGEMENT
    FACILITIES.EMPTY AEROSOL CAN BEFORE DISPOSING OF THEM.PRESSURIZED
    AEROSOL CANS ARE NOT ACCEPTABLE WASTE.COMPLY ALL FEDERAL,STATE &
    LOCAL REGULATIONS.

 Disclaimer (provided with this information by the compiling agencies):
 This information is formulated for use by elements of the Department
 of Defense.  The United States of America in no manner whatsoever,
 expressly or implied, warrants this information to be accurate and
 disclaims all liability for its use.  Any person utilizing this
 document should seek competent professional advice to verify and
 assume responsibility for the suitability of this information to their
 particular situation.

*** END OF RECORD ***