Material Safety Data Sheet
SOLTROL 庐 10 ISOPARAFFIN SOLVENT
August 27, 2003
MSDS #: 34750
Revision#: 2
PHONE NUMBERS
CHEVRON PHILLIPS CHEMICAL COMPANY LP HEALTH:
10001 Six Pines Drive Chevron Phillips Emergency
The Woodlands, TX 77380 Information Center 866.442.9628
(North America) and
1.832.813.4984(International)
TRANSPORTATION:
North America: CHEMTREC 800.424.9300
or 703.527.3887
ASIA: 1.703.527.3887
EUROPE: BIG .32.14.584545 (phone)
or .32.14.583516 (telefax)
SOUTH AMERICA SOS-Cotec
Inside Brazil: 0800.111.767
Outside Brazil: 55.19.3467.1600
Technical Services: (832) 813-4862
For Additional MSDSs: (800) 852-5530
A. Product Identification
Synonyms: Not Established
Chemical Name: Mixture
Chemical Family: Aliphatic Hydrocarbon
Chemical Formula: Mixture
CAS Reg. No.: 70024-92-9
Product No.: AP0100
Product and/or Components Entered on EPA's TSCA Inventory: YES
This product is in U.S. commerce, and is listed in the Toxic Substances
Control Act (TSCA) Inventory of Chemicals; hence, it may be subject to
applicable TSCA provisions and restrictions.
Canadian Inventory Listing Status: NDSL
This product contains ingredients that are Not listed in the Domestic
Substances List (DSL), but ARE listed in the Non-Domestic Substances List
(NDSL). Impurities are exempt in accordance with Section 3 of the
Canadian Environmental Protection Act (CEPA).
B. Components
CAS % OSHA ACGIH
Ingredients Number By Wt. PEL TLV
Isooctane 540-84-1 62.0 NE 300 ppm
Heptane isomers 31394-54-4 28.0 NE NE
Octane isomers 26635-64-3 10.0 NE 300 ppm
See Section F, Recommended Exposure Limits.
C. Personal Protection Information
Ventilation: Use adequate ventilation to control concentration
below recommended exposure limits.
Respiratory Protection: For concentrations exceeding the recommended exposure
limit, use NIOSH approved air purifying respirator.
Eye Protection: Use safety glasses with side shields.
Skin Protection: Use gloves resistant to the material being used.
(Neoprene).
NOTE: Personal protection information shown in Section C is based upon
general information as to normal uses and conditions. Where special or
unusual uses or conditions exist, it is suggested that the expert
assistance of an industrial hygienist or other qualified professional
be sought.
D. Handling and Storage Precautions
Avoid contact with eyes, skin or clothing. Avoid breathing vapors,
mist, fume or dust. Do not swallow, may be aspirated into lungs. Wear
protective equipment and/or garments described in Section C if exposure
conditions warrant. Wash thoroughly after handling. Launder
contaminated clothing before reuse. Use with adequate ventilation.
Keep away from heat, sparks, and flames. Store in well-ventilated area.
Store in tightly closed container. Bond and ground during transfer.
E. Reactivity Data
Stability: Stable
Conditions to Avoid: Not Established
Incompatibility (Materials to Avoid): Oxygen and strong oxidizing agents
Hazardous Polymerization: Will Not Occur
Conditions to Avoid: Not Established
Hazardous Decomposition Products: Carbon oxides and various hydrocarbons
formed when burned.
F. Health Hazard Data
Recommended Exposure Limits:
The Company recommends a permissible exposure level (8-hr. TWA) of 300
ppm for isooctane (2,2,4-Trimethylpentane).
Acute Effects of Overexposure:
Eye: May produce mild irritation.
Skin: May produce mild irritation. The dermal LD50 (rabbit) for
isooctane is > 2000 mg/kg.
Inhalation: May cause slight mucous membrane irritation, rapid breathing,
fatigue, headache, light headedness, dizziness and other central
nervous system effects. Extreme exposures may cause respiratory
arrest, convulsions or unconsciousness. The inhalation LC50
(rat) for isooctane is > 3078.44 ppm after a 4-hr. exposure and a
14-day postexposure observation period.
Ingestion: May cause diarrhea, slight central nervous system depression,
difficulty breathing and fatigue. If swallowed, may be aspirated
resulting in inflammation and possible fluid accumulation in the
lungs. The oral LD50 (rat) for isooctane is > 5000 mg/kg.
Subchronic and Chronic Effects of Overexposure:
In a subchronic oral laboratory study isooctane, a component of this
product, has produced kidney damage in male rats only. No comparable
health hazard for kidney disease is known to occur in humans.
Other Health Effects:
Health Hazard Categories:
Animal Human Animal Human
Known Carcinogen ___ ___ Toxic ___ ___
Suspect Carcinogen ___ ___ Corrosive ___ ___
Mutagen ___ ___ Irritant ___ ___
Teratogen ___ ___ Target Organ Toxin _X_ _X_
Allergic Sensitizer ___ ___ Specify - Lung-Aspiration Hazard
Highly Toxic ___ ___
Canadian WHMIS
CLASS D: POISONOUS AND INFECTIOUS MATERIAL CATEGORIES
1. Materials Causing Immediate and Serious Toxic Effects
A. Very Toxic _____
B. Toxic _____
2. Materials Causing Other Toxic Effects
A. Very Toxic
1. Chronic Toxic Effects _____
2. Teratogen/Embryo Toxin _____
3. Carcinogen _____
4. Reproductive Toxin _____
5. Respiratory Tract Sensitizer _____
6. Mutagen _____
B. Toxic
1. Chronic Toxic Effects _____
2. Skin or Eye Irritant __x__
3. Skin Sensitizer _____
4. Mutagen _____
Specify: Eye Irritant.
Other: Lung-Aspiration Hazard
First Aid and Emergency Procedures:
Eye: Flush eyes with running water for at least fifteen minutes. If
irritation or adverse symptoms develop, seek medical attention.
Skin: Wash skin with soap and water for at least fifteen minutes. If
irritation or adverse symptoms develop, seek medical attention.
Inhalation: Remove from exposure. If breathing is difficult, give oxygen.
If breathing ceases, administer artificial respiration followed
by oxygen. Seek immediate medical attention.
Ingestion: Do not induce vomiting. Seek immediate medical attention.
Note to Physician: Gastric lavage using a cuffed endotracheal tube
may be performed at your discretion.
G. Physical Data
Appearance: Colorless liquid
Odor: Mild
Boiling Point: 204F (96C)
Vapor Pressure: 2.2 psia @ 100F (37.8C)
Vapor Density (Air = 1): >2
Solubility in Water: Negligible
Specific Gravity (H2O = 1): 0.698 @ 60F (15.6C)
Percent Volatile by Volume: 100
Evaporation Rate (Butyl Acetate=1): >1
Viscosity: 0.57 cSt @ 100F (38C)
Autoignition Temperature: 788F (420C)
H. Fire and Explosion Data
Flash Point (Method Used): <13F (<-11C) (TCC, ASTM, D56)
Flammable Limits (% by Volume in Air): LEL - 1 (ESTIMATED)
UEL - 6.6 (ESTIMATED)
Fire Extinguisher Media: Dry chemical, foam or carbon dioxide
(CO2)
Special Fire Fighting Procedure: Evacuate area of all unnecessary
personnel. Shut off source, if
possible. Use NIOSH approved
self-contained breathing apparatus and
other protective equipment and/or
garments described in Section C if
conditions warrant. Water fog or
spray may be used to cool exposed
equipment and containers. Do not
water directly on fire product
will float and could be reignited on
surface of water.
Fire and Explosion Hazard: Carbon ioxide formed when burned.
Highly flammable vapors which are
heavier than air may accumulate in low
areas and/or spread along ground away
from handling site.
I. Spill, Leak and Disposal Procedures
Precautions Required if Material is Released or Spilled:
Evacuate area of all unnecessary personnel. Wear protective equipment
and/or garments described in Section C if exposure conditions warrant.
Shut off source, if possible and contain spill. Protect from ignition.
Keep out of water sources and sewers. Absorb in a dry, inert material
(sand, clay, etc). Transfer to disposal drums using non-sparking
equipment.
Waste Disposal (Insure Conformity with all Applicable Disposal Regulations):
Incinerate or place in permitted waste management facility.
J. DOT Transportation
Shipping Name: Hydrocarbons, liquid, n.o.s.
Hazard Class: 3
ID Number: UN3295
Packing Group: PG II
Marking: Hydrocarbons, liquid, n.o.s., UN 3295, RQ*
Label: Flammable liquid
Placard: Flammable/3295
Hazardous Substance/RQ: 2,2,4-Trimethylpentane
Shipping Description: Hydrocarbons, liquid, n.o.s., 3, UN3295, II, RQ*
Packaging References: 49 CFR 173,150, 173.202, 173.242
*Enter the letters "RQ" as shown and the name (or names) of the hazardous
substance in parentheses only if there is present in a quantity, in one
package, which equals or exceeds the reportable quantity shown for
hazardous substance.
K. RCRA Classification - Unadulterated Product
as a Waste
Ignitable (D001)
Prior to disposal, consult your environmental contact to determine
if TCLP (Toxicity Characteristic Leaching Procedure, EPA Test Method
1311) is required. Reference 40 CFR Part 261.
L. Protection Required for Work on Contaminated
Equipment
Contact immediate supervisor for specific instructions before work
is initiated. Wear protective equipment and/or garments described
in Section C if exposure conditions warrant.
M. Hazard Classification
_X_ This product meets the following hazard definition(s) as defined by
the Occupational Safety and Health Hazard Communication Standard (29
CFR Section 1910.1200):
___ Combustible Liquid ___ Flammable Aerosol ___ Oxidizer
___ Compressed Gas ___ Explosive ___ Pyrophoric
___ Flammable Gas _X_ Health Hazard (Section F) ___ Unstable
_X_ Flammable Liquid ___ Organic Peroxide ___ Water Reactive
___ Flammable Solid
___ Based on information presently available, this product does not meet
any of the hazard definitions of 29 CFR Section 1910.1200.
Canadian WHMIS
Class B-Flammable and Combustible Material
Class D-Poisonous and Infectious Material
Division 2. Materials Causing Other Toxic Effects
N. Additional Comments
SARA 313
As of the preparation date, this product did not contain a chemical or
chemicals subject to the reporting requirements of Section 313 of Title
III of the Superfund Amendments and Reauthorization Act of 1986 and 40
CFR Part 372.
REVISION STATEMENT
This revision updates section J.
NFPA 704 Hazard Codes - - - - - - - - Signals
Least - 0
Health :0
Slight - 1
Flammability: 3 Moderate - 2
Reactivity : 0 High - 3
Special Haz.: - Extreme - 4
Prepared according to the OSHA Hazard Communication Standard (29 CFR 1910.1200) and the
ANSI MSDS Standard (Z400.1) by EHS Product Stewardship Group, Chevron Phillips Chemical
Company LP, 10001 Six Pines Drive, The Woodlands, TX 77380
The above information is based on the data of which we are aware and is believed to be correct as
of the date hereof. Since this information may be applied under conditions beyond our control and
with which we may be unfamiliar and since data made available subsequent to the date hereof may
suggest modifications of the information, we do not assume any responsibility for the results of its
use. This information is furnished upon condition that the person receiving it shall make his own
determination of the suitability of the material for his particular purpose.
|