Material Safety Data Sheet
SOLTROL庐 100 ISOPARAFFIN SOLVENT
January 4, 2002
MSDS #: 34680
Revision #: 2
PHONE NUMBERS
CHEVRON PHILLIPS CHEMICAL COMPANY LP EMERGENCY: (800) 231-0623 or
10001 Six Pines Drive (510) 231-0623 (International)
The Woodlands, Tx 77380 EMERGENCY RESPONSE (ASIA): 800-AlertSGS
or 800-25378747 or 65-6542-9595
(SOUTH AMERICA) SOS-COTEC
Inside Brazil - 0800-111-767
Outside Brazil - 55-19-3467-1600
TRANSPORTATION (24 HR): CHEMTREC
(800)424-9300 OR (703)527-3887
Technical Services: (832)813-4862
For Additional MSDSs: (800) 852-5530
A. Product Identification
Synonyms: Not Established
Chemical Name: C9-C11 Isoalkanes
Chemical Family: Aliphatic hydrocarbon
Chemical Formula: Mixture
CAS Reg. No.: 68551-16-6
Product No.: AP1000
Product and/or Components Entered on EPA's TSCA Inventory: YES
This product is in U.S. commerce, and is listed in the Toxic Substances
Control Act (TSCA) Inventory of Chemicals; hence, it may be subject to
applicable TSCA provisions and restrictions.
Canadian Inventory Listing Status: NDSL
This product contains ingredients that are NOT listed in the Domestic
Substances List (DSL), but ARE listed in the Non-Domestic Substances List
(NDSL). Impurities are exempt in accordance with Section 3 of the
Canadian Environmental Protection Act (CEPA).
B. Components
CAS % OSHA ACGIH
Ingredients Number By Wt. PEL TLV
C9-C11 Isoalkanes 68551-16-6 100 NE NE
See Section F, Recommended Exposure Limits.
C. Personal Protection Information
Ventilation: Use adequate ventilation to control concentration
below recommended exposure limits.
Respiratory Protection: Not generally required. For concentrations exceeding
the recommended exposure limit, use NIOSH approved
air purifying respirator.
Eye Protection: Use safety glasses with side shields. For splash
protection, use chemical goggles and face shield.
Skin Protection: Avoid unnecessary skin contamination with material.
Use gloves resistant to the material being used.
(eg. neoprene or Viton).
NOTE: Personal protection information shown in Section C is based upon
general information as to normal uses and conditions. Where
special or unusual uses or conditions exist, it is suggested that
the expert assistance of an industrial hygienist or other qualified
professional be sought.
D. Handling and Storage Precautions
Avoid contact with eyes, skin or clothing. Avoid breathing vapors,
mist, fume or dust. Do not swallow, may be aspirated into lungs. Wear
protective equipment and/or garments described in Section C if exposure
conditions warrant. Wash thoroughly after handling. Launder
contaminated clothing before reuse. Use with adequate ventilation.
Keep out of water sources and sewars. Keep away from heat, sparks and
flame. Store in well-ventilated area. Store in tightly closed container.
Bond and ground during transfer.
E. Reactivity Data
Stability: Stable
Conditions to Avoid: Not Applicable
Incompatibility (Materials to Avoid): Oxygen and strong oxidizing agents
Hazardous Polymerization: Will Not Occur
Conditions to Avoid:
Not Applicable
Hazardous Decomposition Products: Carbon oxides formed when burned.
F. Health Hazard Data
Recommended Exposure Limits:
The Company recommended exposure is 400 ppm.
Acute Effects of Overexposure:
Eye: May be mildly irritating.
Skin: May be mildly irritating. Dermal LD50 is 15.4 g/kg (rabbit).
Inhalation: May cause headache, dizziness, nausea, unconsciousness. The
inhalation LC50 in rats after a four hour
exposure period and a fourteen day post exposure observation
period is greater than 3684 ppm.
Ingestion: May irritate the stomach and intestines. The oral LD50
in rats is greater than 34.6 g/kg (rat). If
swallowed, may be aspirated resulting in inflammation and
possible fluid accumulation in the lungs.
Subchronic and Chronic Effects of Overexposure:
Some isoparaffins have produced kidney damage in male rats only. No
comparable kidney disease is known to occur in humans.
Other Health Effects:
Health Hazard Categories:
Animal Human Animal Human
Known Carcinogen ___ ___ Toxic ___ ___
Suspect Carcinogen ___ ___ Corrosive ___ ___
Mutagen ___ ___ Irritant ___ ___
Teratogen ___ ___ Target Organ Toxin _X_ _X_
Allergic Sensitizer ___ ___ Specify - Lung-Aspiration Hazard
Highly Toxic ___ ___
Canadian WHIMS:
CLASS D: POISONOUS AND INFECTIOUS MATERIAL CATEGORIES
1. Materials Causing Immeddiate and Serious Toxic Effects
A. Very Toxic _____
B. Toxic _____
2. Materials Causing Other Toxic Effects
A. Very Toxic
1. Chronic Toxic Effects _____
2. Teratogen/Embryo Toxin _____
3. Carcinogen _____
4. Reproductive Toxin _____
5. Respiratory Tract Sensitizer _____
6. Mutagen _____
B. Toxic
1. Chronic Toxic Effects _____
2. Skin or Eye Irritant __x__
3. Skin Sensitizer _____
4. Mutagen _____
Specify: Expected to be irritating to the eyes.
Other: Lung-Aspiration Hazard
First Aid and Emergency Procedures:
Eye: Flush eyes with running water for at least fifteen minutes. If
irritation or adverse symptoms develop, seek medical attention.
Skin: Wash skin with soap and water for at least fifteen minutes. If
irritation or adverse symptoms develop, seek medical attention.
Inhalation: Remove from exposure. If breathing is difficult, give oxygen.
If breathing ceases, administer artificial respiration followed
by oxygen. Seek immediate medical attention.
Ingestion: Do not induce vomiting. Seek immediate medical attention.
Note to Physician: Gastric lavage using a cuffed endotracheal tube
may be performed at your discretion.
G. Physical Data
Appearance: Colorless liquid
Odor: Mild
Boiling Point: 325-410F (163-210C)
Vapor Pressure: Not Established
Vapor Density (Air = 1): >3
Solubility in Water: Negligible
Specific Gravity (H2O = 1): 0.754 @ 60/60F (15.6/15.6C)
Percent Volatile by Volume: 100
Evaporation Rate (Butyl Acetate = 1): < 1
Viscosity: 1.12 cSt @ 100F (38C)
Autoignition Temperature: 637F (336C)
H. Fire and Explosion Data
Flash Point (Method Used): 106F (41C) (TCC, ASTM D56)
Flammable Limits (% by Volume in Air): LEL - Not Established
UEL - Not Established
Fire Extinguishing Media: Dry chemical, foam or carbon
dioxide (CO2)
Special Fire Fighting Procedures: Evacuate area of all unnecessary
personnel. Use NIOSH approved
self-contained breathing apparatus and
other protective equipment and/or
garments described in Section C if
exposure conditions warrant. Shut off
source if possible. Water fog or
spray may be used to cool exposed
containers and equipment. Do not
spray water directly on fire - product
will float and could be reignited on
surface of water.
Fire and Explosion Hazards: Carbon oxides formed when burned.
Highly flammable vapors which are
heavier than air may accumulate in low
areas and/or spread along ground away
from handling site. Flash back along
vapor trail is possible.
I. Spill, Leak and Disposal Procedures
Precautions Required if Material is Released or Spilled:
Evacuate area of all unnecessary personnel. Wear protective equipment
and/or garments described in Section C if exposure conditions warrant.
Shut off source, if possible and contain spill. Protect from ignition.
Keep out of water sources and sewers. Absorb in a dry, inert material
(sand, clay, etc). Transfer to disposal drums using non-sparking
equipment.
Waste Disposal (Insure Conformity with all Applicable Disposal Regulations):
Incinerate or place in permitted waste management facility.
J. DOT Transportation
Shipping Name: Hydrocarbons, liquid, n.o.s.
Hazard Class: 3
ID Number: UN3295
Packing Group: III
Marking: Hydrocarbons, liquid, n.o.s., UN3295
Label: Flammable liquid
Placard: Flammable/3295
Hazardous Substance/RQ: Not Applicable
Shipping Description: Hydrocarbons, liquid, n.o.s., 3, UN3295, III
Packaging References: 49 CFR 173.150, 173.203, 173.241
K. RCRA Classification - Unadulterated Product
as a Waste
Ignitable (D001)
Prior to disposal, consult your Environmental contact to determine
if TCLP (Toxicity Characteristic Leaching Procedure, EPA Test Method
1311) is required. Reference 40 CFR Part 261.
L. Protection Required for Work on Contaminated
Equipment
Contact immediate supervisor for specific instructions before work
is initiated. Wear protective equipment and/or garments described
in Section C if exposure conditions warrant.
M. Hazard Classification
_X_ This product meets the following hazard definition(s) as defined by
the Occupational Safety and Health Hazard Communication Standard (29
CFR Section 1910.1200):
___ Combustible Liquid ___ Flammable Aerosol ___ Oxidizer
___ Compressed Gas ___ Explosive ___ Pyrophoric
___ Flammable Gas _X_ Health Hazard (Section F) ___ Unstable
___ Flammable Liquid ___ Organic Peroxide ___ Water Reactive
___ Flammable Solid
___ Based on information presently available, this product does not meet
any of the hazard definitions of 29 CFR Section 1910.1200.
Canadian WHIMS:
Class B-Flammable and Combustible Material
Class D-Poisonous and Infectious Material
Division 2. Materials Causing Other Toxic Effects
N. Additional Comments
REVISION STATEMENT:
This revision updates Section H.
SARA 313
As of the preparation date, this product did not contain a chemical or
chemicals subject to the reporting requirements of Section 313 of Title
III of the Superfund Amendments and Reauthorization Act of 1986 and 40
CFR Part 372.
NFPA 704 Hazard Codes - - - - - - - - Signals
Least - 0
Health : 1 Slight - 1
Flammability: 2 Moderate - 2
Reactivity : 0 High - 3
Special Haz.: - Extreme - 4
Chevron Phillips Chemical Company LP believes that the information contained herein (including data and statements) is accurate as of the date hereof. NO WARRANTY OF
MERCHANTABILITY, FITNESS FOR ANY PARTICULAR PURPOSE OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED, IS MADE AS CONCERNS THE
INFORMATION HEREIN PROVIDED. The information provided herein relates only to the specific product designated and may not be valid where such product is used in
combination with any other materials or in any process. Further, since the conditions and methods of use of the product and information referred to herein are beyond the control of
Chevron Phillips, Chevron Phillips expressly disclaims any and all liability as to any results obtained or arising from any use of the product or such information. No statement
made herein shall be construed as a permission or recommendation for the use of any product in a manner that might infringe existing patents.
|