Sandell Manufacturing Company, Inc.
Sandell
www.sandellmfg.com e-mail: moreinfo@sandellmfg.com
Sando-Seal Flashing
CORPORATE OFFICE BRANCH OFFICE
310 Wayto Rd. 鈥? Schenectady, NY 12303 1700 Vanderbilt Rd. 鈥? Birmingham, AL 35234
Phone: (518) 357-9757 Phone: (205) 263-1030
MATERIAL SAFETY DATA SHEET
1 (800) 283-3888 鈥? Fax: (518) 357-9636 1 (877) SANDELL 鈥? Fax: (205) 263-1033
SECTION 1 SECTION 4 Waste Disposal: Dispose of according to local,
state and federal regulations.
MATERIAL IDENTIFICATION REACTIVITY HAZARD DATA
INFORMATION Handling Procedures and Equipment: Avoid
Chemical Stability: Stable
contact with skin. Clean fingernails and wash
Trade Names and Synonyms: Rubberized Conditions to Avoid: Avoid contact with strong
hands with soap and water after handling. Avoid
asphalt membrane with polyoletin film or fabric. oxidizing materials or basic compounds.
rubbing eyes while handling product. Do not
This sheet is applicable to: CCW-701, Incompatibility (Materials to Avoid): Strong take internally. Avoid removing release paper
all configurations, CCW-705, CCW-705R, Oxidizers. where spark may ignite flammable vapors.
CCW-707, CCW-711, all configurations,
Hazardous Decomposition Products: Thermal FOR PROFESSIONAL USE ONLY, KEEP OUT
CCW-711N.
decomposition products include CO and CO2. OF REACH OF CHILDREN!
Chemical Family: Mixture
Hazardous Polymerization: Will not occur
Product Use: Waterproofing
SECTION 7
Hazardous Ingredients: Asphalt, Aromatic
FIRST AID MEASURES
SECTION 5
Oil, and Solvent Extract
TOXICOLOGICAL PROPERTIES Eye Contact: Immediately flush with plenty of
water for at least 15 minutes. Call a physician.
Route of Entry: Skin contact, skin absorption,
SECTION 2 eye contact, inhalation, ingestion. Skin Contact: Wash promptly with soap and
PHYSICAL/CHEMICAL water. Remove all material under fingernails.
Effects of Acute Exposure to Product: May
CHARACTERISTICS See a physician if irritation develops.
cause eye irritation if oil residue on hands is
Physical State: Solid wiped or rubbed into the eyes. Inhalation: No known adverse effects. Due to
the physical nature of this product, inhalation is
Vapor Density: N/A Effects of Chronic Exposure: Repeated or
unlikely.
prolonged contact with oil in this product may
Specific Gravity: 1.05
cause skin irritation. Ingestion: As this product is a solid, ingestion
Boiling Point: N/A
is unlikely. Should ingestion occur, contact a
Irritancy of Product: May irritate skin, eyes,
Coef. Water/Oil Dist.: N/A physician.
and respiratory tract.
Freezing Point: N/A
Volatiles BvW t(%): N/A
SECTION 6
pH: N/A PREVENTIVE MEASURES
Corrosivity: N/A Personal Protective Equipment:
Evaporation Rate: N/A Gloves: Rubber gloves and/or the use of
Solubility in Water: Insoluble barrier creams to minimize skin exposure are
recommended.
Appearance and Odor: Black adhesive sheet
with slight petroleum odor. Respirator: Provide adequate ventilation in
confined areas or respirators if material is
heated.
SECTION 3
Other: Source of clean water should be
FIRE AND EXPLOSION HAZARD DATA available in the work area for flushing eyes and
Flammability: Yes skin.
Upper Flammable Limit: (% by Vol.) Engineering Controls (EG.Ventilation Enclosed
Process): Provide local exhaust or mechanical
Sensitivity to Impact: None
exhaust if required to maintain concentration of
Extinguishing Media: CO2, Foam, Dry vapors below 100 ppm.
Chemical
Leak or Spill Procedures: In the event material
Special Fire Fighting Procedures: Wear is released or spilled, peel off material and
NIOSHMSHA approved respirators, or self- dispose of properly.
contained breathing apparatus.
Unusual Fire and Explosion Hazards: None
|