Sartomer Company
Material Safety Data Sheet
Product: SR511 Revised Date: 07-28-2005
MSDS ID: S-000300 Replaces Date: 01-17-2005
01. GENERAL INFORMATION
Sartomer Company, Inc.
Oaklands Corporate Center
502 Thomas Jones Way
Exton, Pennsylvania 19341
Emergency phone numbers:
800/424-9300 (CHEMTREC)
610/692-8401 (Sartomer Co., Inc.)
Product information:
610/363-4100
GENERIC NAME
2-Hydroxyethyl Ethylene Urea Solution
DOT PROPER SHIPPING NAME UN/NA NUMBER
N/AP N/AP
DOT HAZARD CLASS
Not regulated
02. SUMMARY OF HAZARDS
CAUTION
PHYSICAL HAZARDS: No physical hazards expected based on available data
ACUTE HEALTH EFFECTS: Slight to moderate eye irritant
(SHORT-TERM) Not a skin irritation hazard based on available data
Not expected to be an inhalation hazard
Not an ingestion hazard based on available data
Not a skin absorption hazard based on available data
CHRONIC HEALTH EFFECTS: An Ames assay for hydroxyethyl ethylene urea was
(LONG-TERM) negative indicating no mutagenic potential. No
other appropriate human or animal health effects
data are known to exist.
03. COMPONENTS
COMPONENT NAME CAS NUMBER % COMPOSITION (BY WT.)
Hydroxyethyl Ethylene Urea 3699-54-5 AP 75
Water 7732-18-5 AP 25
04. PHYSICAL AND CHEMICAL DATA
BOILING POINT pH
113C/123F AP 8.0
FREEZING POINT DRY POINT
-54C/-65F (Pour Point) N/AP
SPECIFIC GRAVITY (H20=1 AT 39.2F) VOLATILE CHARACTERISTICS
Date Printed: 08-05-2005 Page: 1 of 5
Sartomer Company
Material Safety Data Sheet
Product: SR511 Revised Date: 07-28-2005
MSDS ID: S-000300 Replaces Date: 01-17-2005
AP 1.19 at 20C/68F AP 25% by weight
VISCOSITY UNITS, TEMP. (Brookfield) SOLUBILITY IN WATER
AP 25 cps at 20C/68F Complete at 20C/68F
VAPOR PRESSURE STABILITY
9.782mm Hg at 20C/68F Stable
VAPOR DENSITY (AIR=1 AT 60 - 90F) HAZARDOUS POLYMERIZATION
1.76 Not expected to occur
APPEARANCE AND ODOR
Clear, colorless liquid with mild odor
CONDITIONS AND MATERIALS TO AVOID
Strong acids and bases
HAZARDOUS DECOMPOSITION PRODUCTS
Acrid smoke-fumes/carbon monoxide/carbon dioxide/nitrogen oxides and perhaps
other toxic vapors may be released during a fire involving this product.
05. OCCUPATIONAL EXPOSURE LIMITS
SUBSTANCE SOURCE DATE TYPE VALUE TIME
A PEL or TLV has not been established
06. FIRE AND EXPLOSION
FLASH POINT METHOD AUTOIGNITION TEMP. METHOD=
N/AP (Aqueous solution) N/DA
FLAMMABLE LIMITS (% VOLUME IN AIR)
LOWER: N/DA UPPER: N/DA
FIRE AND EXPLOSION HAZARDS
Non flammable (contains water). However, after water evaporates, remaining
material will burn.
EXTINGUISHING MEDIA
Dry chemical
CO2
Water spray
Foam
Water fog
SPECIAL FIREFIGHTING PROCEDURES
Do not enter fire area without proper protection. See Section 4 on
decomposition products possible. Fight fire from safe distance/protected
location. Heat/impurities may increase temperature/build pressure/rupture
closed containers, spreading fire, increasing rsik of burns/injuries. Use
water spray/fog for cooling. Notify authorites if liquid enters sewer/
public waters.
Date Printed: 08-05-2005 Page: 2 of 5
Sartomer Company
Material Safety Data Sheet
Product: SR511 Revised Date: 07-28-2005
MSDS ID: S-000300 Replaces Date: 01-17-2005
07. HEALTH HAZARDS
ROUTES OF EXPOSURE
INHALATION
No significant signs or symptoms indicative of any adverse health hazard are
expected to occur as a result of inhalation exposure.
EYE CONTACT -- PRIMARY ROUTE
May cause slight to moderate irritation with symptoms including burning
sensation, tearing, redness or swelling.
SKIN ABSORPTION
No significant signs or symptoms indicative of any adverse health effects
are expected to occur as a result of skin absorption.
SKIN IRRITATION -- PRIMARY ROUTE
No significant signs or symptoms indicative of any adverse health effects
are expected to occur as a result of skin exposure.
Prolonged skin contact may produce slight localized redness and discomfort.
INGESTION
No significant signs or symptoms indicative of any adverse health hazard are
expected to occur as a result of ingestion.
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE
No additional medical information found.
08. PROTECTIVE EQUIPMENT / CONTROL MEASURES
RESPIRATORY PROTECTION
No special respiratory protection equipment is recommended under anticipated
conditions of normal use with adequate ventilation.
EYE PROTECTION
Eye protection such as chemical splash goggles and/or face shield must be
worn when possibility exists for eye contact due to splashing or spraying
liquid, airborne particles, or vapor. Contact lenses should not be worn.
SKIN PROTECTION
Even though not indicated to be a specific skin hazard, hand, arm, foot and
face protection should be worn when possibility exists for skin contact.
ENGINEERING CONTROLS
No special ventilation is usually required beyond that needed for normal
comfort control.
OTHER HYGIENIC PRACTICES
Emergency eye wash fountains and safety showers should be available in the
immediate vicinity of any potential exposure.
09. EMERGENCY AND FIRST AID
Date Printed: 08-05-2005 Page: 3 of 5
Sartomer Company
Material Safety Data Sheet
Product: SR511 Revised Date: 07-28-2005
MSDS ID: S-000300 Replaces Date: 01-17-2005
INHALATION
Not expected to present a significant inhalation hazard under anticipated
conditions of normal use.
EYE CONTACT
In case of eye contact, immediately rinse with clean water for 20-30
minutes. Retract eyelids often. Obtain emergency medical attention.
SKIN CONTACT
Wash thoroughly with soap and water.
INGESTION
Ingestion unlikely. However, if ingested, obtain emergency medical
attention.
EMERGENCY MEDICAL TREATMENT PROCEDURES
If pain, blinking, tears, or redness continue, patient should contact
ophthalmologist.
10. SPILL AND DISPOSAL
PRECAUTIONS IF MATERIAL IS SPILLED OR RELEASED
May contaminate water supplies. Prevent flow to sewers/public waters.
Impound/recover large land spill; soak up small spill. On water, contain/
minimize dispersion/collect. Report per regulatory requirements.
WASTE DISPOSAL METHODS
When discarded in its purchased form, this product is not a RCRA hazardous
waste. However, it is the responsibility of the generator to determine at
the time of disposal whether the product meets the criteria of a hazardous
waste. Comply with all applicable federal, state and local regulations.
Waste disposal options include landfilling solids at permitted sites. Use
registered transporters.
11. ADDITIONAL PRECAUTIONS
HANDLING AND STORAGE PROCEDURES
Keep container closed when not in use. Wear appropriate protective
equipment. Wash thoroughly after handling.
DECONTAMINATION PROCEDURES
Follow standard plant procedures or supervisor's instructions for
decontamination operations.
12. LABEL INFORMATION
USE STATEMENT
FOR INDUSTRIAL USE ONLY
SIGNAL WORD
CAUTION
HEALTH HAZARDS
MAY CAUSE EYE IRRITATION
Date Printed: 08-05-2005 Page: 4 of 5
Sartomer Company
Material Safety Data Sheet
Product: SR511 Revised Date: 07-28-2005
MSDS ID: S-000300 Replaces Date: 01-17-2005
PRECAUTIONARY MEASURES
AVOID CONTACT WITH EYES.
AVOID PROLONGED OR REPEATED CONTACT WITH SKIN.
WASH THOROUGHLY AFTER HANDLING.
BEFORE USING PRODUCT, READ MATERIAL SAFETY DATA SHEET (MSDS).
13. SUPPLEMENT
NPCA HMIS RATING
Health 1
Flammability 0
Reactivity 1
Personal protection D
REGULATORY INFORMATION
TSCA STATUS
TSCA status: All components of this product are listed, or excluded from
listing, on the United States Environmental Protection Agency Toxic Substances
Control Act (TSCA) inventory.
INTERNATIONAL INVENTORY STATUS:
Australia (AICS): included on inventory
Canada (DSL): included on NDSL
China (IECSC): included on inventory
Europe(EINECS): included on inventory
Japan (ENCS): included on inventory
Philippines (PICCS): included on inventory
Korea (ECL): not included on inventory
*Note - qualifiers and codes used in this MSDS
EQ = Equal; AP = Approximately; LT = Less Than; GT = Greater Than;
TR = Trace; UK = Unknown; N/AP = Not Applicable; N/P = No Applicable
Information Found; N/DA = No Data Available
14. DISCLAIMERS
Some of the information presented and conclusions drawn herein are from
sources other than direct test data on the product itself. The information in
this MSDS was obtained from sources which we believe are reliable. However,
the information is provided without any warranty, express or implied,
regarding its correctness. The conditions or methods of handling, storage, use
and disposal of the product are beyond our control and may be beyond our
knowledge. For this and other reasons, we do not assume responsibility and
expressly disclaim liability for loss, damage or expense arising out of or in
any way connected with the handling, storage, use or disposal of the product.
This MSDS was prepared and is to be used only for this product. If the
product is used as a component in another product, this MSDS information may
not be applicable. This MSDS has been prepared in accordance with the
requirements of the OSHA Hazard Communication Standard (29 CFR 1910.1200).
Date Printed: 08-05-2005 Page: 5 of 5
|