庐
Product Data Sheet
Shot
Introduction
Shot are tear-dropped shaped pieces of metal that
are typcially used to weigh quantities of other alloys.
Examples include: 铿乴ling vapor deposition crucibles or
铿乴ling anode baskets with indium for electroplating.
The typical diameter of the body is approximately 1/8鈥?
(3.175mm) and the length of the tail can vary depending
on various parameters, such as the surface tension of the
alloy.
Alloys/Materials
Shot are available in most alloys.
Packaging
Technical Support
Shot are typically packaged in jars according to weight and
Indium Corporation鈥檚 internationally experienced engineers
back铿乴led with argon. Custom packaging is available.
provide in-depth technical assistance to our customers.
Thoroughly knowledgeable in all facets of Material Science
Storage and Handling
as it applies to the electronics and semiconductor sectors,
Shot should be stored in a dry environment at or below
Technical Support Engineers provide expert advice in solder
room temperature. A nitrogen dry box is ideal. Once
properties, alloy compatibility and selection of solder
opened, containers should be purged with argon and closed
preforms, wire, ribbon and paste. Indium Corporation鈥檚
tightly before returning to storage.
Technical Support engineers provide Rapid Response to all
technical inquiries, usually within 24 hours.
Material Safety Data Sheet
The MSDS for this product can be found online at
http://www.indium.com/techlibrary/msds.php
This product data sheet is provided for general information only. It is not intended, described which are sold subject exclusively to written warranties and limitations
and shall not be construed, to warrant or guarantee the performance of the products thereon included in product packaging and invoices.
Form No. 97857 R0
|