MATERIAL SAFETY DATA SHEET
Sikagard 701 W VOC
HMIS
HEALTH 2
FLAMMABILITY 1
REACTIVITY 0
D
PERSONAL PROTECTION
1. Product And Company Identification
Supplier Manufacturer
Sika Corporation Goldschmidt Chemical Corporation
201 Polito Ave 914 East Randolph Road
Lyndhurst, NJ 07071 Hopewell, VA 23860
Company Contact: EHS Department
Telephone Number: 201-933-8800 Telephone Number: 800 -732-5616
FAX Number: 201-933-9379
Web Site: www.sikausa.com
Supplier Emergency Contacts & Phone Number Manufacturer Emergency Contacts & Phone Number
CHEMTREC: 800-424-9300 CHEMTREC: 800-424-9300
INTERNATIONAL: 703-527-3887
Issue Date: 05/11/2006
Product Name: Sikagard 701 W VOC
CAS Number: Not Established
Chemical Family: Emulsion of Silane/Siloxane
MSDS Number: 3904
2. Composition/Information On Ingredients
Ingredient CAS Percent Of
Name Number Total Weight
9-OCTADECENOIC ACID (9Z) 112-80-1 0.08
MAGNESIUM NITRATE 10377-60-3 0.0028 - 0.004
METHYL CHLORIDE 74-87-3 < 0.0003
NITRIC ACID, COPPER(2+) SALT, TRIHYDRATE 10031-43-3 <= 0.0003
SILANE, TRIETHOXYOCTYL 2943-75-1 5 - 15
3. Hazards Identification
Eye Hazards
Causes eye irritation.
Skin Hazards
May causes skin irritation.
Ingestion Hazards
May be harmful if swallowed.
Page 1 of 5
MATERIAL SAFETY DATA SHEET
Sikagard 701 W VOC
3. Hazards Identification - Continued
Inhalation Hazards
May cause respiratory tract irritation.
4. First Aid Measures
Eye
In case of contact, hold eyelids apart and immediately flush eyes with plenty of tepid water for at least 15 minutes.
Get medical attention immediately if irritation develops and persists.
Skin
In case of contact, immediately flush skin with soap and plenty of tepid water for at least 15 minutes. Get medical
attention immediately if irritation (redness, rash, blistering) develops and persists.
Ingestion
If swallowed, do not induce vomiting unless directed to do so by medical personnel.
Inhalation
Remove to fresh air. If not breathing, give artificial respiration, seek medical attention.
5. Fire Fighting Measures
Flash Point: >212 掳F
Fire And Explosion Hazards
During a fire, irritating and/or toxic gases and aerosols from the decomposition/combustion products may be
present.
Extinguishing Media
In case of fire, use water spray (fog) foam, dry chemical, or CO2.
Fire Fighting Instructions
In the event of a fire, firefighters should wear full protective clothing and NIOSH-approved self-contained
breathing apparatus with a full facepiece operated in the pressure demand or other positive pressure mode.
6. Accidental Release Measures
Avoid release to the environment. Use appropriate Personal Protective Equipment (PPE). Contain spill and collect with
absorbent material and transfer into suitable containers. Do not flush to sewer or allow to enter waterways. Ventilate
enclosed area.
7. Handling And Storage
Handling And Storage Precautions
Keep out of reach of children. Store in a cool, dry, well ventilated area. Keep containers tightly closed.
Storage Precautions
Keep away from heat, sparks, flame, and other sources of ignition (i.e., pilot lights, electric motors and static
electricity). Do not smoke.
Cool endangered containers by water spray. Protect from frost.
Work/Hygienic Practices
No smoking, eating or drinking allowed while using this product. Wash thoroughly with soap and water after
handling.
8. Exposure Controls/Personal Protection
Engineering Controls
Use of a system of local and/or general exhaust is recommended to keep employee below applicable exposure
limits. Refer to the current edition of "Industrial Ventilation: A Manual of Recommended Practice" published by
Page 2 of 5
MATERIAL SAFETY DATA SHEET
Sikagard 701 W VOC
8. Exposure Controls/Personal Protection - Continued
Engineering Controls - Continued
the American Conference of Governmental Industrial Hygienists for information on the design, installation, use,
and maintenance of exhaust systems.
Eye/Face Protection
Safety glasses with side shields or goggles.
Skin Protection
Chemical-resistant (PVC) gloves. Lab coat or other work clothing to prevent skin exposure (Long sleeve shirt
and long pants). Launder before reuse.
Respiratory Protection
A respirator protection program that meets 29 CFR 1910.134 requirement must be followed whenever workplace
conditions warrant a respirator's use. In areas where the Permissible Exposure Limits are exceeded, use a
properly fitted NIOSH-approved respirator.
Ingredient(s) - Exposure Limits
METHYL CHLORIDE
ACGIH TLV-STEL 100 ppm (Skin)
ACGIH TLV-TWA 50 ppm (Skin)
OSHA PEL-CEILING 200 ppm
OSHA PEL-PEAK 300 ppm
OSHA PEL-TWA 100 ppm
9. Physical And Chemical Properties
Appearance
White liquid
Odor
Slight
Chemical Type: Mixture
Physical State: Liquid
Specific Gravity: 0.98 g/cm3 at 77F Method: DIN 51757
Packing Density: 8.16 Lb/gallon
pH Factor: 7-8
Solubility: Water dispersable at 25C
Viscosity: 5-40 mPas Method: Brookfield
Evaporation Rate: Not Available
VOC Content - 94g/L
10. Stability And Reactivity
Stability: STABLE
Hazardous Polymerization: WILL NOT OCCUR
Conditions To Avoid (Stability)
None known
Hazardous Decomposition Products
Ethanol
11. Toxicological Information
No Data Available...
Page 3 of 5
MATERIAL SAFETY DATA SHEET
Sikagard 701 W VOC
11. Toxicological Information - Continued
Ingredient(s) - Carginogenicity
METHYL CHLORIDE
Listed In The IARC Monographs
12. Ecological Information
No Data Available...
13. Disposal Considerations
Dispose in accordance with applicable federal, state and local government regulations. Waste generators must
determine whether a discarded material is classified as a hazardous waste. USEPA guidelines for the classification
determination are listed in 40 CFR Parts 261.3. Additionally, waste generators must consult state and local hazardous
waste regulations to ensure complete and accurate classification.
14. Transport Information
Proper Shipping Name
Not Regulated by the US DOT
15. Regulatory Information
U.S. Regulatory Information
All ingredients of this product are listed or are excluded from listing under the U.S. Toxic Substances Control Act
(TSCA) Chemical Substance Inventory.
SARA Hazard Classes
Acute Health Hazard
SARA Title III - Section 313 Supplier Notification
This product contains the following toxic chemicals that are subject to the reporting requirements of section 313 of
the Emergency Planning and Community Right-To-Know Act (EPCRA) of 1986 and of 40 CFR 372.
METHYL CHLORIDE (74-87-3) <0.0003 %
This information must be included on all MSDSs that are copied and distributed for this material.
Ingredient(s) - U.S. Regulatory Information
METHYL CHLORIDE
SARA Title III - Section 313 Form "R"/TRI Reportable Chemical
OSHA Process Safety Management - 1910.119 App A Hazardous Chemical
SARA - Acute Health Hazard
SARA - Chronic Health Hazard
SARA - Fire Hazard
SARA - Sudden Release Of Pressure Hazard
Ingredient(s) - State Regulations
MAGNESIUM NITRATE
New Jersey - Workplace Hazard
Pennsylvania - Workplace Hazard
Massachusetts - Hazardous Substance
New York City - Hazardous Substance
METHYL CHLORIDE
New Jersey - Workplace Hazard
New Jersey - Environmental Hazard
New Jersey - Special Hazard
Page 4 of 5
MATERIAL SAFETY DATA SHEET
Sikagard 701 W VOC
15. Regulatory Information - Continued
Ingredient(s) - State Regulations - Continued
New Jersey - TCPA Extraordinarily Hazardous Substance
Pennsylvania - Workplace Hazard
Pennsylvania - Environmental Hazard
California - Proposition 65
Massachusetts - Hazardous Substance
New York City - Hazardous Substance
16. Other Information
HMIS Rating
H eal th: 2
F i re : 1
Reactivity: 0
PP E: D
Revision/Preparer Information
MSDS Preparer: EHS Department
MSDS Preparer Phone Number: 201-933-8800
Disclaimer
The information contained in this Material Safety Data Sheet applies only to the actual Sika Corporation ("Sika")
product identified and described herein. This information is not intended to address, nor does it address the use
or application of the identified Sika product in combination with any other material, product or process. All of the
information set forth herein is based on technical data regarding the identified product that Sika believes to be
reliable as of the date hereof. Prior to each use of any Sika product, the user must always read and follow the
warnings and instructions on the product's current Technical Data Sheet, product label and Material Safety Data
Sheet for each Sika product, which are available at web site and/or telephone number listed in Section 1 of this
MSDS.
SIKA MAKES NO WARRANTIES EXPRESS OR IMPLIED AND ASSUMES NO LIABILITY ARISING FROM THIS
INFORMATION OR ITS USE. SIKA SHALL NOT BE LIABLE UNDER ANY LEGAL THEORY FOR SPECIAL OR
CONSEQUENTIAL DAMAGES AND SHALL NOT BE RESPONSIBLE FOR THE USE OF THIS PRODUCT IN A
MANNER TO INFRINGE ON ANY PATENT OR ANY OTHER INTELLECTUAL PROPERTY RIGHTS HELD BY
OTHERS.
All sales of Sika products are subject to its current terms and conditions of sale available at www.sikacorp.com or
201-933-8800.
SIKA CORPORATION
Printed Using MSDS Generator鈩? 2000
Page 5 of 5
|