MATERIAL SAFETY DATA SHEET
---------------------------------------- I. PRODUCT IDENTIFICATION -------------------------------------------------
LATAPOXY庐 300 Part C (filler powder) Resin; L-300 Rapid Part C,
TRADE NAME (as labeled):
LATAPOXY庐 300 Non-Sag NS, Super Epoxy 2000 Part C,
2000LT Part C, 2001 Part C
CHEMICAL FAMILY: Silica/Calcium Magnesium Carbonate
Reviewed & Approved By:
LATRICRETE INTERNATIONAL, INC.
MANUFACTURER'S NAME: Steven B. Fine
1 Laticrete Park, N. Steven B. Fine
Sr. Research Chemist/Safety Officer
Bethany, CT 06524-3423 USA
Phone number for additional information: (203) 393-0010
Name of preparer: R. Rooshenas
Date prepared or revised: 01/01/00
-------------------------------------------- II. HAZARDOUS INGREDIENTS -------------------------------------------
OTHER
CHEMICAL NAMES CAS NUMBERS PERCENT ACGIH TLV OSHA PEL (SPECIFY)
Silica Dioxide * 14808-60-7 5 - 95% 0.1 mg/m鲁 0.1 mg/m鲁 N/A
471-34-1 5 - 40% 10 mg/m鲁 5 mg/m鲁 TWA 15
Calcium Carbonate**
mg/m鲁
Stearic Acid 57-11-4 Minor 10 mg/m鲁 N/A N/A
* IARC Monographs on the Evaluation of the Carcinogenic Risk of Chemicals to Humans (vol. 4 concludes that
there is sufficient evidence for the carcinogenicity of crystalline silica to experimental animals, and there is
limited evidence of the carcinogenicity of crystalline silica to humans.
** California Proposition 65 - There are extremely small, but detectable amounts of substances regulated under California's
Safe Drinking Water and Toxic Enforcement Act. Arsenic - less than 2 ppm Beryllium - less than 1 ppm
Cadmium - less than 1 ppm Chromium (VI) - less than 0.1 ppm Lead - 1 ppm Mercury
- less than 1 ppm Nickel - less than 2 ppm Crystalline Silica - less than 0.1%
These levels are "typical" quantities and may change slightly with different lots. the term "less than" indiccates that the
substance was detcted, but the amount was less than the quantifiable limit.
W.H.M.I.S. Code D.2.
N/A = Not applicable or available
---------------------------------------- III. PHYSICAL PROPERTIES ----------------------------------------------
掳
N/A Melting point or range,掳 F: N/A
Vapor density (air=1):
Boiling point or range, 掳 F: N/A
Specific gravity: 2.95
Solubility in water: slight <1% Evaporation rate (butyl acetate = 1): N/A
掳
Vapor pressure, mmHg at 20掳 C: N/A
Appearance and odor: White powder, no odor
HOW TO DETECT THIS SUBSTANCE (warning properties of substance as a gas, vapor, dust, or mist): N/A
-------------------------------------------------------------------------------------------------------------------------------
This information is furnished without warranty, representation, inducement or license of any kind; except that it is accurate to the best of our
knowledge, or obtained from sources believed by us to be accurate.
LATAPOXY庐 300 Part C (filler powder) Resin; L-300 Rapid Part C,LATAPOXY庐 300 Non-Sag NS,
Super Epoxy 2000 Part C,2000LT Part C, 2001 Part C
---------------------------------------------- IV. FIRE AND EXPLOSION ----------------------------------------------------
Flash Point, 掳 F (give method): Non-flammable or combustible
掳
Auto ignition temperature,掳 F: N/A
Flammable limits in air, volume %: N/A Lower (LEL) Upper (UEL)
Fire extinguishing materials: N/A
X X
water spray carbon dioxide other:
X foam X dry chemical
Special fire fighting procedures: N/A
Unusual fire and explosion hazards: None
-------------------------------------- V. HEALTH HAZARD INFORMATION -------------------------------------------
SYMPTOMS OF OVEREXPOSURE for each potential route of exposure.
Inhaled: May cause irritation due to abrasiveness
Contact with skin or eyes: May cause irritation due to abrasiveness
Absorbed through skin: Cannot be absorbed through skin
Swallowed: Ingestion should not cause any significant health problems. If a large amount is ingested and if conscious,
give large quantities of water than induce vomiting. See physician.
-------------------------------------------------------------------------------------------------------------------------------
HEALTH EFFECTS OR RISKS FROM EXPOSURE. Explain in lay terms. Attach extra page if more space is needed:
Acute: Occupational disorder of the respiratory tract due to inhalation of dust particles
Chronic: Same as above
Toxicity Data:
Rat, oral, LD50 : 6450 mg/kg.
Rabbit, skin: 500 mg administered for 24 hrs. produces moderate skin irritation
Rabbit, eye: 750 碌g administered for 24 hrs. produces severe irritation
-------------------------------------------------------------------------------------------------------------------------------
FIRST AID: EMERGENCY PROCEDURES
Eye Contact: Immediately wash the eyes with large amounts of water, occasionally lifting the lower and upper lids, get
medical attention.
Skin Contact: Not a problem
Inhaled: If a person breathes in large amounts, move the exposed person to fresh air at once. If breathing has stopped,
perform artificial respiration. Get medical attention.
Swallowed: Ingestion should not cause any significant health problems. If a large amount is ingested and if conscious,
give large quantities of water and induce vomiting. Call a physician.
-------------------------------------------------------------------------------------------------------------------------------
SUSPECTED CANCER AGENT?
NO: This product's ingredients are not found in the lists below.
X
YES: Federal OSHA NTP IARC
-------------------------------------------------------------------------------------------------------------------------------
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: N/A
LATAPOXY庐 300 Part C (filler powder) Resin; L-300 Rapid Part C,LATAPOXY庐 300 Non-Sag NS,
Super Epoxy 2000 Part C,2000LT Part C, 2001 Part C
----------------------------------------------- VI. REACTIVITY DATA ----------------------------------------------------
X
Stability: Stable Unstable
Conditions to avoid: None
Incompatibility (materials to avoid): Reacts with acid to liberate carbon dioxide gas.
Hazardous decomposition products (including combustion products): Reacts with acid to liberate carbon dioxide gas.
X
Hazardous polymerization: May occur Will not occur
Conditions to avoid: None known
------------------------------- VII. SPILL, LEAK, AND DISPOSAL PROCEDURES -------------------------------------
Spill response procedures (include employee protection measures): Use respiratory protection for airborne dust NIOSH
approved mask for nuisance dust. Shovel into containers with lids.
Preparing wastes for disposal (container types, neutralization, etc.): Dispose in a site suitable for industrial waste. Refer to
any local, state or federal regulations for specific disposal information.
NOTE: Dispose of all wastes in accordance with federal, state and local regulations.
---------------------------------- VIII. SPECIAL HANDLING INFORMATION -----------------------------------------
Ventilation and engineering controls: Provide adequate exhaust ventilation to meet TLV requirements. An exhaust filter
system may be required to avoid environmental contamination.
Respiratory protection (type): If exposure limits are exceeded, a NIOSH approved dust respirator should be used.
Eye protection (type): Safety glasses.
Gloves (specify material): Leather or rubber gloves
Other clothing and equipment: Eye wash station should be available to the area of use.
Work practices, hygienic practices: N/A
Other handling and storage requirements: N/A
Protective measures during maintenance of contaminated equipment: Wear safety glasses, protective gloves, and a
NIOSH approved dust mask.
0300c.doc
|