MATERIAL SAFETY DATA SHEET
---------------------------------------------------------- I. PRODUCT IDENTIFICATION ---------------------------------------------------
TRADE NAME (as labeled): LATICRETE庐 SP100 - Part C; Latapoxy SP-100 Quarry Grade Part C,
922, 924, Spec-L Part C
CHEMICAL FAMILY: Proprietary Blend Reviewed & Approved By:
Steven B. Fine
Steven B. Fine
Sr. Research Chemist/Safety Officer
MANUFACTURER'S NAME:
LATICRETE INTERNATIONAL, INC.
1 Laticrete Park N.
Bethany, CT 06524-3423 USA
Phone number for additional information: (203) 393-0010
Date prepared or revised: 01/11/00 Name of preparer: S. Fine
----------------------------------------------------------- II. HAZARDOUS INGREDIENTS -------------------------------------------------
OTHER
CHEMICAL NAMES CAS NUMBERS PERCENT ACGIH TLV OSHA PEL (SPECIFY)
Silica Sand* 14808-60-7 80 - 90 50 micro g/m鲁 10 mg/m鲁 N/A
Aluminum Oxide 1344-28-1 1-4 10 mg/m鲁 15 mg/m鲁 N/A
Titanium Dioxide 13463-67-1 0 - 12 10 mg/m鲁 15 mg/m鲁 N/A
Copper phthalocyanine+ 147-14-8 0.05 - A N/A N/A N/A
0.05 - B
0.7 - C
1.8 - D
* IARC Monographs on the Evaluation of the Carcinogenic Risk of Chemical to humans (volume 42,1987) concludes
that there is sufficient evidence for the carcinogenicity of crystalline silica to experimental animals, and there is limited
evidence of the carcinogenicity of crystalline silica to humans.
+ This chemical is contained in the following powders. It must be reported under Section 313 of the Emergency
Planning and Community Right-To-Know Act of 1986 and of 40 CFR 372.
A = 774 Diamond Blue - B = Blue Quartz - C = 772 Jade - 776 = Blue Sapphire
W.H.M.I.S. Code D.2
N/A = Not applicable or available
---------------------------------------------------------- III. PHYSICAL PROPERTIES --------------------------------------------------------
Vapor density (air=1): N/A Melting point or range,掳F: N/A
Boiling point or range, 掳F: N/A
Specific gravity: 2-3 g/cc
Solubility in water: N/A Evaporation rate (butyl acetate = 1): N/A
Vapor pressure, mmHg at 20掳C: N/A VOC: 0 lb/gal.
Appearance and odor: odorless free flowing colored powder.
HOW TO DETECT THIS SUBSTANCE (warning properties of substance as a gas, vapor, dust, or mist): N/A
----------------------------------------------------------------------------------------------------------------------------------------
This information is furnished without warranty, representation, inducement or license of any kind; except that it is
accurate to the best of our knowledge, or obtained from sources believed by us to be accurate.
LATICRETE庐 SP100 - Part C; Latapoxy SP-100 Quarry Grade Part C,
922, 924, Spec-L Part C
--------------------------------------------------- IV. FIRE AND EXPLOSION ------------------------------------------------------------
Flash Point, 掳F (give method): None
Auto ignition temperature,掳F: N/A
Flammable limits in air, volume %: Lower (LEL) N/A Upper (UEL) N/A
Fire extinguishing materials:
X water spray X carbon dioxide other:
X foam X dry chemical
Special fire fighting procedures: Wear self-contained breathing apparatus with full face piece and protective clothing.
Unusual fire and explosion hazards: This product may form explosive dust clouds in air.
-------------------------------------------------- V. HEALTH HAZARD INFORMATION ------------------------------------------------
SYMPTOMS OF OVEREXPOSURE for each potential route of exposure.
Inhaled: Symptoms are dyspnea-caused by many lung scars that develop from the dust-pain in chest, decreased vital
capacity and cough. Inhalation of the dust can cause silicosis and may cause lung cancer depending on duration and
level of exposure.
Contact with skin or eyes: May be irritating to the eyes.
Absorbed through skin: N/A
Swallowed: N/A
--------------------------------------------------------------------------------------------------------------------------------------------
HEALTH EFFECTS OR RISKS FROM EXPOSURE. Explain in lay terms. Attach extra page if more space is needed:
Acute: Eye contact may cause eye irritation. Inhalation of dust may cause lung irritation.
Chronic: Inhalation of the dust can cause silicosis and may cause lung cancer depending on duration and level of
exposure.
--------------------------------------------------------------------------------------------------------------------------------------------
FIRST AID: EMERGENCY PROCEDURES
Eye Contact: Flush with water for 15 minutes. Consult with physician.
Skin Contact: If irritation occurs, remove affected clothing and wash the skin exposed.
Inhaled: Remove to fresh area. For extreme respiratory distress, administer oxygen.
Swallowed: Refer to physician.
--------------------------------------------------------------------------------------------------------------------------------------------
SUSPECTED CANCER AGENT?
NO: This product's ingredients are not found in the lists below.
YES: Federal OSHA NTP X IARC
--------------------------------------------------------------------------------------------------------------------------------------------
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: Chronic lung scarring leads to a progressive
massive fibrosis that is often accompanied by increased susceptibility to the risk of impaired health due to a
combination of smoking and dust exposure. Persons with reduced pulmonary function may be at increased
risk.
LATICRETE庐 SP100 - Part C; Latapoxy SP-100 Quarry Grade Part C,
922, 924, Spec-L Part C
------------------------------------------------------------- VI. REACTIVITY DATA ------------------------------------------------------------
Stability: X Stable Unstable
Conditions to avoid: Exposure to hydrofluoric acid or strong alkalis or oxidizers.
Incompatibility (materials to avoid): N/A
Hazardous decomposition products (including combustion products): May release carbon monoxide, carbon dioxide,
nitrogen oxide, ammonia upon combustion.
Hazardous polymerization: May occur X Will not occur
Conditions to avoid: Exposure to strong oxidizers or alkalis
------------------------------------------- VII. SPILL, LEAK, AND DISPOSAL PROCEDURES --------------------------------------
Spill response procedures (include employee protection measures): Clean up with dustless method (use vacuum or wet
sweeping). Wear NIOSH approved dust mask, safety glasses, gloves.
Preparing wastes for disposal (container types, neutralization, etc.): N/A
NOTE: Dispose of all wastes in accordance with federal, state and local regulations.
------------------------------------------- VIII. SPECIAL HANDLING INFORMATION ------------------------------------------------
Ventilation and engineering controls: normal ventilation
Respiratory protection (type): NIOSH approved disposable dust mask if PEL is exceeded
Eye protection (type): safety glasses
Gloves (specify material): cloth or impermeable gloves
Other clothing and equipment: long sleeved clothing
Work practices, hygienic practices: normal good housekeeping
Other handling and storage requirements: keep away from strong alkalis and oxidizers
Protective measures during maintenance of contaminated equipment: Wear NIOSH approved dust mask, safety
glasses, gloves
0100C.DOC
|