24 Madison Road, Fairfield, New Jersey 07004, USA
Tel: 800-771-JEEN (5336), Tel: 973-439-1401, Fax: 973-439-1402,
email: info@jeen.com , Website: www.jeen.com
MATERIAL SAFETY DATA SHEET
SECTION I - MATERIAL AND MANUFACTURER IDENTIFICATION
Manufacturer's Name: Chemtrec Emergency Telephone No.: 800-424-9300
JEEN International Corp. *Chemtrec International Telephone No.: 703-527-3887
24 Madison Road *(Collect Calls Accepted)
Fairfield, NJ 07004 Latest Revision Date: 3/08/2006
Telephone # 439-1401
Product Name: JEEMIDE SAF
Chemical Name: Sunfloweramide, MEA
INCI/CTFA: None
CAS#: 69227-24-3; 68140-00-1
HMIS HAZARD RATINGS: Health (1) Fire (0) Reactivity (0)
4= EXTREME; 3= HIGH; 2= MODERATE; 1= SLIGHT; 0= INSIGNIFICANT
SECTION II - HAZARDOUS INGREDIENTS
INGREDIENTS CAS# Wt %
Sunflower Alkanolamide 69227-24-3 50-60
Coconut Monoethanolamide 68140-00-1 40-50
THIS MATERIAL IS FOR INDUSTRIAL USE ONLY, NOT FOR FOOD, MEDICAL OR DRUG USE.
SECTION III 鈥? HAZARDS IDENTIFICATION
Good manufacturing practices are always recommended when handling any chemical.
Eye: Irritation may result. May cause redness, irritation.
Skin: Contact may cause irritation, inflammation, irritation on prolonged contact.
Inhalation: No health effects are known.
Oral: No health effects are known.
Repeated exposure effects:
Eyes: May cause redness, irritation.
Skin: Skin irritation and inflammation may occur.
SECTION IV - FIRST AID MEASURES
Eyes: Immediately flush with warm running water for at least 15 minutes, holding eyelids open during flushing. If irritation
persists, repeat flushing and obtain medical attention immediately.
Skin: Remove contaminated clothing. Immediately flush exposed area with large amounts of warm running water for at
least ten (10) minutes. If irritation persists or if contact has been prolonged, obtain medical attention.
Inhalation: Not an expected route of exposure. If respiratory irritation or distress occurs remove victim to fresh air. Seek
medical attention if respiratory irritation or distress continues.
Oral: Never give anything by mouth to an unconscious person. Obtain medical attention.
Comments: Treat symptomatically.
SECTION V -FIRE FIGHTING MEASURES
Auto-ignition Temperature: No available.
Flammability: Non-Flammable
Extinguishing Media: Dry chemical; foam or carbon dioxide, water fog.
Fire Fighting Procedures: Do not direct a sold stream of water of foam into hot, burning pools; this may cause
frothing and increase fire intensity. Use self-contained breathing apparatus and body-
covering protective clothing.
Hazardous Decomposition Products: Oxides of carbon.
Page No. 1 of 3 - MSDS - JEEMIDE SAF
24 Madison Road, Fairfield, New Jersey 07004, USA
Tel: 800-771-JEEN (5336), Tel: 973-439-1401, Fax: 973-439-1402,
email: info@jeen.com , Website: www.jeen.com
Page No. 2 of 3 - MSDS - JEEMIDE SAF
SECTION VI - Accidental Release Measures
Containment/Clean up: Sections 13 and 15 of this Material Safety Data Sheet provide information regarding certain Federal,
and local requirements. Leak and spill procedures. Evacuate area. Shut off all sources of ignition.
Ventilate area. Collect for disposal. Clean up remaining materials from spill with suitable absorbent.
For large spills provide diking or other appropriate containment to keep material from spreading. If diked
material can pumped, store recovered material in steel drums for recovery or disposal. Clean area as
appropriate since some silicone material, even in small quantities, may present a slip hazard. Final
cleaning may require steam, solvents or detergents. Observe all personal protection equipment
recommendations described in Section 5 and 8 of this MSDS. Observe all Federal, Provincial and local
regulations that may apply to the clean up of this material.
SECTION VII - HANDLING AND STORAGE
Handling (Personnel): DO NOT FREEZE. Follow routine safe handling procedures. Ground and bond equipment and containers
to prevent a static charge buildup. Use spark resistant tools. Safety Glasses and PVC Gloves.
Storage: Store above 5掳C. Keep container tightly closed. Do not use containers made of Carbon Steel.
SECTION VIII- EXPOSURE CONTROLS/PERSONAL PROTECTION
Engineering Controls: Local Exhaust: Required
General Ventilation: Required
Personal Protective Equipment for Routine Handling:
Eyes: Use chemical safety glasses.
Skin: Rubber gloves. Impermeable apron and coveralls as appropriate. Washing at mealtime and end of shift.
Inhalation: Not required.
Suitable Respirator: Not required.
Other: An eyewash and safety shower should be nearby and ready for use.
Personal Protective Equipment for Spills
Eyes: Use proper protection 鈥? rubber gloves and chemical safety glasses as a minimum.
Skin: Rubber gloves. Impermeable apron and coveralls as appropriate.
Inhalation/Suitable Respirator; NIOSH/MSHA approved respirator for concentrations exceeding TLV.
Precautionary Measures: Avoid eye contact and inhalation.
WARNING
Wash thoroughly after handling.
Combustible. Keep away from heat and flame.
Note: These precautions are for room temperature handling. Use at elevated temperatures or aerosol spray applications may
require added precautions.
SECTION IX - PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Soft Solid Viscosity: Not available
Color: Yellow Melting Point: Not determined
Odor: Slight Boiling Point: Not available
Specific Gravity @ 25掳C: Not applicable Vapor Pressure @ 25掳C: Not determined
Solubility in Water: Insoluble
SECTION X - Stability and Reactivity
Chemical Stability: Stable.
Hazardous Polymerization: Will not occur.
Incompatibility with other substances: Strong mineral acids
Materials to Avoid: Heat, open flame, sparks.
24 Madison Road, Fairfield, New Jersey 07004, USA
Tel: 800-771-JEEN (5336), Tel: 973-439-1401, Fax: 973-439-1402,
email: info@jeen.com , Website: www.jeen.com
Page No. 3 of 3 - MSDS - JEEMIDE SAF
SECTION XI - TOXICOLOGICAL INFORMATION
Optional Section 鈥? Complete information not yet available.
SECTION XII - ECOLOGICAL INFORMATION
Optional Section 鈥? Complete information not yet available.
SECTION XIII - DISPOSAL CONSIDERATIONS
Landfill and/or incineration where permitted under Federal, Provincial or local laws. Observe all local, Provincial and Federal waste
management regulations.
SECTION XIV 鈥? TRANSPORTATION INFORMATION
Shipping Name: Non Dangerous
Technical Name: Not applicable
Primary Class: Not applicable
Subsidiary Risk: Not applicable
SECTION XV - REGULATORY INFORMATION
This product has been classified in accordance with the hazard criteria of the CPR, and this MSDS contains all the information required
by the CPR.
DSL: All ingredients are on the inventory.
TSCA: All ingredients are on the inventory.
WHMIS Classification: Not controlled.
SECTION XVI 鈥? OTHER INFORMATION
The data in this MSDS related only to the specific material designated herein and does not relate to use in combination with any other
material or in any process. This data is offered in good faith as typical values and not as product specifications. No warranty, either
expressed or implied, is hereby made. The recommended industrial hygiene and safe handling procedures are believed to be generally
applicable. However, each user should review these recommendations in the specific context of the intended use and determine
whether they are appropriate.
|