MATERIAL SAFETY DATA SHEET
-------------------------------------------- I. PRODUCT IDENTIFICATION ): ----------------------------------------------------
TRADE NAME (as labeled): LATAPOXY庐 SP100B, 300B, LATAPOXY庐 QG100, 105 Non-Sag,
LATAPOXY 300B Non-Sag
CHEMICAL FAMILY: RESIN
Reviewed & Approved By:
MANUFACTURER'S NAME: LATICRETE INTERNATIONAL, INC. Steven B. Fine
1 Laticrete Park, N. Steven B. Fine
Bethany, CT 06524-3423 USA Sr. Research Chemist/Safety Officer
Phone number for additional information: (203) 393-0010
Date prepared or revised: 01/11/00 Name of preparer: R. Rooshenas
-------------------------------------------- II. HAZARDOUS INGREDIENTS ----------------------------------------------------
OTHER
CHEMICAL NAMES CAS NUMBERS PERCENT ACGIH TLV OSHA PEL (SPECIFY)
Liquid Epoxy Resin 25068-38-6 60 - 80 N/A N/A N/A
Reactive diluent 25068-38-6 0-20 N/A N/A N/A
Polymer of bisphenol A & 054208-638 0-20 N/A N/A N/A
Epichlorohydrin
N/A
Hydrogenated Castor Oil 80017-83 0-5 N/A N/A
W.H.I.M.S. Code D.2
N/A = Not applicable or available
III. PHYSICAL PROPERTIES
Vapor density (air=1): >1 Melting point or range,掳F: N/A
Boiling point or range, 掳F: N/A
Specific gravity: 1.12 @ 20掳C
Solubility in water: None Evaporation rate (butyl acetate = 1): N/A
Vapor pressure, mmHg at 20掳C: N/A VOC: 0.04 lb/gal.
Appearance and odor: Liquid Slightly Viscose.
HOW TO DETECT THIS SUBSTANCE (warning properties of substance as a gas, vapor, dust, or mist): N/A
This information is furnished without warranty, representation, inducement or license of any kind; except that it is
accurate to the best of our knowledge, or obtained from sources believed by us to be accurate.
LATAPOXY庐 SP100B, 300B, LATAPOXY庐 QG100,105 Non-Sag, LATAPOXY 300B Non-Sag
IV. FIRE AND EXPLOSION
Flash Point, 掳F (give method): 245掳F method used = PMCC
Auto ignition temperature,掳F: N/A
Flammable limits in air, volume %: N/A Lower (LEL) Upper (UEL)
Fire extinguishing materials:
water spray X carbon dioxide other:
X foam X dry chemical
Special fire fighting procedures: Wear positive pressure self contained breathing apparatus
Unusual fire and explosion hazards: None
V. HEALTH HAZARD INFORMATION
SYMPTOMS OF OVEREXPOSURE for each potential route of exposure.
Inhaled: May cause irritation of respiratory tract.
Contact with skin or eyes: Minor transient irritation for eye contact. No corneal injury likely. May cause allergic skin
reaction. Prolonged exposure not likely to cause skin irritation. Skin sensitizer
Absorbed through skin: Not likely to absorb through skin in toxic amount in a single prolonged exposure. LD 50 for skin
absorption for rabbits = 20,000 mg/kg.
Swallowed: Causes gastrointestinal irritation and possible burns if swallowed.
HEALTH EFFECTS OR RISKS FROM EXPOSURE. Explain in lay terms. Attach extra page if more space is needed:
Acute: N/A
Chronic: N/A
FIRST AID: EMERGENCY PROCEDURES
Eye Contact: Irrigation of the eye immediately with water for 15 minutes is good safety practice. Consult medical
personnel. Stain for evidence of corneal injury.
Skin Contact: Contact will probably cause no more than irritation. Wash off in flowing water or shower. Wash clothing
before reuse.
Inhaled: If inhaled, remove to fresh air. If effects occur consult a physician
Swallowed: Do not induce vomiting. Call a physician
SUSPECTED CANCER AGENT?
X NO: This product's ingredients are not found in the lists below.
YES: Federal OSHA NTP IARC
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE: N/A
LATAPOXY庐 SP100B, 300B, LATAPOXY庐 QG100, 105 Non-Sag, LATAPOXY 300B Non-Sag
VI. REACTIVITY DATA
Stability: X Stable Unstable
Conditions to avoid: Excess heating over long periods of time degrades the resin
Incompatibility (materials to avoid): Base
Hazardous decomposition products (including combustion products): Incomplete pyrolosis or combustion results in
phenolics, carbon monoxide, carbon dioxide, and water. Thermal decomposition should be traced as a potentially
hazardous substance.
Hazardous polymerization: May occur X Will not occur
Conditions to avoid: Masses of more than 1 pound of product plus an aliphatic amine will cause irreversible
polymerization with considerable heat build up.
VII. SPILL, LEAK, AND DISPOSAL PROCEDURES
Spill response procedures (include employee protection measures): Soak up in absorbant material or scrape up.
Residual can be removed with hot water and a nonionic surfactant. Wear goggles, rubber gloves, long sleeved clothing.
Preparing wastes for disposal (container types, neutralization, etc.): Burn in adequate incinerator or bury in an approved
landfill.
NOTE: Dispose of all wastes in accordance with federal, state and local regulations.
VIII. SPECIAL HANDLING INFORMATION
Ventilation and engineering controls: Good room ventilation should be adequate for most operations
Respiratory protection (type): None normally needed
Eye protection (type): Chemical splash proof goggles, safety glasses
Gloves (specify material): Rubber or polyethylene gloves
Other clothing and equipment: clean, body-covering clothing
Work practices, hygienic practices: N/A
Other handling and storage requirements: None
Protective measures during maintenance of contaminated equipment: Same as above
0100B.DOC
|