MATERIAL SAFETY DATA SHEET
-------------------------------------------- I. PRODUCT IDENTIFICATION -------------------------------
TRADE NAME (as labeled): LATAPOXY庐 300 Epoxy Adhesive Part B
CHEMICAL FAMILY: Epoxy Resin
MANUFACTURER'S NAME: LATICRETE INTERNATIONAL, INC.
1 Laticrete Park, N. Reviewed & Approved By:
Steven B. Fine
Bethany, CT 06524-3423 USA
Steven B. Fine
Sr. Research Chemist/Safety Officer
Phone number for additional information: (203) 393-0010
Date prepared or revised: 6/04 Name of preparer: S.B. Fine
-------------------------------------------- II. HAZARDOUS INGREDIENTS ----------------------------
OTHER
CHEMICAL NAMES CAS PERCENT ACGIH TLV OSHA PEL (SPECIFY)
NUMBERS
Polymer of Bisphenol 25085-99-8 60-70 N/A N/A N/A
A and
Epichlorohydrin
Alkyl glycidyl ether 28064-14-4 15-20 N/A N/A N/A
Bisphenol F 68609-97-2 10-15 N/A N/A N/A
diglycidly ether
N/A = Not applicable or available
------------------------------------------ III. HEALTH HAZARD INFORMATION -----------------------
SYMPTOMS OF OVEREXPOSURE for each potential route of exposure. (Possible Longer Term
Effects) None Known
SIGNS AND SYMPTOMS OF EXPOSURE (Acute effects)
Inhaled: May cause irritation of respiratory tract.
Contact with skin or eyes: Minor transient irritation for eye contact. No corneal injury likely. May
cause allergic skin reaction. Prolonged exposure not likely to cause skin irritation. Skin sensitizer
Absorbed through skin: Not likely to absorb through skin in toxic amount in a single prolonged
exposure. LD 50 for skin absorption for rabbits = 20,000 mg/kg.
Swallowed: Causes gastrointestinal irritation and possible burns if swallowed
SUSPECTED CANCER AGENT?
x NO: This product's ingredients are not found in the lists below.
YES: Federal OSHA NTP IARC
300b.doc Page 1
------------------------------IV. FIRST AID: EMERGENCY PROCEDURES-----------------------------------------
Eye Contact: Hold eyelids apart and immediately flush eyes with plenty of water for at least 15
minutes. Get medical attention immediately.
Skin Contact: Contact will probably cause no more than irritation. Wash off in flowing water or
shower. Wash clothing before reuse.
Inhaled: If inhaled, remove to fresh air. If effects occur consult a physician
Swallowed Do not induce vomiting. Call a physician
---------------------------------------------- V. FIRE AND EXPLOSION ------------------------------------------
Flash Point method): 245 F method used = PMCC
Auto ignition temperature,掳F: N/A
Flammable limits in air, volume %: Lower (LEL) Upper (UEL)
Fire extinguishing materials:
water spray x carbon dioxide other:
x foam x dry chemical
Special fire fighting procedures: Wear positive pressure self contained breathing apparatus
Unusual fire and explosion hazards: None known.
----------------------------------- VI. SPILL, LEAK, AND DISPOSAL PROCEDURES -----------------------
Spill response procedures (include employee protection measures): Soak up in absorbant material or
scrape up. Residual can be removed with hot water and a nonionic surfactant. Wear goggles, rubber
gloves, long sleeved clothing.
Preparing wastes for disposal (container types, neutralization, etc.): Burn in adequate incinerator or
bury in an approved landfill.
NOTE: Dispose of all wastes in accordance with federal, state and local regulations.
------------------------------------------VII. Handling and Storage----------------------------------------------------------
Store in cool dry area.
-------------------------------------- VIII. Exposure Controls and Personal Protection ------------------------------
Ventilation and engineering controls: Good room ventilation should be adequate for most operations
Respiratory protection (type): None normally needed
Eye protection (type): Chemical splash proof goggles, safety glasses
Gloves (specify material): Rubber or polyethylene gloves
Other clothing and equipment: clean, body-covering clothing
Work practices, hygienic practices: N/A
Other handling and storage requirements: N/A
Protective measures during maintenance of contaminated equipment: See above
300b.doc Page 2
------------------------------------------------ IX. PHYSICAL PROPERTIES ----------------------------
Vapor density (air=1): N/A Melting point or range,掳F: N/A
Boiling point or range, 掳F: N/A
Specific gravity: 1.12
Solubility in water: insoluble Evaporation rate (butyl acetate = 1): N/A
Vapor pressure, mmHg at 20掳C: N/A VOC 0.04 lb/gal.
Appearance and odor: thick opaque liquid
HOW TO DETECT THIS SUBSTANCE (warning properties of substance as a gas, vapor, dust, or
mist):
---------------------------------------------------- X. REACTIVITY DATA -----------------------------------------------
Stability: x Stable Unstable
Conditions to avoid: Excess heating over long periods of time degrades the resin
Incompatibility (materials to avoid): Bases
Hazardous decomposition products (including combustion products): (from burning, heating, or
reaction with other materials). Incomplete pyrolosis or combustion results in phenolics, carbon
monoxide, carbon dioxide, and water. Thermal decomposition should be traced as a potentially
hazardous substance.
Hazardous polymerization: May occur x Will not occur
Conditions to avoid: Masses of more than 1 pound of product plus an aliphatic amine will cause
irreversible polymerization with considerable heat build up.
-----------------------------------------------XI. Toxicology Information-------------------------------------------------
LD 50 for skin absorption for rabbits = 20,000 mg/kg
-----------------------------------------------XII. Ecological Information-------------------------------------------------
None Known
-----------------------------------------------XIII. Disposal Information--------------------------------------------------
Dispose in compliance with local, state, and federal regulations.
------------------------------------------------XIV. Transport Information---------------------------------------------------
No special labeling or transportation placarding is required.
------------------------------------------------XV. Regulatory Information--------------------------------------------------
All ingredients are listed on the U.S. EPA TSCA inventory of chemical substances.
------------------------------------------------XVI Other Information---------------------------------------------------------
This information is furnished without warranty, representation, inducement or license of any kind;
except that it is accurate to the best of our knowledge, or obtained from sources believed by us to be
accurate.
300b.doc Page 3
|