**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 94-96-2 |2-Ethyl-1,3-hexanediol | 99 | 202-377-9 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 41
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Risk of serious damage to eyes.Hygroscopic (absorbs moisture from
the air).
Potential Health Effects
Eye:
Causes severe eye irritation.
Skin:
Causes mild skin irritation. If absorbed, may cause symptoms similar
to those for ingestion. May be harmful if absorbed through the skin.
Ingestion:
May be harmful if swallowed. Ingestion of large amounts may cause
CNS depression.
Inhalation:
Causes irritation of mucous membrane.
Chronic:
Adverse reproductive effects have been reported in animals.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid.
Skin:
Get medical aid immediately. Immediately flush skin with plenty of
water for at least 15 minutes while removing contaminated clothing
and shoes. Wash clothing before reuse.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid immediately.
Inhalation:
Remove from exposure and move to fresh air immediately. If breathing
is difficult, give oxygen. Get medical aid. Do NOT use mouth-to-mouth
resuscitation. If breathing has ceased apply artificial respiration
using oxygen and a suitable mechanical device such as a bag and a
mask.
Notes to Physician:
Treat symptomatically and supportively.
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Water may
be ineffective. Material is lighter than water and a fire may be
spread by the use of water. Vapors may be heavier than air. They
can spread along the ground and collect in low or confined areas.
Extinguishing Media:
Water spray may cause frothing. Use agent most appropriate to
extinguish fire. In case of fire, use alcohol foam, foam, or dry
chemical.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Clean up spills immediately,
observing precautions in the Protective Equipment section. Provide
ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Do not get in eyes, on skin, or on clothing. Keep
container tightly closed. Do not ingest or inhale. Use with adequate
ventilation. Wash clothing before reuse.
Storage:
Store in a tightly closed container. Store in a cool, dry,
well-ventilated area away from incompatible substances. Store
protected from moisture.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 94-96-2:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: oily, colorless
Odor: Odorless
pH: Not available.
Vapor Pressure: < 0.01 mm Hg @ 20 C
Viscosity: 323 cps @ 20 deg C
Boiling Point: 241.0 - 249.0 deg C @ 760.00m
Freezing/Melting Point: -40 deg C
Autoignition Temperature: 335 deg C ( 635.00 deg F)
Flash Point: 129 deg C ( 264.20 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature:
Solubility in water: Slightly soluble.
Specific Gravity/Density: .9330g/cm3
Molecular Formula: C8H18O2
Molecular Weight: 146.23
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
Incompatible materials, moisture, excess heat, strong oxidants.
Incompatibilities with Other Materials:
Strong oxidizing agents, strong reducing agents, strong acids, acid
chlorides, acid anhydrides.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 94-96-2: MO2625000
LD50/LC50:
CAS# 94-96-2: Dermal, guinea pig: LD50 = >10 mL/kg; Draize test,
rabbit, eye: 20 mg Severe; Draize test, rabbit, skin: 500 mg Mild;
Oral, mouse: LD50 = 1900 mg/kg; Oral, rabbit: LD50 = 2600 mg/kg;
Oral, rat: LD50 = 1400 mg/kg; Skin, rabbit: LD50 = 2 gm/kg.
Carcinogenicity:
2-Ethyl-1,3-hexanediol -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 41 Risk of serious damage to eyes.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
WGK (Water Danger/Protection)
CAS# 94-96-2: 1
Canada
CAS# 94-96-2 is listed on Canada's DSL List.
CAS# 94-96-2 is listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 94-96-2 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 11/11/1998 Revision #3 Date: 10/07/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
1-Methoxynaphthalene, 95% (gc)
| 2216-69-5 |
|
2-Bromo-4'-Chloroacetophenone, 98+%
| 536-38-9 |
|
Methyl 3-bromopropionate, 97%
| 3395-91-3 |
|
1,4,7-Triazacyclononane trihydrochloride , 97%
| 58966-93-1 |
|
Ethylene/Methacrylic Acid Ionomer, Sodium Ion
| 25608-26-8 |
|
1-Fluoro-4-nitrobenzene, 99%
| 350-46-9 |
|
Bis(trimethylsilyl)telluride, 98%
| 4551-16-0 |
|
1-Acetoxy-1,3-butadiene, 97%, mixture of isomers
| 1515-76-0 |
|
Heneicosanol, 99%
| 15594-90-8 |
|
Amberlite ira-900 cl ion-exchange resin
| 9050-97-9 |
|
2-Ethyl-1,3-hexanediol, mixture of isomers, 99%
| 94-96-2 |
|
Poly(butadiene), cis and trans, average m. w. 420.000
| 9003-17-2 |
|
3-Bromo-o-xylene, 99%
| 576-23-8 |
|
Dichloroisocyanuric acid sodium salt
| 2893-78-9 |
|
Dimethyl 1,3-acetonedicarboxylate, 97%
| 1830-54-2 |
|
Octyl 4-Methoxycinnamate, 98%
| 5466-77-3 |
|
2-Cyclohexylethanol, 98%
| 4442-79-9 |
|
4-Morpholinecarbonitrile, 97+%
| 1530-89-8 |
|
2-Oxo-1-Cyclohexanepropionitrile, 99+%
| 4594-78-9 |
|
Azelaoyl Chloride, 98% (Titr.)
| 123-98-8 |
|
2-(4-Methoxyphenyl)malondialdehyde, 95+% (nmr)
| 53868-40-9 |
|
4,7-Dichloroquinoline, Tech., 95+%
| 86-98-6 |
|
Methyl azodicarboxylate, 97%
| 2446-84-6 |
|
D(+)-10-Camphorsulfonyl Chloride, 97%
| 21286-54-4 |
|
Thioisonicotinamide, 95%
| 2196-13-6 |
|
N-Methyl-4-nitroaniline, 99% (Titr.)
| 100-15-2 |
|
FLUORESCENT POLYMER SPHERES
| |
|
4-(2-Pyridylazo)resorcinol Disodium Salt, Dihydrate, 75% (UV-Vis)
| 52722-53-9 |
|
1,4-Diphenyl-1-butanone
| 5407-91-0 |
|
Amberlite ira-420, anion exchange resin
| 9002-24-8 |
|
Dibenzo-15-Crown-5, 98%
| 14262-60-3 |
|
Ammonium Hexachlororhodate(III)Trihydrate
| 81044-09-9 |
|
Methylmagnesium chloride, 22 wt% solution in tetrahydrofuran (THF)
| 109-99-9 |
|
3,3-Tetramethyleneglutaric Anhydride, 98%
| 5662-95-3 |
|
2-Chloro-6-Methylaniline, 98%
| 87-63-8 |
|
Aluminum Perchlorate Nonahydrate, 99%
| 81029-06-3 |
|
3,4-Dimercaptotoluene, zinc salt
| 26293-80-1 |
|
1-Phenyl-1-cyclohexanecarbonitrile 97%
| 2201-23-2 |
|
Allyl Mercaptan, Tech., 70+% Remainder Mainly Sulfide
| 870-23-5 |
|
4-Acetoxyacetophenone, 99%
| 13031-43-1 |
|
Lithiumtriethylborohydride, 1M solution in THF
| 109-99-9 |
|
Dimethyl Methoxymethylenemalonate, 98+%
| 22398-14-7 |
|
Methyl Oxalyl Chloride, 97%
| 5781-53-3 |
|
alpha-Hydroxy-heptafluoronaphthalene, 98%
| 5386-30-1 |
|
2-Chloro-5-fluoroanisole, 97%
| 450-89-5 |
|
Potassium selenocyanate, 99%
| 3425-46-5 |
|
2-Bromonaphtalene, 99% (GC)
| 580-13-2 |
|
Azobenzene, 99%
| 103-33-3 |
|
N-Carbobenzyloxy-DL-alanine
| 4132-86-9 |
|
Trimellitic Anhydride Acid Chloride, 99%
| 1204-28-0 |
|
|