DCT
Page 1 of 4
Diversified Chemical Technologies, Inc.
15477 Woodrow Wilson
Detroit, MI 48238
(313) 867-5444
MATERIAL SAFETY DATA SHEET
Issue Date: 09/27/01
Supersedes: 05/15/01 Issue Date: N/A
SECTION I - CHEMICAL PRODUCT
Identity: 130270
Brands: DCT Oven Cleaner
Hazard Rating: 2 Health: 2 4=EXTREME
Flammability: 1 3=HIGH
Reactivity: 0 2= MODERATE
1=SLIGHT
Emergency Telephone Number: (800) 424-9300 (24-HR 鈥? CHEMTREC)
SECTION II - COMPOSITION AND INGREDIENTS
Ingredients/Chemical Name: Sodium metasilicate and other proprietary alkaline ingredients
Hazardous Ingredients as defined by OSHA, 29 CFR 1910.1200.
Common CAS No. Recommended Limits Composition LD50/LC50
Chemical Name
Name Range
Sodium same 6834-92-0 ACGIH TWA: 10mg/m3 1-7
Metasilicate (total dust) /
5 mg/m3
(respirable dust)
OSHA PEL: 15 mg/m3
1300-72-7 1 - 10
Bemzensulfonic ACGIH TWA: 2 mg/m3
acid, dimethyl
sodium salt
1鈥? 5
TS 1094 鈥? Trade ACGIH TWA: 10 mg/m3 (total
Secret dust)
ACGIH TWA: 10mg/m3 1鈥? 5
TS 1057 鈥? Trade
(total dust) /
Secret
5 mg/m3
(respirable dust)
OSHA PEL: 15 mg/m3
1 鈥? 20
TS 1013 鈥? Trade ACGIH TWA: 2 mg/m3
Secret OSHA PEL: 2 mg/m3
5 鈥? 15
TS 1038 鈥? Trade ACGIH TWA: 100 ppm
Secret STEL: 150 ppm
OSHA PEL: 100 ppm
STEL: 150 ppm
1鈥? 5
*TS 1016- Trade OSHA PEL: 1 ppm
Secret
DCT OVEN CLEANER MSDS (continued) Page 2 of 4
SECTION III - HAZARDS IDENTIFICATION
Health Hazards (Acute and Chronic):
Ingestion: May cause moderate to severe gastrointestinal irritation if swallowed.
Eye Contact: May cause moderate to severe eye irritation.
Inhalation: May cause irritation if inhaled during prolonged, repeated exposures.
Skin: May cause moderate to severe skin irritation.
SECTION IV - FIRST AID INFORMATION
Emergency and First Aid Procedures:
Ingestion: Drink large quantities of water or milk. Do not induce vomiting. Seek prompt medical
attention.
Eye Contact: Hold eyelids open and flush thoroughly with plenty of water for at least 15 minutes. Seek
prompt medical attention.
Skin: Wash skin thoroughly with soap and water. If irritation persists, or burns exist, seek prompt
medical attention. If spilled on clothing, change clothes.
Inhalation: For accidental, high level inhalation, remove to fresh air. Get medical attention if irritation
persists.
Other: None
SECTION V - FIRE FIGHTING INFORMATION
Flash Point (Method Used): none (PMCC) Explosive Limits: LEL: N/K UEL: N/K
Extinguishing Media: Use CO2 , water, or dry chemical.
Special Fire Fighting Procedures: Firefighters should wear structural firefighting gear and SCBA if exposed to
vapors or products of combustion.
Unusual Fire Hazards : Flammable vapors may occur if mixed with water and air, and heated sufficiently
(approximately 350 F and above).
SECTION VI - ACCIDENTAL RELEASE MEASURES
Personal Precautions: Avoid contact with undiluted product. Wash thoroughly with soap and water after
handling. Do not swallow.
Environmental Precautions: DISPOSAL IS TO BE PERFORMED IN COMPLIANCE WITH ALL FEDERAL, STATE
AND LOCAL REGULATIONS.
Steps To Be Taken in Case Large Quantities of Material are Released or Spilled: Put on safety glasses, or
goggles, and rubber gloves. Contain spill. Prevent large spills from reaching waterways or sewers untreated.
Sorbents may be used. Read 鈥淲aste Disposal Method鈥? below for further information.
SECTION VII - HANDLING AND STORAGE
Precautions To Be Taken in Handling and Storing: Avoid eye and skin contact. Store in dry, cool, well-ventilated
area away from incompatibles. Do not store at elevated temperatures. Keep container sealed when not in use.
Wash thoroughly after handling material.
Other Precautions: For Institutional Use Only. Keep out of reach of children.
2
DCT OVEN CLEANER MSDS (Continued) Page 3 of 4
SECTION VIII - EXPOSURE CONTROLS, PERSONAL PROTECTION
Respiratory Protection (Specify Type): None required with normal use
Ventilation General
Eye Protection: For splash protection, use chemical goggles, safety glasses with side shields and/or faceshield.
Protective Gloves: Chemical-Resistant (neoprene, rubber, PVC preferred)
Other Protective Equipment: Suitable eyewash facilities
SECTION IX - PHYSICAL AND CHEMICAL PROPERTIES
Boiling Point 掳 F: 200 F Specific Gravity (H2 O=1): 1.09 鈥? 1.10
Vapor Pressure (mm Hg): N/K Percent Volatile by Volume (%): N/K
Vapor Density (Air=1): N/K Evaporation Rate (nBuOAc=1): N/K
Appearance and Odor: Clear yellowish, slightly viscous Freezing Point: approx. 30F
liquid with light fragranced odor
Coefficient of Water/Oil Distribution: N/K pH (F.S.): 13.4 鈥? 13.6
Solubility in Water: Complete
SECTION X - STABILITY AND REACTIVITY
Possible Hazardous Reactions/Conditions: Avoid contamination with strong oxidizers and materials that will react
with hydroxyl compounds. Avoid strong acids and bases at elevated temperatures since this
may result in explosive decomposition.
Conditions to Avoid: Extremely high temperatures.
Materials to Avoid: Strong oxidizers, Strong acids, Strong bases
Hazardous Decomposition Products: CO, CO2, and acrid smoke/irritating fumes
Other Recommendations: None
Stability: Stable
Hazardous Polymerization: Will not occur
SECTION XI - TOXICOLOGICAL INFORMATION
*LD50 (Rabbits - Skin): Greater than 5000 mg/kg; LD50 (Rats 鈥? Oral): 16,800 鈥? 22,060 mg/kg; LC50 (Rats 鈥?
Inhalation): greater than 4.5 mg/liter as an aerosol
Sodium Metasilicate: LD50 (Rats 鈥? Oral): 847 mg/kg; Skin (Rabbits 鈥? 4 HR Exposure OECD 404 Protocol): Corrosive
SECTION XII - ECOLOGICAL INFORMATION
Not Available
SECTION XIII - DISPOSAL CONSIDERATIONS
Waste Disposal Method: Small quantities: Flush with plenty of water to dilute and/or neutralize with weak acid (i.e.
citric acid) prior to discharge to POTW. Follow applicable local ordinances for disposal. Large quantities (i.e. 50
gallons or more): RCRA-corrosive (D002). Neutralization is preferred. Do not allow to enter sewers or waterways
untreated. DISPOSAL IS TO BE PERFORMED IN COMPLIANCE WITH FEDERAL, STATE AND LOCAL
REGULATIONS.
DCT OVEN CLEANER MSDS (Continued) Page 4 of 4
3
SECTION XIV - TRANSPORT INFORMATION
DOT Classification: Corrosive liquids, n.o.s. (contains sodium metasilicate and other proprietary alkaline
ingredients), 8, UN 1760, PG II, Ltd Qty
SECTION XV - ADDITIONAL REGULATORY INFORMATION
All components are listed on the US TSCA Inventory.
All ingredients are listed on the Canadian DSL Inventory. The Canadian WHMIS classification is: Class E
(Corrosive Material).
SECTION XVI - OTHER INFORMATION
*N/A. - Not Applicable *N/K. - Not Known *F.S. 鈥? Full Strength
The submission of this MSDS may be required by law, but this is not an assertion that the substance is hazardous
when used in accordance with proper safety practices and normal handling procedures. Data supplied is for use
only in connection with occupational safety and health.
The information contained herein has been compiled from sources considered by Diversified Chemical
Technologies, Inc. to be dependable and is accurate to the best of the Company鈥檚 knowledge. The information
relates to the specific material designated herein, and does not relate to the use in combination with any other
material or any other process. Diversified Chemical Technologies, Inc. assumes no responsibility for injury to the
recipient or third persons, for any damage to any property resulting from misuse of the controlled product.
4
|