MATERIAL SAFETY DATA SHEET MSDS Number: 246485CB
1. PRODUCT AND COMPANY IDENTIFICATION
Product Name: SIEGE PRESSURIZED BAIT SYSTEM (PBS) - GEL INSECTICIDE FOR COCKROACHES - ALL SIZES - EPA REGISTRATION
# 241-313- 9444
Manufactured for: Waterbury Companies, Inc. 24-Hour Emergency Contact:
P.O. Box 640 800-424-9300 or 703-527-3887
(CHEMTREC)
Independence, LA 70443
2. COMPOSITION/INFORMATION ON INGREDIENTS
Hazardous components greater than 1.0% (0.1% if carcinogen or suspected carcinogen)
% by wt.
Component CAS# OSHA PEL ACGIH TLV Other Limits
Hy dramethy lnon (Tetrahy dro-5,5-dimethy l- 67485-29-4 N.E. 1.43mg/M3 N.E. 2
2(1H-pry imidinone(3-(trif luoromethy l)pheny l)-1-
(2-(4-(trif luoromethy l)pheny l)etheny l)-2-
propeny lidene)hy drazone
Nitrogen (Non-hazardous) 7727-37-9
Non-hazardous components N/A N/A N/A N/A 85-100
3. HAZARDS IDENTIFICATION
Contents under pressure, do not expose to fire or extreme heat.
In case of a spill, wear personal protective equipment as specified on the label. Sweep solids into a drum for re-use. Decontaminate protective gear before re-use
using soap and water.
Potential Health Effects:
Routes of Entry: Inhalation: Yes Ingestion: Yes Skin: Yes
Health Hazards: Routes of entry: for solids and liquids, eye and skin contact, ingestion, and inhalation; for gases, inhalation and eye contact.
Signs/symptom of
s There is no specific antidote. Treatment for overexposure should be directed at the control of symptoms and the clinical condition.
overexposure:
Medical conditions aggravated by There are no data available to indicate medical conditions whi ch are aggravated by this product.
exposure:
NFPA Hazard Ratings Fire: 1 Health: 2 Reactivity: 0
NFPA 704 Ratings are subject to interpretation and are only intended for general identification of the level of the specific hazard. All information m be
ust
considered for proper safe handling of the material.
4. FIRST AID MEASURES
IF SWALLOWED: Call a poison control center or doctor for treatment advice. Have person sip water if able to swallow. Do not induce vomiting unless instructed to
do so by the poison control center or doctor. Do not give anything by mouth to an unconscious person. IF ON SKIN: Wash with plenty of soap and water, remove
affected clothing, and seek medical attention if irritation occurs. IF IN EYES: Immediately wash eye with running water for 15 minutes. Remove contact lenses after
5 minutes and continue rinsing for 10 more minutes. If irritation develops, consult a physician. IF INHALED: Remove victim to fresh air. If not breathing, call 911 or
an ambulance, then give arftificial respiration, preferably by mouth to mouth. Have the product label or c ontainer with you when calling for / going for treatment.
5. FIRE FIGHTING MEASURES
Extinguishing Media: Water fog, CO2, dry chemical, or foam
Fire Fighting Procedures: Self contained air supply suggested.
Unusual Fire and Explosion Hazards: None Known.
6. ACCIDENTAL RELEASE MEASURES
Isolate area and keep out animals and unprotected persons. SOLID SPILL: Sweep or vacuum for re-use or disposal. Flush area with water. LIQUID SPILL: Dike
and contain with inert material (sand, earth, etc.); transfer liqid and solid to separate containers for dis posal.
7. HANDLING AND STORAGE
Avoid contact with skin and eyes. Do not contaminate water, food or feed by storage or disposal. Do not store where children or animals may gain access.
STORAGE: Store in a cool, dry place away from ignition sources, heat, or flame. Liquefies above 176 deg. F or below 25 deg.F Do not store where children or
animals may gain access. Do not allow contact with ponds or streams; the active ingredient is very toxi c to fish and aquatic invertebrates.
NFPA 30B Aerosol Classification: Level 1 Aerosol
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Protective Gloves: Wear gloves to avoid skin contact.
Eye Protection: Chemical goggles.
Respiratory Protection: Wear appropriate MESA and NIOSH approved respirator.
Ventilation: Local: As required to keep airborne concentrations below the acceptable levels.
Mechanical: Not required for normal use.
Other protective equipment: Long sleeve shirt , long pants, socks, and shoes are recommended.
Protective Work/Hygiene Practices: Follow label instructions.
Revision Date: 1/8/2008 Date Printed: 1/9/2008 Page 1 of 2
MATERIAL SAFETY DATA SHEET MSDS Number: 246485CB
9. PHYSICAL AND CHEMICAL PROPERTIES
Specific Gravity (H2O=1): 1.09 Flashpoint: Not applicable. LEL: N/A
Vapor Pressure (m Hg):
m N.E. Boiling Point: N.E. Melting Point: 176F UEL: N/A
Solubility: Soluble Appearance/Odor: Yellow gel/odor-unknown
10. STABILITY AND REACTIVITY
Conditions to Avoid: None known.
Incompatible Materials: Concentrated oxidizing agents.
Hazardous Decomposition By-products: Oxides of Carbon and Nitrogen, Hydrogen Flouride
Hazardous Polymerization Conditions: None known.
11. TOXICOLOGICAL INFORMATION
This product contains no chemicals that are listed on the NTP, IARC, or OSHA carcinogen lists. Any further information on the toxicology of the material can be
obtained by contacting the manufacturer.
12. ECOLOGICAL INFORMATION
Please call the manufacturer for questions concerning the ecological effects of this product and it's constituents.
13. DISPOSAL CONSIDERATIONS
Do not puncture or incinerate! "Empty" cylinders may contain residue. IF EMPTY: Place in trash or offer for recycling if available. IF PARTLY FILLED: Call your
local solid waste agency or 1-800-CLEANUP for disposal instructions.
14. TRANSPORT INFORMATION
Status Shipping Name Class ID Number Pack Grp
DOT (USA): Regulated Consumer Commodity (per 49CFR173.306) ORM-D N/A N/A
IATA (Air): Regulated Consumer Commodity 9 ID8000 N/A
IMDG (Vessel): Regulated Aerosols 2 UN1950 N/A
National Motor Freight Classification and LTL Class: 57100 Sub 3 Class 60
15. REGULATORY INFORMATION
SARA Title III Section 312: When completing Tier II reports, the following information should be used.
Note: See state and local regulations for specifics on reporting requirements for your facility.
This product should be described as: PURE: N MIXTURE: Y SOLID: Y LIQUID: N GAS: Y
Physical Hazards: FIRE: N PRESSURE: Y REACTIVITY: N Health Hazards: IMMEDIATE: Y DELAYED: Y
SARA Title III Section 313: Toxic chemical components subject to the report ing requirements of EPCRA and 40CFR372
Chemical CAS/Category Percent
Hy dramethy lnon 67485-29-4 2.00
16. OTHER INFORMATION
Product Sales Information: 800-845-3495
MSDS Information: 985-878-6751
Revision Notes: Review of MSDS
MSDS Prepared by SW
N/A = Not Applicable N.E. = Not Established WATCO PART #: 38MS246485CB
This Information is provided in good faith, but no warranty, expressed or implied, is made. The manufac turer believes that it is accurate and to the best of its
knowledge, and relates only to the specific m aterial designated herein.
Revision Date: 1/8/2008 Date Printed: 1/9/2008 Page 2 of 2
|