Material Safety Data Sheet
1. Product and Company Identification
Product Code CS-100 JADE
Product Name BRICKFORM庐 Blush-Tone Acid Stain鈩?
Manufacturer Emergency Phone
BRICKFORM Chemtrec 800-424-9300
Address Business Phone
11061 Jersey Blvd. 909-484-3399
City, State, Zip Business Fax
Rancho Cucamonga, CA 91730 909-484-3318
Last Updated June 6, 2006
2. Composition / Information on Ingredients
Chemical Name CAS No. ACGIH TLV OSHA PEL STEL
Cupric Chloride 7447-39-4 1 mg/m3 1 mg/m3 N/A
Phosphoric Acid 7664-38-2 1 mg/m3 1 mg/m3 N/A
Hydrochloric Acid 7647-01-0 7 mg/m3 7 mg/m3 N/A
Water 7732-38-2 N/A N/A N/A
3. Hazards Identification
Emergency Overview
CORROSIVE. Contains acid. Dark liquid with sharp pungent odor. Harmful if swallowed or inhaled. Overexposure could cause (target
organ or system) damage, such as nervous system, blood disorders, liver, kidney, immune system, cardiovascular system, thyroid, testicular,
or ovarian.
Signs and Symptoms of Exposure
Ingestion
When concentrated hydrochloric acid is swallowed, it causes severe burns of the mucous membranes of the mouth, esophagus and
stomach. The lips and mouth usually turn white and later brown. There is pain in the throat and stomach, difficulty in swallowing, intense
thirst, nausea and vomiting, followed by diarrhea and in severe cases, by collapse and unconsciousness.
Inhalation
Inhalation of excessive concentrations of hydrogen chloride vapors immediately produces severe irritation of the upper respiratory
tract, resulting in coughing, burning of the throat, and choking sensation. Reactions encountered in man have usually been limited to
inflammation and occasional ulceration of the nose, throat and larynx. If inhaled deeply, edema of the lungs may occur. Prolonged or
repeated contact may cause perforation of the nasal septum.
Eyes
Contact of the eyes with hydrogen chloride, either as a gas or in solution, rapidly causes severe irritation and painful burns of the eyes and
eyelids. If the acid is not quickly removed by thorough irrigation with water, there may be prolonged or permanent visual impairment or
total loss of sight. Prolonged or repeated contact may cause conjunctivitis.
Skin
Absorption of concentrated solutions is destructive to clothing and on contact with skin, causes severe burns unless promptly washed off.
Repeated skin contact with dilute solutions may lead to the development of dermatitis. Exposure to the concentrated vapor of an hydrous
hydrogen chloride may also result in burns or dermatitis. Prolonged or repeated contact may cause ulcerations.
Potential Environmental Hazards:
N/A
continued
Page 1 of 4 LIT-3040 漏 2006 BRICKFORM庐 - All rights reserved
BRICKFORM BRICKFORM Blush Tone Acid Stain / CS-100 JADE
Last Updated June 6, 2006
Material Safety Data Sheet
4. First Aid Measures
Ingestion
DO NOT INDUCE VOMITING. If the patient has swallowed Hydrochloric Acid and is conscious, give large amounts of
limewater or milk of magnesia. Water should be given if neither of these is available. Do not give sodium bicarbonate.
GET MEDICAL ATTENTION IMMEDIATELY.
Inhalation
If symptoms develop, immediately move individuals away from exposure and into fresh air. Seek immediate medical
attention; keep person warm and quiet. If person is not breathing, begin artificial respiration. If breathing is difficult,
administer oxygen. GET MEDICAL ATTENTION IMMEDIATELY.
Eyes
DO NOT RUB. Immediately flush the eyes with large quantities of running water for a minimum of 15 minutes. Hold the
eyelids apart during the irrigation to ensure flushing of the entire surface of the eye and lids with water. GET MEDICAL
ATTENTION
IMMEDIATELY. Do not attempt to neutralize the acid with chemicals. Oils or ointments should not be used unless directed
by a physician. Continue the irrigation for an additional 15 minutes if a physician is not available.
Skin
Immediately flush affected areas with water. Remove contaminated clothing under the shower. Continue washing with
water - do not attempt to neutralize with chemical agents. Severe or extensive burns may be caused by Hydrochloric
Acid producing shock symptoms (rapid pulse, sweating and collapse). In these cases keep the patient on his back
and comfortably warm. GET MEDICAL ATTENTION IMMEDIATELY. Do not apply oils or ointments unless directed by a
physician.
5. Fire Fighting Measures
Flash Point N/A Lower Explosive Limit N/A
Autoignition Temperature N/A Upper Explosive Limit N/A
Unusual Fire Explosion Hazards
Releases Hydrogen Chloride Gas when heated. Also reacts with most metals to release Hydrogen Gas, which can form
explosive mixtures with air.
Extinguishing Media
Use water fog, foam, or dry chemical.
Special Fire Fighting Procedures
Evacuate hazard area of unprotected personnel. Wear full protective gear, including a NIOSH-approved, positive pressure,
self-contained, breathing apparatus. Cool fire-exposed containers with water. In case of large fires, also cool surrounding
equipment and structures with water. If a leak or spill has not ignited, use water spray to disperse the vapors. Water
runoff can cause environmental damage. Dike and collect water used to fight fire.
6. Accidental Release Measures
Approach release from upwind. Stop or control leak using special protective clothing and positive pressure self-contained
breathing apparatus. Minimize breathing vapors. Minimize skin contact. Ventilate confined spaces. Open all windows and
doors. Control runoff and isolate discharge material for proper waste-disposal method. Do not use metal containers to
recover material. Keep product out of sewers and watercourses by dyking or impounding. Advise authorities if product
has entered or may enter sewers, watercourses, or extensive land areas. Use non-leaking containers, seal tightly, and label
properly. Dispose of in accordance with applicable local, county, state, and federal regulations.
7. Handling and Storage
Safe Handling and Storage
CAUTION: CORROSIVE. Store away from strong oxidizing agents, in a cool, dry place that is away from direct sunlight.
Keep containers closed. Do not let product freeze. Keep away from heat, sparks, and open flame.
DO NOT WELD, heat or drill on or near containers. Even empty containers can contain explosive vapors or residue.
Material containers may be hazardous when emptied, since containers retain residues (vapor, liquid, and/or solids).
Observe all hazard precautions given in this data sheet.
Page 2 of 4 LIT-3040
BRICKFORM BRICKFORM Blush Tone Acid Stain / CS-100 JADE
Last Updated June 6, 2006
Material Safety Data Sheet
8. Exposure Controls and Personal Protection
Engineering controls
Provide mechanical local exhaust ventilation to prevent release of mist in work environment. If ventilation is inadequate or
not available, use acid cartridge or canister with full face-piece.
Personal Protective Equipment
Use approved acid/gas cartridge or canister with full-face piece unless break through occurs, then use airline supplied or
self-contained breathing apparatus. Use impervious neoprene or rubber gloves. Use cup-type chemical goggles or full face
shield.
Other Protective Clothing Equipment
An eyewash station and a safety shower should be available.
General Work Practices Hygiene Considerations
Minimize breathing vapor or mist. Avoid prolonged or repeated contact with skin. Use good hygiene when handling this
product. Cleanse skin thoroughly after handling and before eating or drinking. Product is easily removed with waterless,
hand cleaners followed by washing thoroughly with soap and water. Remove contaminated clothing and launder or dry-
clean before reuse. Discard contaminated shoes and thoroughly clean and dry before reuse.
Exposure Guidelines
Please see section 2.
9. Physical and Chemical Properties
Physical State Liquid Appearance/Color/Odor Dark liquid/Sharp pungent odor
Melting Point/Range N/A Boiling Point/Range N/A
Solubility in Water Soluble How to Detect this Compound Odor
pH N/A Specific Gravity (Water = 1) 1.30 +/- .03
Molecular Weight N/A Percent Volatiles N/A
Vapor Pressure (mmHg) N/A Vapor Density (Air = 1) N/A
VOC N/A
10. Stability and Reactivity
Stability Stable
Hazardous Polymerization Will not occur
Conditions To Avoid Never add water to acid. Addition to water releases heat and will result in violent foaming and
spattering.
Materials To Avoid Strong alkalies or alkali metals.
Hazardous Decomposition Products May evolve highly toxic chloride and chlorine fumes.
11. Toxicological Information
N/A
12. Ecological Information
N/A
13. Disposal Considerations
Use non-leaking, non-metal containers, seal tightly and label properly. Dispose of in accordance with applicable local,
county, state, and federal guidelines. Do not dispose in streams, wells, lakes, rivers, oceans, or sewers.
continued
Page 3 of 4 LIT-3040
BRICKFORM BRICKFORM Blush Tone Acid Stain / CS-100 JADE
Last Updated June 6, 2006
Material Safety Data Sheet
14. Transportation Information
DOT Proper Shipping Name Hydrochloric Acid
DOT Hazard Class ID Number 8, UN1789, lll
15. Regulatory Information
Reportable Quantity N/A
NFPA Rating 0=Insignificant, 1=Slight, 2=Moderate, 3=High, 4=Extreme
Health 3
Flammability 0
Reactivity 0
Carcinogenicity Lists No
NTP Yes
IARC Monograph Yes
OSHA Regulated No
STATE WARNING
California Prop 65: This product may contain a chemical known to the State of California to cause cancer and birth
defects or other reproductive harm.
Many States have adopted Federal guidelines and restrictions for hazardous chemicals. A complete list is available at
www.epa.gov./ceppo/pubs/title3.pdf. Some states have expanded the Federal List and you should check with your local
regulatory agency for any additional restrictions on the hazardous chemicals listed in this section.
FEDERAL WARNING
Section 313 Supplier Notification: This product contains the following toxic chemical(s) subject to the reporting
requirements of SARA TITLE III, Section 313 of the Emergency Planning and Community Right-To-Know Act of 1986 and
of 40 CFR 372:
CAS# CHEMICAL NAME %BY WEIGHT
7647-01-0 Hydrochloric Acid <7
7664-38-2 Phosphoric Acid Trace
16. Other Information
IMPORTANT! Read this MSDS before use or disposal of this product. Pass along the information to employees and any
other persons who could be exposed to the product to be sure that they are aware of the information before use or other
exposure.
This MSDS has been prepared according to the OSHA Hazard Communication Standard (29 CFR 1910.1200). To the best
of our knowledge, the information contained herein is accurate and the information is based on sources believed to be
reliable. However, since data, safety standards, and government regulations are subject to change, BRICKFORM makes
no warranty, either expressed or implied with respect to the completeness or continuing accuracy of the information
contained herein and disclaims all liability for reliance thereon. The data on this sheet is related only to this specific
material. It may not be valid for this material if used in combination with any other materials. It is the user鈥檚 responsibility
to determine suitability and completeness of this information with regards to a particular use. Additional information may
be necessary or helpful for specific conditions and circumstances of use. Unknown hazards may exist and this material
should be used with caution. BRICKFORM assumes no legal responsibility for use or reliance upon this data.
Page 4 of 4 LIT-3040
|