MSDS - Material Safety Data Sheet
Product Name: LIGHT CUTTING OIL
MSDS No.: CO16L
I. Basic Information:
Manufacturer: RADIATOR SPECIALTY COMPANY
1
Address: P.O. BOX 159, 600 RADIATOR ROAD
City, ST Zip: INDIAN TRAIL, NC 28079
1 0
Emergency Contact: Rocky Mountain Poision Control Center
Emergency Telephone Number: 303-623-5716
Contact: Robert Geer
Information Telephone Number: 704-688-3430
1
1
Last Update: 05/26/2004
0
X Liquid Gas Solid
Chemical State:
B
Pure Mixture
X
Chemical Type:
II. Ingredients:
Trade Secret
EHS IARC SARA
313 OSHA ACGIH Other
% Range NTP SUB Z PEL TLV Limits
CAS No. Chemical Name
63449398 Chlorinated Paraffin 0.1 - 1.0 N/E N/E
X
68425161 Di-Tertiary nonylpolysulfide 1.0 - 5.0 N/E N/E
64742525 Naphthenic Petroleum Distillate 60.0 - 100.0 5 mg/m3 5 mg/m3
68991708 Sulfurized Fat 1.0 - 5.0 N/E N/E
III. Hazardous Identification:
Hazard Category:
X Acute Chronic Fire Pressure Reactive
Hazardous Identification Information:
Harmful or Fatal if Swallowed.
IV. First Aid Measures:
Route(s) of Entry:
Absorption, Inhalation, and Ingestion.
Health Hazards (Acute and Chronic):
See signs and symptoms below
Signs and Symptoms:
Eye Contace: May cause slight iffitation
Skin Contact: May cause slight irritation
Inhalation: If oil mist is inhaled for prolonged periods, may cause irritation.
Ingestion: Can be Harmful or fatal if swallowed.
Medical Conditions Generally Aggravated by Exposure:
None known
Emergency and First Aid Procedures:
MSDS - Material Safety Data Sheet
Product Name: LIGHT CUTTING OIL
MSDS No.: CO16L
Eye Contact: Flush eyes with clean water for 15 minutes while lifting eyelids and get prompt medical attention.
Skin Contact: Wash with soap and water thoroughly. If adverse effects persist, get prompt medical attention. Launder
contaminated clothing before reuse.
Inhalation: Remove to fresh air. If breathing becomes difficult get prompt medical attention.
Ingestion: DO NOT INDUCE VOMITING! Call Poison Control Center, physician, or hospital emergency room immediately.
Other Health Warnings:
Vomiting and subsequent aspiration into the lungs may lead to chemical pneumonia and pulmonary edema which is a potentially
fatal condition.
V. Fire Fighting Measures:
Flash Point: 300 F Lower Explosive Limit: N/D Upper Explosive Limit: N/D
F.P. Method: COC
Fire Extinguishing Media: Water Fog, Foam, Carbon Dioxide, Dry Chemical
Special Fire Fighting Procedures:
Wear self-contained positive pressure breathing apparatus and protective clothes. Cool containers with a water fog. Do not use
forced water stream as this could cause the fire to spread.
Unusual Fire and Explosion:
None known.
VI. Accidental Release Measures:
Steps to be Taken in Case Material is Released or Spilled:
Persons not wearing protective equipment should be excluded from area of spill until clean-up has been completed. Dike or
contain spill and absorb with inert materials (sand, sawdust, absorbent sweeping compounds, rags, etc). Place contaminated
material into an approved chemical waste container. Where possible, vacuum spilled liquid using an explosion proof vacuum to
recover material. Prevent run-off to sewers, streams, or other bodies of water. If run-off occurs, notify proper authorities as
required that a spill has occured.
VII. Handling and Storage:
Precautions to be Taken:
Handling: Use with adequate ventilation and proper protective equipment.
Do not use or store near fire, sparks, or flame. Do not puncture or incinerate container. Exposure to temperatures above 120掳 may
cause container to vent, rupture, or burst.
Other Precautions:
Keep container closed tightly when not in use.
Store in a cool place away from oxidizing agents.
VIII. Exposure Controls/Personal Protection:
Ventilation Requirements:
See Section 2 for applicable exposure limits. Maintain adequate ventilation.
Avoid breathing mist. In restricted areas, use approved chemical filters designed to remove mist. In confined areas, use approved
air line type respirator or hood. A self-contained breathing apparatus is required for vapor or mist concentrations above TLV limit
Personal Protective Equipment:
See Section 2 for applicable exposure limits. For prolonged exposure wear protective safety glasses, gloves, and apron.
MSDS - Material Safety Data Sheet
Product Name: LIGHT CUTTING OIL
MSDS No.: CO16L
IX. Physical and Chemical Properties:
Boiling Point: 500掳F Melting Point: N/A
Evaporation Rate (Butyl Acetate = 1): Slow Vapor Pressure (mm Hg.): LOW
Specific Gravity (H20 = 1): 0.87000 Vapor Density (AIR = 1): N/D
Solubility In Water: Insoluble Appearance and Odor: amber oil with petroleum odor
Other Information: N/D
X. Stability and Reactivity:
Stability:
Stable
Incompatibility (Materials to Avoid):
Avoid contact with strong ozidizing agents
Decomposition/By Products:
Normal products of combustion, smoke, carbon dioxide, carbon monoxide, phosphorus, nitrogen and sulfur oxides.
Hazardous Polymerization:
Will not occur
XI. Toxicological Information:
N/D
XII. Ecological Information:
N/D
XIII. Disposal Considerations:
DISPOSAL: This container may be recycled in a recycling centers when empty. Before offering for recycling, empty the can or
bottle by using the product according to the label. If recycling is not available, wrap the container and discard in the trash. Dispose
of unused product in accordance with all local, state government and federal laws and regulations
XIV. Transport Information:
DOT Shipping Name: Not DOT regulated.
DOT Hazard Class: None
XV. Regulatory Information:
See Section 2 for SARA Reportable Chemicals.
USA TSCA: All components of this material are listed on the US TSCA Inventory.
XVI. Other Information:
Do not used in confined area without proper ventilation. Contact lenses may cause further damage in case of splash into eye.
KEEP AWAY FROM CHILDREN AND ANIMALS!
N/E: Not Established
N/D: Not Determined
N/A: Not Applicable
N/AV: Not Available
MSDS - Material Safety Data Sheet
Product Name: LIGHT CUTTING OIL
MSDS No.: CO16L
While Radiator Specialty Company believes this data is accurate as of the revision date, we make no warranty with respect to the
data and we expressly disclaim all liability for reliance thereon. The data is offered soley for information, investigation, and
verification. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or
disposal of this product which may not be covered by this MSDS. The user is repsonsible for full compliance.
|