Wednesday, June 11, 2008
Page 1 of 5
MSDS - Material Safety Data Sheet
Product Name: DIESEL FUEL ANTI-GEL COLD FLOW IMPROVER
(UPC: 078698132211)
MSDS No.: M2216X
I. Basic Information:
Manufacturer: RADIATOR SPECIALTY COMPANY Contact: Robert Geer
Address: 600 RADIATOR ROAD Information Telephone Number: 704-684--181 1
City, ST Zip: INDIAN TRAIL, NC 28079 Emergency Contact: Rocky Mountain Poision Control Center
Country: Emergency Telephone Number: 303-623-5716
Emergency Restrictions:
Product Name: DIESEL FUEL ANTI-GEL COLD FLOW IMPROVER (UPC: 078698132211)
MSDS No.: M2216X
Issue Date: 06/11/2008
Supersedes Date: 10/04/2006
II. Hazards Identification:
EMERGENCY OVERVIEW
Combustible. Harmful or Fatal if Swallowed. Eye and Skin Irritant.
OSHA Regulatory Status
This material is considered hazardous by the OSHA Hazard Communication Standard (29 CFR 1910.1200).
Potential Health Effects
Route(s) of Entry:
Absorption, Eye, Inhalation, and Ingestion.
Health Hazards (Acute and Chronic):
See signs and symptoms below
Signs and Symptoms:
Eye Contact: Irritant. Prolonged contact may cause conjunctivitis.
Skin Contact: Irritant. Defatting of tissue, dermatitis may occur.
Inhalation: Irritant to mucous membranes. Repeated exposure may cause narcosis..
Ingestion: HARMFUL OR FATAL IF SWALLOWED.
Medical Conditions Generally Aggravated by Exposure:
None Known
Other Health Warnings:
Vomiting and subsequent aspiration into the lungs may lead to chemical pneumonia and pulmonary edema which is a potentially fatal condition.
Potential Environmental Effects
Not Available
III. Composition/Information on Ingredients:
Chemical Name CAS No. % Range Trade Secret
1,2,4-Trimethylbenzene 95-63-6 10.0 - 30.0
Aliphatic Hydrocarbon - Non Exempt. 8052-41-3 30.0 - 60.0
Aromatic Petroleum Naphtha 64742-95-6 30.0 - 60.0
Diethylbenzene 25340-17-4 1.0 - 5.0
Ethylbenzene 100-41-4 0.1 - 1.0
Ethylhexanol 104-76-7 0.1 - 1.0
Isopropylbenzene 98-82-8 0.1 - 1.0
Mesitylene 108-67-8 1.0 - 10.0
Naphthalene 91-20-3 0.1 - 1.0
Wednesday, June 11, 2008
Page 2 of 5
MSDS - Material Safety Data Sheet
Product Name: DIESEL FUEL ANTI-GEL COLD FLOW IMPROVER
(UPC: 078698132211)
MSDS No.: M2216X
Petroleum naphtha 64742-94-5 3.0 - 7.0
Trimethyl benzene 25551-13-7 0.1 - 1.0
Xylene (mixed isomers) 1330-20-7 1.0 - 5.0
IV. First Aid Measures:
Emergency and First Aid Procedures:
Eye Contact: Flush eyes with clean water for 15 minutes while lifting eyelids and get prompt medical attention.
Skin Contact: Wash with soap and water thoroughly. If adverse effects persist, get prompt medical attention. Launder contaminated clothing
before reuse.
Inhalation: Remove to fresh air. If breathing becomes difficult get prompt medical attention.
Ingestion: DO NOT INDUCE VOMITING! Call Poison Control Center, physician, or hospital emergency room immediately.
Note to Physicians:
N/E
V. Fire Fighting Measures:
Suitable Extinguishing Media:
Water Fog, Foam, Carbon Dioxide, Dry Chemical
Unsuitable Extinguishing Media:
Do not use forced water stream as this could cause the fire to spread.
Products of Combustion:
Normal products of combustion: carbon monoxide, carbon dioxide, smoke and Nitrogen, Sulfur Oxides
Protection of Firefighters:
Wear self-contained positive pressure breathing apparatus and protective clothes.
VI. Accidental Release Measures:
Personal Precautions:
Persons not wearing protective equipment should be excluded from area of spill until clean-up has been completed.
Environmental Precautions:
Prevent run-off to sewers, streams, or other bodies of water. If run-off occurs, notify proper authorities as required that a spill has occurred. Run off
to sewer may create fire or explosion hazard.
Methods for Containment:
Dike or contain spill and absorb with inert materials (sand, sawdust, absorbent sweeping compounds, rags, etc).
Methods for Cleanup:
Using a non-metalic scoop, place contaminated material into an approved chemical waste container. Where possible, vacuum spilled liquid using
an explosion proof vacuum to recover material.
Other Information:
All equipment used with handling the concentrate must be grounded. If run-off occurs, notify proper authorities as required that a spill has occurred.
VII. Handling and Storage:
Handling Precautions:
Handling: Use with adequate ventilation and proper protective equipment.
Do not use near fire, sparks, or flame. Do not puncture or incinerate container.
Store in cool, well ventilated area below 120掳F away from heat sources. Avoid contact with alkalis and strong oxidizing agents. Keep containers
tightly closed.
Storage Precautions:
Do not used in confined area without proper ventilation. Contact lenses may cause further damage in case of splash into eye. KEEP AWAY FROM
CHILDREN AND ANIMALS!
Wednesday, June 11, 2008
Page 3 of 5
MSDS - Material Safety Data Sheet
Product Name: DIESEL FUEL ANTI-GEL COLD FLOW IMPROVER
(UPC: 078698132211)
MSDS No.: M2216X
VIII. Exposure Controls/Personal Protection:
Chemical Name OSHA PEL ACGIH TLV Other Limits
Aliphatic Hydrocarbon - Non Exempt. 100 ppm 100 ppm Not Available
Aromatic Petroleum Naphtha N/E N/E 25 ppm
1,2,4-Trimethylbenzene N/E 25 ppm Not Available
Mesitylene N/A N/A Not Available
Diethylbenzene N/A N/A Not Available
Naphthalene 10 ppm 10 ppm Not Available
Trimethyl benzene 25 ppm (TWA) 25 ppm (TWA) Not Available
Ethylbenzene 100 ppm 100 ppm Not Available
Xylene (mixed isomers) 100 ppm 100 ppm Not Available
Isopropylbenzene 50 ppm 50 ppm Not Available
Petroleum naphtha N/E N/E 100 ppm
Ethylhexanol N/E N/E Not Available
Engineering Controls:
See Section above for applicable exposure limits. Use with adequate ventilation. If TLV is exceeded, wear NIOSH approved respirator.
Personal Protective Equipment:
For prolonged exposure wear protective safety glasses, gloves, and apron.
IX. Physical and Chemical Properties:
Boiling Point: 320掳F Melting Point: N/A
Boiling Range: Not Available Freezing Point: Not Available
Solubility In Water: Insoluble Evaporation Rate (Butyl Acetate = 1): N/D
Flash Point: 105掳F Flash Point Method: TCC
Odor Threshold: Not Available Appearance and Odor: Clear amber liquid with petroleum odor.
Vapor Density (AIR = 1): N/D Vapor Pressure (mm Hg.): N/D
pH Range: Not Available Not Available
Partition Coefficient:
Not Available Auto-Ignition Temp: Not Available
Decomposition Temp:
Lower Explosive Limit: N/D Upper Explosive Limit: N/D
Specific Gravity (H20 = 1): 0.84
Other Information: N/D
X. Stability and Reactivity:
Stability:
Stable
Conditions to Avoid:
See Incompatible Materials listed below.
Incompatible Materials:
Oxidizing agents, acids and alkalis .
Wednesday, June 11, 2008
Page 4 of 5
MSDS - Material Safety Data Sheet
Product Name: DIESEL FUEL ANTI-GEL COLD FLOW IMPROVER
(UPC: 078698132211)
MSDS No.: M2216X
Hazardous Decomposition Products:
Normal products of combustion: carbon monoxide, carbon dioxide, smoke and Nitrogen, Sulfur Oxides
Possibility of Hazardous Reactions:
Will not occur
XI. Toxicological Information:
N/E
XII. Ecological Information:
N/E
XIII. Disposal Considerations:
DISPOSAL: This container may be recycled in a recycling centers when empty. Before offering for recycling, empty the can or bottle by using the
product according to the label. If recycling is not available, wrap the container and discard in the trash. Dispose of unused product in accordance
with all local, state government and federal laws and regulations
XIV. Transport Information:
Shipping Name: Not Available
DOT Hazard Class: Not Available DOT Subsidiary Hazard Class: Not Available
UN/NA#: Not Available Not Available
Packing Group:
Transportation Information:
DOT Shipping Name: Not DOT regulated.
DOT Hazard Class: None
The DOT description is provided to assist in the proper shipping classification of this product and may not be suitable for all shipping purposes.
ICAO/IATA (US)
Shipping Name: Petroleum products, n.o.s. (Mineral Spirits/Aromatic Petroleum Naphtha)
Class: 3
UN number: UN1268
PG: III
International:
ICAO/IATA
UN number: UN1268
Shipping Name: Petroleum products, n.o.s. (Mineral Spirits/Aromatic Petroleum Naphtha)
Class: 3
PG: III
IMDG
UN number: UN1268
Shipping Name: Petroleum products, n.o.s. (Mineral Spirits/Aromatic Petroleum Naphtha)
Class:
PG: III
EmS: F-E, S-E
XV. Regulatory Information:
Wednesday, June 11, 2008
Page 5 of 5
MSDS - Material Safety Data Sheet
Product Name: DIESEL FUEL ANTI-GEL COLD FLOW IMPROVER
(UPC: 078698132211)
MSDS No.: M2216X
SARA 313 Reportable Chemicals.:
Aliphatic Hydrocarbon (8052-41-3)
Aromatic Petroleum Distillate (64742-95-6)
Petroleum Naphtha (64742-94-5)
Xylene (1330-20-7)
1,2,4-Trimethylbenzene (95-63-6)
USA TSCA: All components of this material are listed on the US TSCA Inventory.
This fuel additive is registered in the United States
Warning: This product contains a chemical known to the State of California to cause cancer or birth defects or other reproductive harm.
State Right To Know Chemicals:
Aliphatic Hydrocarbon (8052-41-3)
Xylene (1330-20-7)
1,2,4-Trimethylbenzene (95-63-6)
Naphthalene (91-20-3)
Ethylbenzene (100-41-4)
Diethylbenzene (25340-17-4)
Isopropenyl benzene (98-82-8)
XVI. Other Information:
Liquid Gas Solid
Chemical State: X
Pure Mixture
Chemical Type: 2
X
Hazard Category: 2 0
Acute Chronic Fire
X X
Pressure Reactive
Additional Manufacturer Warnings:
Do not used in confined area without proper ventilation. Contact lenses 2
may cause further damage in case of splash into eye. KEEP AWAY FROM
2
CHILDREN AND ANIMALS!
0
N/E: Not Established
N/D: Not Determined H
N/A: Not Applicable
N/AV: Not Available
Additional Product Information:
While Radiator Specialty Company believes this data is accurate as of the revision date, we make no warranty with respect to the
data and we expressly disclaim all liability for reliance thereon. The data is offered solely for information, investigation, and
verification. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or
disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.
|