2. CHEMICAL AND PHYSICAL PROPERTIES
Vapor Pressure: Less than 10mm @ 80掳F
Vapor Density: Not available
Solubility in Water: Slight
Specific Gravity: 1.08 @ 80掳F
Boiling Point: More than 300掳F
Volatile Organic Compound 0%
Evaporation Rate (Ether = 1) Not available
pH: Does not apply
Appearance: Translucent amber tan paste
Odor: Sharp, irritating
3. FLAMMABILITY AND EXPLOSIVE PROPERTIES
Flash Point: 200掳F Method: (PMCC)
Estimated NFPA Code:
Health Hazard: 2
Fire Hazard: 1
Reactivity Hazard: 1
Specific Hazard: Does not apply
Estimated HMIS Code:
Health Hazard: 2
Flammability Hazard: 1
Reactivity Hazard: 1
Personal Protection: See Section 9
Explosive Limits:
(% by volume in air) Lower Not available
(% by volume in air) Upper Not available
Recommended Extinguishing Agents: Carbon dioxide, foam, dry chemical
Hazardous Products Formed by Fire
or Thermal Decomposition: Irritating organic vapors & oxides of carbon & nitrogen
Unusual Fire or Explosion Hazards: None
Compressed Gases: None
Pressure at Room Temp.: Does not apply
Page 1 of 3
MATERIAL SAFETY DATA SHEET 670A
Adhesive
8/15/2003
4. SPILL OR LEAK AND DISPOSAL PROCEDURES
Steps to be taken in case of spill or leak: Remove sources of ignition. Maintain adequate ventilation.
Soak up with an inert absorbent. Store in a partly filled, closed container until disposal.
Recommended methods of disposal: Incinerate following EPA and local regulations.
5. STORAGE AND HANDLING PROCEDURES
Storage: Store at or below 100OF to preserve shelf life.
Handling: Avoid prolonged breathing of vapors. Keep away from eyes. Avoid prolonged skin
contact. Keep away from sources of ignition.
7. REACTIVITY DATA
Stability: Stable
Hazardous Polymerization: Will not occur.
Hazardous Decomposition Products
(non-thermal): None
Incompatibility: None
8. EMERGENCY TREATMENT PROCEDURES
Ingestion: Do not induce vomiting. Keep individual calm. Obtain
medical attention.
Inhalation: Remove to fresh air. If symptoms persist, obtain medical
attention.
Skin Contact: Wash with soap and water.
Eye Contact: Flush with water for at least 15 minutes. Obtain medical
attention.
9. PERSONAL PROTECTION
Eyes: Safety glasses or goggles.
Skin: Rubber of plastic gloves.
Ventilation: Sufficient to maintain vapor concentration below TLV.
10. HEALTH HAZARD DATA
Toxicity: Eye and skin irritant. Estimated oral LD50 more than 5,000
mg/kg. Estimated dermal LD50 more than 2,000 mg/kg.
Primary Routes of Entry: None known
Signs and Symptoms of Exposure: May cause dermatitis on prolonged contact in sensitive
individuals.
Existing Conditions Aggravated
By Exposure: None known.
Page 2 of 3
MATERIAL SAFETY DATA SHEET 670A
Adhesive
8/15/2003
Exposure Limits (STEL) ACGIH OSHA
Ingredients 6(TLV) (PEL)
Ingredients for which no Exposure Limits have been established are not listed above.
Literature Referenced Carcinogen
Ingredients Target Organ and Other Health Effects NTP IARC OSHA
Polyurethane methacrylate resin No Data NO NO NO
High boiling acrylate No Data NO NO NO
Hydroxyalkyl methacrylate No Data NO NO NO
METHACRYLIC ACID IRR NO NO NO
Modified silicone dioxide No Data NO NO NO
MUT NO NO NO
Tert-BUTYL PEROXYBENZOATE
MALEIC ACID IRR NO NO NO
SACCHARIN MUT YES 2B NO
Abbreviations
2B Possibly carcinogenic to humans IRR Irritant
MUT Mutagen
DISCLAIMER
THE INFORMATION AND RECOMMENDATIONS PROVIDED HEREIN ARE BELIEVED TO BE
ACCURATE AS OF THE DATE HEREOF. HOWEVER, SUCH INFORMATION AND RECOMMENDATIONS
ARE PROVIDED WITHOUT WARRANTY OF ANY KIND AND INTERNATIONAL EPOXIES & SEALERS,
DISCLAIMS ANY AND ALL LIABILITY OR LEGAL RESPONSIBLITY
FOR USE OR RELIANCE UPON SAME.
Page 3 of 3
ALL Chemical Property And Toxicity Analysis PAGES IN THIS GROUP