MATERIAL SAFETY DATA SHEET
I. PRODUCT IDENTIFICATION
Name: Henry 971 PlankPro鈩? Moisture Cure Urethane Wood Adhesive
971
Description: Urethane Adhesive
II. DEPT. OF TRANSPORTATION INFORMATION
Prepared 3/00 - Replaces 1/00
SHIPPING NAME: Not classified. HAZARD CLASS: N/A. ID#: N/A.
EMERGENCY ONLY CONTACT: CHEM-TEL-1-800-255-3924
The W.W. Henry Company
III. HMIS (0=minimal hazard; 4 = severe hazard)
400 Ardex Park Drive
Health = 2 Flammability = 1 Reactivity = 1
Aliquippa, PA 15001
IV. PRODUCT CONTENT
(724) 203-8499
Visit our Website: http://www.wwhenry.com
This product does contain chemicals subject to the reporting require-
ments of Section 313 of SARA Title III and 40 CFR 372. All components
are on TSCA inventory. This product does NOT contain asbestos.
V. HAZARDOUS INGREDIENTS
INGREDIENT: PERCENT: OCCUP. EXPOS. LMT.
TLV: PEL:
As MDI: As MDI:
4,4鈥?-Diphenylmethane, Diisocyanate 1 0.005 ppm 0.02 ppm (Ceiling)
(Polymeric) CAS# 9016-87-9
mist and other hazardous organic compounds. HAZARDOUS POLYMER-
VI. PHYSICAL DATA
IZATION: Hazardous polymerization will not occur.
APPEARANCE: Brown. BOILING POINT: N/A. MELTING POINT: N/A
X. SPILL OR LEAK PROCEDURES
VAPOR PRESSURE (mm Hg @ TEMP): N/A. VAPOR DENSITY (Air = 1):
N/A. % VOLATILE BY WEIGHT (30 min. @ 275掳F): N/A. EVAPORATION
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Ventilate
RATE (Butyl Acetate = 1): N/A. WT/GAL (water =8.3): 10.71 lb. SOLUBILI-
area of spill or release. Contain spill, preventing it from entering sewer
TY IN WATER: Nil. SPECIFIC GRAVITY: 1.29. VOC: 77g/l -- calculated
lines or waterways. Use absorbent, such as clay, to assist with the pick-up
and reported, SCAQMD 1168.
of material. Wear eye protection and other personal protective equipment
to prevent eye and skin contact. Prevent contact with shoes and other
VII. FIRE AND EXPLOSION HAZARD DATA
leather wearing apparel. Place material into containers. WASTE DISPOS-
AL METHOD: Dispose of container and any unused contents in accor-
FLASH POINT (METHOD): >200掳F (Setaflash). FLAMMABLE RANGE:
dance with Federal, State, and Local Waste Disposal Regulations. Do not
LEL: N/A; UEL: N/A. EXTINGUISHING MEDIA: Carbon dioxide, dry
flush unused contents or residue down drains. Do not reuse container.
chemical, water spray. SPECIAL FIRE FIGHTING PROCEDURES: Protect
fire fighters from toxic products of combustion by wearing self-contained
XI. SPECIAL HANDLING AND USE INFORMATION
breathing apparatus. UNUSUAL FIRE AND EXPLOSION HAZARDS:
Closed containers in a fire may rupture due to pressure build-up; use
VENTILATION: Local mechanical ventilation should be provided where
water to cool containers to prevent this.
material is used. During use, ventilation arrangement should capture and
remove the vapors or contaminants before they reach the breathing zone.
VIII. HEALTH HAZARD DATA
RESPIRATORY PROTECTION: With adequate ventilation, respiratory
equipment should not be needed. If adequate ventilation is not afforded,
PRIMARY ROUTE(S) OF ENTRY: Inhalation, and direct dermal exposure.
wear respiratory equipment approved for organic vapor. SKIN AND EYE
TARGET ORGANS: Upper respiratory tract, skin, eyes. EFFECTS OF
PROTECTION: During the handling of this product, impervious gloves and
OVEREXPOSURE: SKIN AND EYES: Primary hazard is contact with skin
eye protection should be utilized to prevent skin and eye contact.
and eyes which may cause irritation and dermatitis; sensitization may
also occur -- once sensitized, an adverse reaction can occur with expo-
XII. SPECIAL PRECAUTIONS
sure to small amounts by either vapor or direct contact. Skin absorption
has not been known to occur with this product - primarily because skin
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Store in an
contact must be avoided due to the primary irritation and sensitization
area suitable for combustible mixtures. Recommended storage temperature
properties. INHALATION: Irritating effects through inhalation have not
is below 90掳F. OTHER PRECAUTIONS: None. WORK SITE ENVIRONMENT:
been known to occur at ambient temperature with this product. At high
Initially there may be a potential adverse impact on indoor air quality with-
temperatures, the material may cause nose and throat irritation.
in the general work area during the installation process. Therefore you should
CARCINOGENICITY: NTP: No; IARC Monographs: No; OSHA
advise the building manager or other appropriate person that: 鈥? It will be
Regulated: No; MEDICAL CONDITIONS GENERALLY AGGRAVATED
necessary to establish and maintain adequate ventilation of the work area,
BY EXPOSURE: N/K; FIRST AID PROCEDURES: SKIN AND EYES: In
without causing the entry of contaminants to other parts of building; and 鈥?
case of eye contact, flush eyes repeatedly with water for 15 minutes and
Persons who are sensitive to odors and/or chemicals should be advised to
get immediate medical attention. In case of skin contact, flush with cool
avoid the work area during this process.
water, then wash with water and soap; see a physician if symptoms or
irritation persist. INHALATION: In case of inhalation of product, remove
The information presented herein is supplied as a guide to those who han-
to fresh air and see a physician if symptoms persist. INGESTION: Do not
dle or use this product. Safe work practices must be employed when
induce vomiting. Call a Poison Control Center or physician for guidance.
working with any materials. It is important that the end user makes a
determination regarding the adequacy of the safety procedures employed
IX. REACTIVITY DATA
during the use of this product.
STABILITY: This product is stable. INCOMPATIBILITY: Water, acids, bases,
N/A - not applicable or not available
alcohols, metal compounds. Avoid water as it reacts to generate heat,
N/K - none known or not known
CO2, and insoluble urea. The reaction with water is slow at temperatures
less than 120掳F, but accelerated at higher temperatures and in the pres-
ence of the above mentioned materials. HAZARDOUS DECOMPOSI-
TION PRODUCTS: Excessive heating can produce isocyanate vapor,
|