MATERIAL SAFETY DATA SHEET
I. PRODUCT IDENTIFICATION
Name: Henry 972 Urethane Adhesive Remover
972
Description: Solvent based adhesive remover
II. DEPT. OF TRANSPORTATION INFORMATION
Prepared 1/00
SHIPPING NAME: Not classified. HAZARD CLASS: N/A. ID#: N/A.
EMERGENCY ONLY CONTACT: CHEM-TEL-1-800-255-3924
The W.W. Henry Company
III. HMIS (0=minimal hazard; 4 = severe hazard)
400 Ardex Park Drive
Health = 2 Flammability = 2 Reactivity = 0
Aliquippa, PA 15001
IV. PRODUCT CONTENT
(724) 203-8499
Visit our Website: http://www.wwhenry.com
This product does not contain chemicals subject to the reporting require-
ments of Section 313 of SARA Title III and 40 CFR 372. All components
are on TSCA inventory. This product does NOT contain asbestos.
V. HAZARDOUS INGREDIENTS
INGREDIENT: PERCENT: OCCUP. EXPOS. LMT.
TLV: PEL:
Dipropylene glycol methyl ether 25-30 100 ppm 100 ppm
CAS #34590-94-8 STEL: STEL:
150 ppm 150 ppm
(Skin) (Skin)
Propylene glycol normal butyl ether 25-30 N/A N/A
CAS# 5131-66-8
Terpene Hydrocarbons 20-30 N/A N/A
CAS# 5989-27-5
VI. PHYSICAL DATA X. SPILL OR LEAK PROCEDURES
APPEARANCE: Clear, colorless. ODOR: Citrus odor. BOILING POINT: STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Ventilate
350掳F. MELTING POINT: N/A VAPOR PRESSURE (mm Hg @ 20掳C): 1.0 area of spill or release. Contain spill, preventing it from entering sewer
VAPOR DENSITY: 4.1 EVAPORATION RATE: 1.0. WT/GAL (water =8.3): lines or waterways. Use absorbent to assist with the pick-up of material.
7.4 lb. SOLUBILITY IN WATER: Soluble. SPECIFIC GRAVITY: 0.88 - 90. Scrape up product and place into container. Residual of product, while
still wet, can be cleaned up with warm soapy water. WASTE DISPOSAL
VII. FIRE AND EXPLOSION HAZARD DATA METHOD: Dispose of container and any unused contents in accordance
with Federal, State, and Local Waste Disposal Regulations. Do not flush
FLASH POINT (METHOD): 145掳F (COC). FLAMMABLE RANGE: LEL: unused contents or residue down drains. Do not reuse container
0.6; UEL: 14. EXTINGUISHING MEDIA: Foam, carbon dioxide, dry
chemical, water spray. SPECIAL FIRE FIGHTING PROCEDURES: Protect XI. SPECIAL HANDLING AND USE INFORMATION
fire fighters from toxic products of combustion by wearing self-contained
breathing apparatus. UNUSUAL FIRE AND EXPLOSION HAZARDS: VENTILATION: Use natural cross-ventilation, local (mechanical) pick-up,
Closed containers in a fire may rupture due to pressure build-up; use and/or general area (mechanical) ventilation to prevent an accumulation of
water to cool containers to prevent this. solvent vapors, keeping in mind that the ventilation pattern must remove
the heavier-than-air solvent vapors from the lower levels of the work
VIII. HEALTH HAZARD DATA spaces. The ventilation should be sufficient to keep the solvent vapor con-
centration below the TLV. RESPIRATORY PROTECTION: With adequate
PRIMARY ROUTE(S) OF ENTRY: Inhalation, ingestion, and direct dermal ventilation, respiratory equipment should not be needed. If adequate ven-
exposure. TARGET ORGANS: Upper respiratory tract, skin, eyes. tilation is not afforded, wear respiratory equipment approved for organic
EFFECTS OF OVEREXPOSURE: SKIN AND EYES: Excessive skin contact vapors. SKIN AND EYE PROTECTION: Avoid prolonged contact with skin,
may cause drying and cracking of the skin, defatting of tissue, and result and contact with eyes. Wear solvent resistant gloves and spectacle-type
in dermatitis. Contact with eyes may cause irritation. INHALATION: safety glasses are recommended to prevent contact with this product.
May cause irritation of respiratory tract, coughing, and CNS effects such
as headache, dizziness, drowsiness or nausea. CARCINOGENICITY: XII. SPECIAL PRECAUTIONS
NTP: No; IARC Monographs: No; OSHA Regulated: No; MEDICAL
CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: Any condi- PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Store in
tion generally aggravated by solvents, including preexisting upper respi- an area suitable for flammable mixtures. Recommended storage tempera-
ratory and lung disease such as, but not limited to bronchitis, emphyse- ture is below 90掳 F. OTHER PRECAUTIONS: Vapors are flammable and
ma, and asthma. Existing skin conditions. FIRST AID PROCEDURES: are heavier-than-air. Prohibit smoking and eliminate all other sources of
SKIN AND EYES: Flush any eye contact with plenty of water. ignition, such as regular electrical tools and appliances, making sure that
Additionally with skin contact, wash with soap and water. Refer to pilots on gas-fired water heaters are extinguished. WORK SITE ENVI-
physician if irritation or symptoms persist. INHALATION: Remove to RONMENT: Initially there may be a potential adverse impact on indoor
fresh air if exposed to excess concentrations of vapor. Seek medical air quality within the general work area during the installation process.
attention if symptoms persist. INGESTION: Do not induce vomiting. Therefore you should advise the building manager or other appropriate
Call a Poison Control Center or physician for guidance. person that: 鈥? It will be necessary to establish and maintain adequate ven-
tilation of the work area, without causing the entry of contaminants to
IX. REACTIVITY DATA other parts of building; and 鈥? Persons who are sensitive to odors and/or
chemicals should be advised to avoid the work area during this process.
STABILITY: Stable. INCOMPATIBILITY: Strong oxidizing agents.
HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide, The information presented herein is supplied as a guide to those who han-
carbon dioxide, and other toxic vapors and gases that are common to dle or use this product. Safe work practices must be employed when
thermal degradation of organic compounds. HAZARDOUS POLYMER- working with any materials. It is important that the end user makes a
IZATION: Will not occur. determination regarding the adequacy of the safety procedures employed
during the use of this product.
N/A - not applicable or not available
N/K - none known or not known
|