HENRY COMPANY CANADA INC.
10 St-Pierre, Lachine, Quebec H8R 1N7
Tel.:(514) 364-5224 Fax:(514)364-7270
EMERGENCY TEL. NO.: (514) 364-5224
MATERIAL SAFETY DATA SHEET
WHMIS: B-3, D-2B
I - PRODUCT INFORMATION
Bakor 710-11 Summer / 710-11 Winter
PRODUCT NAME
Asphalt/Solvent Cutback
PRODUCT TYPE
Used as a heavy duty protective coating on masonry or concrete
PRODUCT USE
II - HAZARDOUS INGREDIENTS
INGREDIENTS % CAS # EXPOSURE LIMITS LD50/LC50(SPECIES & ROUTE)
Stoddard Solvent 30-60 8052-41-3 100 ppm, TLV LD50(oral-rat) > 5000 mg/kg
LC50(inhal.-rat) > 5g/m3
III - PHYSICAL DATA
PHYSICAL [ ] GAS ODOUR & APPEARANCE ODOUR THRESHOLD (ppm)
Black liquid, petroleum odour. Not available
STATE [x] LIQUID
[ ] SOLID
VOC
VOLATILE (VOL.) VAPOUR PRESSURE (mm Hg) VAPOUR DENSITY (AIR = 1) EVAPORATION RATE (BuAc=1)
38 - 43% < 410 g/L 7 at 38掳C 3.9 0.10-0.15
BOILING POINT (掳C) FREEZING POINT (掳C) SPEC. GRAVITY (WATER - 1) DENSITY (g / ml)
150 - 204掳C Not applicable 0.93 0.93
SOLUBILITY (IN WATER) COEF. OF WATER/OIL DIST. pH
Insoluble Not available Not applicable
IV - FIRE & EXPLOSION HAZARD
FLAMMABILITY [ X ] YES CONDITIONS OF FLAMMABILITY
Avoid excessive heat and open flames.
[ ] NO
41掳C
FLASH POINT (掳C): FLAMMABLE LIMITS (% VOLUME) AUTO-IGNITION TEMP. (掳C)
PMCC 1.0 6.0 245掳C for solvent
METHOD: LOWER: UPPER:
TDG FLAMMABILITY CLASS SENSITIVITY TO MECHANICAL IMPACT SENSITIVITY TO STATIC DISCHARGE
Class 3, PG III None If product above flash point.
On burning some SO2 and traces of CO.
HAZARDOUS COMBUSTION
Main combustion products are H2O, CO2 and C (as heavy smoke).
PRODUCTS
Foam , carbon dioxide, dry chemicals, water spray (for small fires).
MEANS OF EXTINCTION
Contain spill. Cover with extinguishing agents. Use water spray to cool fire-exposed containers.
SPEC. FIRE FIGHTING PROCEDURES
Self-contained equipment and full protective clothing when fumes or smoke are present.
V - PREPARATION OF M.S.D.S.
PREPARED BY: PHONE NUMBER DATE
WHMIS Group (514) 364-5224 May 2006
VI - REACTIVITY DATA Bakor 710-11 Summer, 鈥?
CHEMICAL [ X ] YES CONDITIONS TO AVOID:
Sources of ignition, excessive heat approaching flash point.
STABILITY [ ] NO
Strong oxidizing agents may ignite the product.
INCOMPATIBILITY
(SUBSTANCE TO AVOID)
None.
CONDITIONS
OF REACTIVITY
Will not decompose under normal conditions of handling and warehousing.
HAZARDOUS DECOMPOS-
ITION PRODUCTS
VII - TOXICOLOGICAL PROPERTIES
LD50(oral-rat) > 5000 mg/kg
THRESHOLD LIMIT VALUE LC50/LD50 (estimated)
100 ppm LC50(inhal.-rat) > 5g/m3
ROUTE OF ENTRY [ ] SKIN CONTACT [ ] SKIN ABS. [x] EYES [x] INGESTION [x] INHALATION
Inhalation of high concentrations of vapours can cause headache, dizziness, nausea and unconsciousness.
EFFECTS OF ACUTE
Can cause gastro-intestinal irritations, nausea, vomiting, diarrhea, if ingested in large quantity.
EXPOSURE
Prolonged or repeated skin contact may cause severe skin problems such as lesions or dermatitis.
EFFECTS OF
Vapours may also irritate eyes, nose and throat.
CHRONIC EXPOSURE
Skin irritancy after prolonged or
IRRITANCY SENSITIZATION SYNERGISTIC MATERIALS
repeated contacts. Not available Not available
[ ] CARCINOGENICITY [ ] REPRODUCTIVE EFFECTS [ ] TERATOGENICITY [ ] MUTAGENICITY
Not believed to cause any of these effects.
VIII - FIRST AID MEASURES
Thoroughly wash exposed areas with waterless cleaner or soap and water.
SKIN
Flush eyes thoroughly with plenty of lukewarm water. Get medical attention
EYES
immediately.
Remove victim to fresh air. Administer artificial respiration if breathing has stopped, administer oxygen.
INHALATION
Consult a physician immediately.
DO NOT INDUCE VOMITING. If vomiting occurs, take care to prevent aspiration into lungs. Force
INGESTION
fluids, activated charcoal tablets. Obtain medical attention immediately.
IX - PREVENTIVE MEASURES
Goggles if applied by spray.
EYES:
Suggested (neoprene, nitrile).
PERSONAL GLOVES:
Oil resistant apron and/or clothing if drect contact is likely.
PROTECTIVE CLOTHING:
Use approved, organic vapour mask in confined areas or if applied by spray.
EQUIPMENT RESPIRATORY:
Ventilation required in confined areas. Local exhaust, if necessary, to maintain TLV.
ENGINEERING CONTROLS
(VENTILATION, ETC.)
Avoid breathing fumes and contact with skin and eyes. Avoid sources of ignition.
LEAK AND SPILL
Contain with absorbent solids such as sand, earth, etc. Transfer into disposable containers.
PROCEDURE
WASTE
Bury in approved landfill or burn in approved incinerator as per state, federal and provincial regulations.
DISPOSAL
Normal
HANDLING PROCEDURES
Store in cool, well ventilated areas. Keep away from ignition souces.
STORAGE REQUIREMENTS
TDG regulations not applicable for shipments on a road vehicle, a railway vehicle or a ship on a domestic
SHIPPING INFORMATION
voyage if shipped in means of containment of 450L or less. Tars, liquid; UN1999; Class3, Packing Group III.
While Henry Company Canada Inc. believes that the data contained herein are factual & opinionsexpressed are those of qualified experts regarding the results of the
tests conducted, the data is not to be taken as warranty or representation for which Henry Company Canada Inc. assumes legal responsibility. These are offered solely
for your consideration, investigation and verification. Any use of this data and information must be determined by the user to be in accordance with federal,
provincial or municipal laws and regulations.
|