MATERIAL SAFETY DATA SHEET Page: 1
Printed: 11/17/2005
Adams Water-Based Flea & Tick Mist Revision: 10/17/2005
1. Product and Company Identification
270-348
Product Code:
Adams Water-Based Flea & Tick Mist
Product Name:
6615
Reference #:
Manufacturer Information
DISTRIBUTED BY:
Company Name:
FARNAM COMPANIES, INC.
301 WEST OSBORN
PHOENIX, AZ 85013
BUSINESS HOURS (800)825-2555
Emergency Contact:
ANYTIME RESPONSE NUMBER (602)285-1660
Alternate Emergency Contact:
Sherry Faith
Preparer Name:
2. Composition/Information on Ingredients
Hazardous Components (Chemical Name) CAS # Percentage OSHA PEL ACGIH TLV Other Limits
1. Permethrin 52645-53-1 0.2 %
2. Pyrethrins and Pyrethroids 8003-34-7 0.2 %
3. Piperonyl butoxide 51-03-6 0.5 %
4. N-OCTYL BICYCLOHEPTENE 113-48-4 2.0 %
DICARBOXIMIDE
5. Dipropyl isocinchomeronate 136-45-8 1.0 %
6. BUTOXY POLYPROPYLENE GLYCOL 9003-13-8 5.0 %
3. Hazards Identification
Emergency Overview
Inhalation? Yes Skin? Yes Eyes? Yes Ingestion? Yes
Route(s) of Entry:
Potential Health Effects (Acute and Chronic)
Oral LD 50 is > 5000 mg/kg in rats
LD 50/LC 50:
Signs and Symptoms Of Exposure
SKIN CONTACT: Irritation may occur following direct contact. Symptoms might include itching redness, or
swelling.
EYE CONTACT: Irritation may occur following direct contact. Symptoms might include redness, swelling or
discharge.
INHALATION: Mist or vapor is not expected to be toxic. However, inhalation should be avoided.
INGESTION: Toxicity following ingestion is not expected. However, ingestion should be avoided.
Medical Conditions Generally Aggravated By Exposure
None known
4. First Aid Measures
Emergency and First Aid Procedures
SKIN CONTACT: Wash exposed area with soap and water, remove contaminated clothing and obtain medical
assistance if irritation occurs.
EYE CONTACT: Wash eyes with water for at least 15 minutes then obtain medical assistance.
INHALATION: Move exposed person to fresh air. Refer to a physician if subject experiences difficulty
breathing. If breathing has stopped institute basic life support and seek immediate medical assistance.
INGESTION: In the event of swallowing this material do not induce vomiting. Treat subject symptomatically
and supportively. Get immediate medical assistance.
NOTE TO PHYSICIAN: This material contains pyrethrin insecticides. In cases of over exposure, consult a
poison control center for additional information concerning pyrethrin poisoning and treatment.
ANTIDOTES: NONE
Licensed to Farnam Companies: MIRS MSDS, (c) A V Systems, Inc. ANSI Z400.1 Format
MATERIAL SAFETY DATA SHEET Page: 2
Printed: 11/17/2005
Adams Water-Based Flea & Tick Mist Revision: 10/17/2005
5. Fire Fighting Measures
N.A.
Flash Pt:
LEL: UEL:
Explosive Limits:
N.A.
Autoignition Pt:
Fire Fighting Instructions
Self-contained breathing apparatus and full protective gear. Toxic or corrosive gases can be expected in fires of
this material.
Flammable Properties and Hazards
None known
Extinguishing Media
Water
Unsuitable Extinguishing Media
6. Accidental Release Measures
Steps To Be Taken In Case Material Is Released Or Spilled
For large spills, isolate the spill area, restrict access and post the area for hazards present (skin irritant, eye irritant)
and necessary precautions. Wear appropriate protective equipment to avoid skin contact and eye contact. Mix
with sand or absorbent material and scoop or shovel into a suitable, properly labeled container for recovery or
disposal.
7. Handling and Storage
Hazard Label Information:
Temperatures greater than 350 degrees Store away from heat, sparks & flames Corrosive to metals.
Precautions To Be Taken in Handling
HANDLING: Use with adequate ventilation.
STORAGE: Store in a cool, dry place away from heat, open flames and other containers of food or feed.
Do not transfer to other containers.
8. Exposure Controls/Personal Protection
Protective Equipment Summary - Hazard Label Information:
Clothes to prevent skin contact
Respiratory Equipment (Specify Type)
An oppropriate respirator should be used if respiratory discomfort occurs. For U.S. operations, OSHA 29 CFR
1910.134 must be followed if respirator use is employed in the workplace. For non U.S. operations, review
pertinent local regulations.
Eye Protection
Glasses or goggles are recommended if eye contact is possible.
Protective Gloves
Avoid skin contact or wear impervious gloves when handling this material.
Other Protective Clothing
Wear clothing with long sleeves to avoid skin contact.
Engineering Controls (Ventilation etc.)
Work/Hygienic/Maintenance Practices
Wash hands and arms thoroughly after handling this material. Clean up spills immediately.
9. Physical and Chemical Properties
[ ] Gas [ X ] Liquid [ ] Solid
Physical States:
-2.00 C - 0.00 C
Melting Point:
Licensed to Farnam Companies: MIRS MSDS, (c) A V Systems, Inc. ANSI Z400.1 Format
MATERIAL SAFETY DATA SHEET Page: 3
Printed: 11/17/2005
Adams Water-Based Flea & Tick Mist Revision: 10/17/2005
99.00 C - 100.00 C
Boiling Point:
N.A.
Autoignition Pt:
N.A. Method:
Flash Pt:
LEL: UEL:
Explosive Limits:
1.005
Specific Gravity (Water = 1):
1
Evaporation Rate (vs Butyl
Acetate=1):
Completely soluble/water
Other Solubility Notes:
N.A.
Percent Volatile:
Appearance and Odor
Cream colored liquid with a light fragrance
10. Stability and Reactivity
Unstable [ ] Stable [ X ]
Stability:
Conditions To Avoid - Instability
None known
Incompatibility - Materials To Avoid
None known
Hazardous Decomposition Or Byproducts
None known
Will occur [ ] Will not occur [ X ]
Hazardous Polymerization:
Conditions To Avoid - Hazardous Polymerization
Product will not undergo polymerization.
11. Toxicological Information
Toxicological Information
Carcinogenicity/Other Information
No components are listed as carcinogens by IARC, NTP, or OSHA.
NTP? No IARC Monographs? No OSHA Regulated? No
Carcinogenicity:
12. Ecological Information
Ecological Information
13. Disposal Considerations
Waste Disposal Method
Do not reuse empty containers. Observe all federal, state and local regulations when disposing of this material.
14. Transport Information
LAND TRANSPORT (US DOT)
DOT Proper Shipping Name
15. Regulatory Information
No data available.
16. Other Information
Additional Information About This Product
ECOLOGICAL INFORMATION:
This mixture contains material that is toxic to fish.
Company Policy or Disclaimer
The information and data herein are believed to be accurate and have been compiled from sources believed to be
reliable. It is offered for your consideration, investigation and verification.
Licensed to Farnam Companies: MIRS MSDS, (c) A V Systems, Inc. ANSI Z400.1 Format
|