SECTION V HEALTH HAZARD DATA
MATERIAL SAFETY DATA SHEET FF266
Threshold Limited Value
ALDON Methanol: STEL 250 ppm, 328 mg/m3
1533 W.Henrietta Rd.
FF 266
Avon, New York 14414 MSDS No.
庐
CORPORATION December 5, 1996
Effective Date
(716) 226-6177
Effects of Overexposure
Toxic effects are mainly those of irritation. If swallowed it causes violent
vomiting and diarrhea which can lead to collapse. Frequent or prolonged
SECTION I NAME 24 HOUR EMERGENCY ASSISTANCE exposure can cause hypersensitivity.
Product FORMALDEHYDE SOLUTION, 10% CHEMTREC
2 3
Health
800-424-9300
Chemical
Emergency and
2 0
Formalin 4% w/w Neutralized EYES: Flush thoroughly with water for at least 15 minutes, lifting upper and
Synonyms 0
Fire
Day 716-226-6177
lower eyelids occasionally. Get immediate medical attention. SKIN: Flush
First Aid Procedures
Formula Mixture. thoroughly with water, then wash with mild soap and water. If irritation occurs
0
Reactivity
NFPA get medical attention. INHALATION: Remove to fresh air. If not breathing,
HAZARD RATING HMIS * give artificial respiration. If breathing is difficult, give oxygen. Get medical
Unit Size up to 4 Lt.
attention. INGESTION: If swallowed, if conscious, give one or two glasses of
LEAST SLIGHT MODERATE HIGH EXTREME
water to drink. Induce vomiting. Repeat until vomit fluid is clear. Get
0 1 2 3 4
C.A.S. No. Mixture.
immediate medical attention. Never give anything by mouth to an unconscious
person.
SECTION II INGREDIENTS OF MIXTURES
SECTION VI REACTIVITY DATA
Principal Component(s) % TLV Units
Conditions to Avoid
Stability Unstable
Formaldehyde: (CAS No. 50-00-0) 3.7% TWA: 0.3 ppm; 0.37 mg/m3 Excessive temperature to cause
Sodium phosphate, monobasic: (CAS No. 10049-21-5) 0.4% None established. evaporation.
Stable X
Sodium phosphate, dibasic: (CAS No. 7558-79-4) 0.65% None established.
Incompatibility
Methyl alcohol: (CAS No. 67-56-1) 1.2% TWA: 200 ppm; 262 mg/m3 Strong acids, phenols, strong oxidizers, hydrochloric acid, ammonia, iodine, alkalies,
tannin, iron products, gelatin, bisulfite.
(Materials to Avoid)
Water: CAS No. 7732-18-5) 94.05% None established.
Hazardous
WARNING! HARMFUL IF INHALED, SWALLOWED OR Thermal decomposition or burning may produce irritating formaldehyde
ABSORBED THROUGH SKIN. MAY CAUSE IRRITATION. vapor or carbon monoxide.
Decomposition Products
SECTION III PHYSICAL DATA
Conditions to Avoid
Hazardous Polymerization
Specific Gravity (H2O = 1)
Melting Point (掳F) Freezes approx. 0掳C (68掳F) Approx. 1.0
May Occur Will Not Occur Not applicable.
Percent Volatile
Boiling Point (掳F) Approx. 100掳C (212掳F) 94.05% X
by Volume (%)
Evaporation Rate
SECTION VII SPILL OR LEAK PROCEDURES
Vapor Pressure (mm Hg) 14 (water) water Slightly < 1
=1)
(
Steps to be taken in case
Vapor Density (Air=1) 0.7 (water)
Absorb spill with an inert dry material and place in a suitable
material is released or spilled
container for disposal. Flush spill area with water. Wash with
Solubility in Water Complete.
dilute ammonia solution to remove any residual odor.
Appearance & Odor Clear, colorless liquid; strong irritating aldehyde odor.
Discharge, treatment, or disposal may be subject to Federal, State or Local laws.
Waste Disposal Method
SECTION IV FIRE AND EXPLOSION HAZARD DATA These disposal guidelines are intended for the disposal of catalog-size quantities only.
Lower
Flammable Limits in Air Upper
Flash Point
Dispose of in an approved incinerator equipped with an afterburner and scrubber or in an approved chemical
Flammable liquid. N/A
% by Volume
(Method Used)
landfill. If at-site treatment or disposal facility are not available, contract with a licensed waste disposal agency.
Extinguisher
SECTION VIII SPECIAL PROTECTION INFORMATION
Use water spray; dry chemical; foam; carbon dioxide (CO2).
Media
For laboratory use work in fume hood or wear NIOSH/MSHA-approved cartridge
Respiration Protection
respirator for organic vapors.
(Specify Type)
SPECIAL FIREFIGHTING
Yes. No.
Local Exhaust Special
PROCEDURES Ventilation
In fire conditions, wear a NIOSH/MSHA-approved self-contained Yes. Adequate to maintain below exposure limit.
Mechanical (General) Other
breathing apparatus and full protective clothing. Wear goggles if
Protective Gloves Eye Protection
Rubber. Splash proof goggles or face shield.
eye protection is not provided.
Other Protective
Lab coat, apron, goggles, gloves, eye wash station, ventilation hood, fire extinguisher.
Equipment
SECTION IX SPECIAL PRECAUTIONS
(1993 EMERGENCY RESPONSE GUIDEBOOK, DOT P 5800.6, GUIDE PAGE NO. 29)
Precautions to be Taken Store in a cool, dry place. Keep away from heat and flame. Avoid
UNUSUAL FIRE AND in Handling & Storing breathing vapors or mist. Avoid contact with skin and clothing.
EXPLOSION HAZARDS Wash thoroughly after handling.
Keep container tightly closed when not in use.
In fire conditions, water may evaporate from this solution, which may Read label on container before using. Do not wear contact lenses when working with chemicals.
Other Precautions
cause hazardous decomposition products to be produced as dust or
fume. Remove and wash contaminated clothing before reuse.
For laboratory use only. Not for drug, food or household use. Keep out of reach of children.
Chemical Safety
Approved
Revision Date Michael Raszeja MR
No. 1 12/05/96 Coordinator
D.O.T. Formaldehyde, solution, flammable, 3, UN 1198, PG III The information contained herein is furnished without warranty of any kind. Employers should use this information only as a supplement to other information
gathered by them and must make independent determinations of suitability and completeness of information from all sources to assure proper use of these
Approved by U.S. Department of Labor "essentially similar" to form OSHA-20 materials and the safety and health of employees. * Hazardous Materials Industrial Standards. Printed on recycled paper.
|