QUICKCABLE
Material Safety Data Sheet (MSDS)
Description: Heat Shrink Part Number: 5611-5616, 5657-6671
SECTION I
CONTACT INFORMATION
Date: May 2000
Quick Cable Corporation
3700 Quick Cable Drive, Franksville, WI 53126
Telephone: 1-800-558-8667
Emergency Telephone: INFOTRAC 1-800-535-5053 Quick Cable Product I.D.: 5611-5616, 5657-6671
SECTION II
HAZARDOUS INGREDIENTS/IDENTITY INFORMATION
*This product is a manufactured article and, as such, is exempt from the hazardous products act.
**Overheating to temperatures above 200潞C for long periods of time may cause the release of irritating and toxic fumes.
SECTION III
PHYSICAL/CHEMICAL CHARACTERISTICS
Physical State: Solid Freezing Point: N/A
Odor and Appearance: Plastic tube, almost odorless, with adhesive lining Melting Point: N/A
Odor Threshold (ppm): N/A pH: N/A
Vapor Pressure (mmHg): N/A Specific Gravity (H2O=1): 1.34-.05
Vapor Density (air=1): N/A Coefficient: N/A
Evaporation Rate: N/A Oil Distribution: N/A
Boiling Point: N/A Solubility in Water: Insoluble
SECTION IV
FIRE AND EXPLOSION HAZARD DATA
Flammability Class: N/A LFL: N/A
Extinguishing Media: Water spray, Dry chemical, Foam, Carbon Dioxide UFL: N/A
Flash Point: N/A
SECTION V
REACTIVITY DATA
Stability: Stable
Conditions to Avoid: Decomposes at elevated temperatures
Hazardous Decomposition Products: May produce oxides of carbon, sulphur, nitrogen, acetic acid, antimony and hydrogen halides,
acid aldehydes, & vinyl acetate
Hazardous Polymerization: None
Incompatibility: Strong oxidizers
SECTION VI
HEALTH HAZARD DATA
Primary Routes of Exposure: None Irritancy of Material: Mild
Skin Contact: No unusual dermatitis hazard expected. Hot adhesive can cause burns Sensitizing Capability: No
Skin Absorption: None Carcinogenicity of Material: No
Eye Contact: Mechanical Irritation Reproductive Effects: No
Inhalation: None Teratogenicity: No
Ingestion: Low toxicity expected Mutagenicity: No
Effects of Acute Exposure: See Above Synergistic Materials: No
Effects of Chronic Exposure: None Known
First Aid Procedures: Eyes: Flush with water for 5 minutes; Skin: In the event of a burn with hot adhesive, immerse the affected part in
clean, cold, water and seek medical attention. Do not pull off adhesive; Inhalation: If exposed to fumes/gases from overheating, or
burning, remove to fresh air and seek medical advice; Ingestion: Low toxicity expected.
SECTION VII
PRECAUTIONS FOR SAFE HANDLING AND USE
Spill Procedures: Not Applicable
Waste disposal Method: Do not incinerate, landfill or incinerate in compliance with all federal, provincial, and local regulations
Handling Procedures and Equipment: Avoid overheating materials above decomposition temperatures. Do not breath fumes produced
during overheating or burning.
Storage Needs: Cool dry environment
Special Shipping Instructions: Not Regulated
SECTION VIII
CONTROL MEASURES
Protective Gloves: Wear gloves to protect from thermal burns
Respiratory Protection: Not required with adequate general ventilation
Eye Protection: Safety glasses during flame heating
Footwear: None
Clothing: Fire retardant clothing is recommended
Ventilation Type: General ventilation is adequate
Engineering Controls: General ventilation should be adequate. Use of local ventilation may be required where overheating is expected
SECTION IX
OTHER REGULATORY INFORMATION
This information is accurate to the best of Quick Cable Corporation鈥檚 knowledge or obtained from sources believed by
Quick Cable to be accurate. Before using this product, read all warnings and directions on the label.
|