NORTHSTAR
150 Series
Acrylic Enamel Topcoat
DESCRIPTION
The 100 Series is a medium solids, modified acrylic enamel topcoat, which offers very good gloss with
excellent dry times. The 150 Series is compliant with the National VOC rules.
COMPONENTS
150 Series color Base
鈥?
H150/H155/H47 Hardener (optional)
鈥?
S9860/9870/9885/9895 Reducers
鈥?
MIXING RATIO
For enhanced performance, mix eight (8) parts 150 Series color with one (1) part H150/155/47
hardener. May be reduced up to 25% by volume with S9860/9870/9885/9895.
POT LIFE @ 77掳 F
4 hours with hardener
CLEAN UP
Use NORTHSTAR Lacquer Thinner. (Check local regulations.)
PHYSICAL DATA
Volume solids as mixed 36% (average of colors)
VOC as mixed 4.4
Color Full intermix from SHS tints
DRY / FLASH TIMES
Air Dry @ 77掳 F
Flash between coats 10-15 minutes
Tape time Over night
Dust free 30 minutes
Tack free 45 minutes
Tack free with Hardener I hour
Force Dry
Flash before force dry 15 minutes flash
Force dry time 30 minutes @ 140掳 F
GUN SETUPS
Conventional
Gravity Feed 1.3 mm 鈥? 1.6 mm
Siphon Feed 1.3 mm 鈥? 1.6 mm
AIR PRESSURES
Conventional @ Gun
Gravity Feed 35 鈥? 45 psi
Siphon Feed 40 鈥? 50 psi
HVLP @ cap 8 鈥? 10 psi
SURFACE PREPARATION
Use NORTHSTAR Cleanwipe (S10) to clean substrate free of grease, dirt, and foreign contaminants.
APPLICATION
Apply 2 鈥? 3 medium wet coats over substrate
鈥?
Allow 10-15 minutes between coats
鈥?
Scuff after 24 hours before recoating
鈥?
Clean gun after spraying is completed
鈥?
SAFETY
Refer to Material Safety Data Sheet (MSDS) for complete safety instructions. The technical data sheet
listed has been compiled in good faith for your convenience and guidance. No warranty, expressed or
implied, is intended or given by the information on this sheet.
NORTHSTAR COATINGS
Division of Lusid Technologies, Inc. 鈥? Sandy, UT 鈥? Phone 801 565-0030 鈥? Fax 801 565-3750
|