PL21 1/8/1970
2.1 VOC Fast Dry Lacquer Primer Page 2
DRY / FLASH TIMES
Air Dry @ 77掳 F
Flash between coats 10 minutes
To sand 30 minutes
Dust free 10 minutes
To topcoat 30 minutes
Force Dry
Flash before force dry 15 minutes flash
Force dry time 20 minutes @ 140掳 F
GUN SETUPS
Conventional
Gravity Feed 1.5mm - 1.8mm
Siphon Feed 1.5mm - 1.8mm
AIR PRESSURES
Conventional @ Gun
Gravity Feed 35 - 45 psi
Siphon Feed 40 - 50 psi
HVLP @ cap 8 - 10 psi
SURFACE PREPARATION
Use NORTHSTAR Wax and Grease Remover (S20) to clean substrate free of grease, dirt , and foreign
contaminants.
APPLICATION
鈥? Apply 2 medium wet coats over substrate (additional coats may be applied after proper flash)
鈥? Allow 10 minutes between coats, 30 minutes to topcoat
鈥? Scuff after 24 hours before applying topcoat
鈥? Clean gun after spraying is completed
SAFETY
Refer to Material Safety Data Sheet (MSDS) for complete safety instructions. The technical data sheet listed
has been compiled in good faith for your convenience and guidance. No warranty, expressed or implied, is
intended or given by the information on this sheet.
NORTHSTAR COATINGS / DIVISION OF LUSID TECH, INC.
9498 South 67 West 鈥? Sandy, UT 鈥? Phone 801 565-0030 鈥? Fax 801 565-3750
|