EP210 1/8/1970
2.1 VOC HB Epoxy Primer Page 2
DRY / FLASH TIMES
Air Dry @ 77掳 F
Flash between coats 15 minutes
To sand Overnight
To topcoat 60 minutes
Force Dry
Flash before force dry 15 minutes flash
Force dry time 30 minutes @ 140掳 F
GUN SETUPS
Conventional
Gravity Feed 1.5mm - 1.8mm
Siphon Feed 1.5mm - 1.8mm
AIR PRESSURES
Conventional @ Gun
Gravity Feed 35 - 45 psi
Siphon Feed 45 - 50 psi
HVLP @ cap 8-10 psi
SURFACE PREPARATION
Use NORTHSTAR Cleanwipe (S10) to clean substrate free of grease, dirt, and foreign contaminants.
APPLICATION
鈥? Apply 1-2 medium wet coats over substrate
鈥? Allow 15 minutes between coats, 60 minutes to topcoat
鈥? Scuff after 48 hour period
鈥? Clean gun after spraying is completed
SAFETY
Refer to Material Safety Data Sheet (MSDS) for complete safety instructions. The technical data sheet listed
has been compiled in good faith for your convenience and guidance. No warranty, expressed or implied, is
intended or given by the information on this sheet..
NORTHSTAR COATINGS / DIVISION OF LUSID TECH, INC.
9498 South 67 West 鈥? Sandy, UT 鈥? Phone 801 565-0030 鈥? Fax 801 565-3750
|