MS210 1/8/1970
2.1 VOC Automotive Clear Page 2
DRY / FLASH TIMES
Air Dry @ 77掳 F
Flash between coats 10-15 minutes
Dust free 30 minutes
Tack free 60 minutes
Sand & Buff 12 hours
Force Dry
Flash before force dry 15 minutes flash
Force dry time 40 minutes @ 140掳 F
Sand & buff after cool down of 2 hours
GUN SETUPS
Conventional
Gravity Feed 1.2mm - 1.6mm
Siphon Feed 1.2mm - 1.6mm`
AIR PRESSURES
Conventional @ Gun
Gravity Feed 35 - 45 psi
Siphon Feed 40 - 50 psi
HVLP @ cap 8 - 10 psi
SURFACE PREPARATION
Use NORTHSTAR Cleanwipe (S10) to clean substrate free of grease, dirt, and foreign contaminants.
APPLICATION
鈥? Apply 2 medium wet coats over substrate to desired film thickness
鈥? Allow 10-15 minutes between coats
鈥? Scuff after 24 hours before applying topcoat or recoating
鈥? Clean gun after spraying is completed
鈥? Note: Flex additive is recommended when flexible part is not on vehicle or when using a fast activator.
SAFETY
Refer to Material Safety Data Sheet (MSDS) for complete safety instructions. The technical data sheet listed
has been compiled in good faith for your convenience and guidance. No warranty, expressed or implied, is
intended or given by the information on this sheet..
NORTHSTAR COATINGS / DIVISION OF LUSID TECH, INC.
9498 South 67 West 鈥? Sandy, UT 鈥? Phone 801 565-0030 鈥? Fax 801 565-3750
|