VP404 1/8/1970
Etching Primer Page 2
GUN SETUPS
Conventional
Gravity Feed 1.5mm - 1.8mm
Siphon Feed 1.5mm - 1.8mm
AIR PRESSURES
Conventional @ Gun
Gravity Feed 35 - 45 psi
Siphon Feed 40 - 50 psi
HVLP @ cap 8 - 10 psi
Siphon Feed
SURFACE PREPARATION
Use NORTHSTAR Cleanwipe (S10) to clean substrate free of grease, dirt, and foreign contaminants.
APPLICATION
鈥? Apply 1 medium wet coat over substrate (.5 mils)
鈥? Allow 10 - 15 minutes between coats, 30 minutes to topcoat
鈥? Avoid excess film build which may cause adhesion failure
鈥? Clean gun immediately after spraying is completed
SAFETY
Refer to Material Safety Data Sheet (MSDS) for complete safety instructions. The technical data sheet listed
has been compiled in good faith for your convenience and guidance. No warranty, expressed or implied, is
intended or given by the information on this sheet.
NORTHSTAR COATINGS / DIVISION OF LUSID TECH, INC.
9498 South 67 West 鈥? Sandy, UT 鈥? Phone 801 565-0030 鈥? Fax 801 565-3750
|