P460 1/10/1970
Enamel Sealer Page 2
GUN SETUPS
Conventional
Gravity Feed 1.5mm - 1.8mm
Siphon Feed 1.5mm - 1.8mm
AIR PRESSURES
Conventional @ Gun
Gravity Feed 35 - 45 psi
Siphon Feed 40 - 50 psi
HVLP @ cap 8-10 psi
SURFACE PREPARATION
Use NORTHSTAR Cleanwipe (S10) to clean substrate free of grease, dirt, and foreign contaminants.
APPLICATION
鈥? Apply medium wet coats over substrate to desired film thickness
鈥? Allow 10-15 minutes between coats, 30 minutes to topcoat
鈥? Scuff after 24 hours application before applying topcoat
鈥? Clean gun after spraying is completed
SAFETY
Refer to Material Safety Data Sheet (MSDS) for complete safety instructions. The technical data sheet listed
has been compiled in good faith for your convenience and guidance. No warranty, expressed or implied, is
intended or given by the information on this sheet..
NORTHSTAR COATINGS / DIVISION OF LUSID TECH, INC.
9498 South 67 West 鈥? Sandy, UT 鈥? Phone 801 565-0030 鈥? Fax 801 565-3750
|