MATERIAL SAFETY DATA SHEET
Sikafloor 156 - Part B
HMIS
HEALTH 3
FLAMMABILITY 2
REACTIVITY 0
D
PERSONAL PROTECTION
1. Product And Company Identification
Supplier Manufacturer
Sika Corporation Sika Canada Inc.
201 Polito Ave 601, Avenue Delmar
Lyndhurst, NJ 07071 Pointe Claire, QC H9R 4A9 Canada
Company Contact: EHS Department Company Contact: Steve Gosselin
Telephone Number: 201-933-8800 Telephone Number: 514-697-2610
FAX Number: 201-933-9379
Web Site: www.sikausa.com
Supplier Emergency Contacts & Phone Number Manufacturer Emergency Contacts & Phone Number
CHEMTREC: 800-424-9300 CANUTEC: 613-996-6666
INTERNATIONAL: 703-527-3887
Issue Date: 03/21/2006
Product Name: Sikafloor 156 - Part B
CAS Number: Not Established
Chemical Family: Modified Polyamine
MSDS Number: 3853
2. Composition/Information On Ingredients
Ingredient CAS Percent Of
Name Number Total Weight
2,4,6-TRIS(DIMETHYLAMINOMETHYL)PHENOL 90-72-2
BENZYL ALCOHOL 100-51-6
ISOPHORONEDIAMINE 2855-13-2
PROPRIETARY BLEND OF ALIPHATIC & CYCLOALIPHATIC AMINES Trade Secret
3. Hazards Identification
Eye Hazards
Corrosive to living tissue. Causes eye irritation. Causes eye burns.
Skin Hazards
Corrosive to living tissue. May cause skin irritation. Causes skin burns. Prolonged and/or repeated skin contact
may cause an allergic reaction/sensitization.
Ingestion Hazards
Corrosive to living tissue. Harmful if swallowed.
Page 1 of 5
MATERIAL SAFETY DATA SHEET
Sikafloor 156 - Part B
3. Hazards Identification - Continued
Inhalation Hazards
May cause nose, throat, and lung irritation.
An overexposure may cause breathing difficulty, headaches, nausea, damages to the lungs, sensitization, and
dizziness. May cause problems to the skin, eyes, lungs. May aggravate respiratory and allergic problems.
4. First Aid Measures
Eye
In case of contact, hold eyelids apart and immediately flush eyes with plenty of tepid water for at least 15 minutes.
Get medical attention immediately if irritation develops and persists.
Skin
In case of contact, immediately flush skin with soap and plenty of tepid water for at least 15 minutes. Get medical
attention immediately if irritation (redness, rash, blistering) develops and persists.
Ingestion
If swallowed, do not induce vomiting, contact physician.
Inhalation
Remove to fresh air. If not breathing, give artificial respiration, seek medical attention.
5. Fire Fighting Measures
Flash Point: >180 掳F >82 掳C
Autoignition Point: N/A 掳F
Fire And Explosion Hazards
Combustible liquid. During a fire, irritating and/or toxic gases and aerosols from the decomposition/combustion
products may be present.
Extinguishing Media
Foam/Dry Chemical/Water Fog
Fire Fighting Instructions
Wear NIOSH/MSHA approved self-contained breathing apparatus and full protective gear. Wear full face piece
operated in positive pressure mode.Avoid breathing vapors or fumes. Cool exposed containers with water spray.
6. Accidental Release Measures
Eliminate all ignition sources. Use appropriate Personal Protective Equipment (PPE). Absorb and/or contain spill with
inert materials (e.g. sand, vermiculite) and then place in appropriate container. For large spills, use water spray to
disperse vapors. Prevent runoff from entering waterways or sewers.
7. Handling And Storage
Handling And Storage Precautions
Keep out of reach of children. Store in a cool, dry, well ventilated area. Keep containers tightly closed.
Storage Precautions
Keep away from heat, sparks, flame, and other sources of ignition (i.e., pilot lights, electric motors and static
electricity).
Work/Hygienic Practices
Wash thoroughly with soap and water after handling.
Page 2 of 5
MATERIAL SAFETY DATA SHEET
Sikafloor 156 - Part B
8. Exposure Controls/Personal Protection
Engineering Controls
Use of a system of local and/or general exhaust is recommended to keep employee below applicable expsoure
limits. Refer to the current edition of "Industrial Ventilation: A Manual of Recommended Practice" published by
the American Conference of Governmental Industrial Hygienists for information on the design, installation, use,
and maintenance of exhaust systems.
Eye/Face Protection
Faceshield over safety glasses or goggles.
Skin Protection
Avoid skin contact. Wear long sleeve shirt and long pants, chemical resistant gloves.
Respiratory Protection
A respirator protection program that meets 29 CFR 1910.134 requirement must be followed whenever workplace
conditions warrant a respirator's use.
Other/General Protection
Wash thoroughly with soap and water after handling.
9. Physical And Chemical Properties
Appearance
Yellowish liquid
Odor
Amine odor
Chemical Type: Mixture
Physical State: Liquid
Specific Gravity: 1 g/cm3
Solubility: Partial in water
10. Stability And Reactivity
Stability: Stable
Hazardous Polymerization: Will not occur
Hazardous Decomposition Products
CO, NOx, Phenol
11. Toxicological Information
No Data Available...
12. Ecological Information
No Data Available...
13. Disposal Considerations
Dispose in accordance with applicable federal, state and local government regulations. Waste generators must
determine whether a discarded material is classified as a hazardous waste. USEPA guidelines for the classification
determination are listed in 40 CFR Parts 261.3. Additionally, waste generators must consult state and local hazardous
waste regulations to ensure complete and accurate classification.
RCRA Information
Waste solutions may meet the RCRA Corrosive characteristic.
Page 3 of 5
MATERIAL SAFETY DATA SHEET
Sikafloor 156 - Part B
14. Transport Information
Proper Shipping Name
Paint related material
Hazard Class
8 PG III
DOT Identification Number
UN3066
DOT Shipping Label
Corrosive
15. Regulatory Information
U.S. Regulatory Information
All ingredients of this product are listed or are excluded from listing under the U.S. Toxic Substances Control Act
(TSCA) Chemical Substance Inventory.
SARA Hazard Classes
Acute Health Hazard
SARA Section 313 Notification
This product does not contain any ingredients regulated under Section 313 of the Emergency Planning and
Community Right-To-Know Act of 1986 or 40 CFR 372.
Ingredient(s) - State Regulations
BENZYL ALCOHOL
New Jersey - Workplace Hazard
Pennsylvania - Workplace Hazard
Massachusetts - Hazardous Substance
ISOPHORONEDIAMINE
New Jersey - Workplace Hazard
New Jersey - Special Hazard
New York City - Hazardous Substance
16. Other Information
HMIS Rating
H eal th: 3
F i re : 2
Reactivity: 0
PP E: D
Revision/Preparer Information
MSDS Preparer: EHS Department
MSDS Preparer Phone Number: 201-933-8800
This MSDS Supercedes A Previous MSDS Dated: 02/15/2006
Disclaimer
The data in this Material Safety Data Sheet relates only to the specific material herein and does not relate to use
in combination with any other material or in any process. The information set forth herein is based on technical
data that Sika believes to be reliable as of the date hereof. Since conditions of use are outside our control, we
make no warranties, express or implied andassume no liability in connection with any use of this information.
Nothing herein is to be taken as a license to operate under or a recommendation to infringe any patents.
Page 4 of 5
MATERIAL SAFETY DATA SHEET
Sikafloor 156 - Part B
Disclaimer - Continued
SIKA CORPORATION
Printed Using MSDS Generator鈩? 2000
Page 5 of 5
|