**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 110-15-6 |Succinic acid | >99 | 203-740-4 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: XI
Risk Phrases: 36/37/38
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Irritating to eyes, respiratory system and skin.
Potential Health Effects
Eye:
Causes eye irritation.
Skin:
Causes skin irritation.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea.
Inhalation:
Causes respiratory tract irritation.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Immediately flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
Never give anything by mouth to an unconscious person. Get medical
aid immediately. Do NOT induce vomiting. If conscious and alert,
rinse mouth and drink 2-4 cupfuls of milk or water.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
Treat symptomatically and supportively.
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. Dusts at sufficient concentrations can form
explosive mixtures with air. During a fire, irritating and highly
toxic gases may be generated by thermal decomposition or combustion.
Extinguishing Media:
For small fires, use water spray, dry chemical, carbon dioxide or
chemical foam. Use water spray, dry chemical, carbon dioxide, or
appropriate foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Clean up spills immediately, observing precautions in the Protective
Equipment section. Sweep up, then place into a suitable container for
disposal. Avoid generating dusty conditions. Provide ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use with adequate ventilation. Minimize dust
generation and accumulation. Avoid contact with eyes, skin, and
clothing. Avoid breathing dust.
Storage:
Store in a cool, dry, well-ventilated area away from incompatible
substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate
ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 110-15-6:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
A respiratory protection program that meets OSHA's 29
CFR 1910.134 and ANSI Z88.2 requirements or European
Standard EN 149 must be followed whenever workplace
conditions warrant respirator use. Follow the OSHA
respirator regulations found in 29 CFR 1910.134 or
European Standard EN 149. Use a NIOSH/MSHA or
European Standard EN 149 approved respirator if
exposure limits are exceeded or if irritation or
other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Crystalline powder
Color: white
Odor: odorless
pH: 2.7 (0.1M aq soln)
Vapor Pressure: Not available.
Viscosity: Not available.
Boiling Point: 235 deg C
Freezing/Melting Point: 185-190 deg C
Autoignition Temperature: 630 deg C ( 1,166.00 deg F)
Flash Point: 206 deg C ( 402.80 deg F)
Explosion Limits, lower: Not available.
Explosion Limits, upper: Not available.
Decomposition Temperature: > 235 deg C
Solubility in water: 80 g/l @ 20C
Specific Gravity/Density: 1.56
Molecular Formula: C4H6O4
Molecular Weight: 118.09
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable at room temperature in closed containers under normal storage
and handling conditions.
Conditions to Avoid:
Dust generation, excess heat.
Incompatibilities with Other Materials:
Strong oxidizing agents, strong bases.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 110-15-6: WM4900000
LD50/LC50:
CAS# 110-15-6: Draize test, rabbit, eye: 750 ug Severe; Oral, rat:
LD50 = 2260 mg/kg.
Carcinogenicity:
Succinic acid -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
Other
No information available.
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Not regulated as a hazardous material.
IMO
Not regulated as a hazardous material.
RID/ADR
Not regulated as a hazardous material.
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: XI
Risk Phrases:
R 36/37/38 Irritating to eyes, respiratory system
and skin.
Safety Phrases:
S 26 In case of contact with eyes, rinse immediately
with plenty of water and seek medical advice.
S 37/39 Wear suitable gloves and eye/face
protection.
WGK (Water Danger/Protection)
CAS# 110-15-6: 0
Canada
CAS# 110-15-6 is listed on Canada's DSL List.
CAS# 110-15-6 is listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 110-15-6 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 7/15/1999 Revision #5 Date: 4/26/2005
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
Tin(IV) Chloride Anhydrous
| 7646-78-8 |
|
Tin(IV) Chloride Pentahydrate
| 7646-78-8 |
|
2,5-Dimethyl-3-Pyrroline, 75% Remainder 2,5-Dimethyl-1-Pyrroline
| 59480-92-1 |
|
Ruthenium on 1/8-inch alumina pellets (0.5% ru)
| |
|
6-Fluorotryptamine hydrochloride, 99%
| 55206-24-1 |
|
3-Phenyl-1-propylamine, 98%
| 2038-57-5 |
|
Tin (IV) Oxide
| 18282-10-5 |
|
Isethionic Acid Potassium Salt, 98% (Titr.)
| 1561-99-5 |
|
Tin (II) Chloride Anhydrous
| 7772-99-8 |
|
Tubocurarine Chloride, 98.0 - 102.0%
| 6989-98-6 |
|
Tin (II) Chloride Dihydrate
| 10025-69-1 |
|
Rhodium on srtio3 , 0.5 wt% rh
| |
|
Cochineal, extract powder
| |
|
Dimethyl trans-1,2-cyclopropanedicarboxylate, 99+%
| 826-35-7 |
|
3-Aminocrotonamide, Tech. 85%
| 15846-25-0 |
|
Normal-butyl sulfoxide, tech., 93%
| 2168-93-6 |
|
Tin (II) Oxide
| 21651-19-4 |
|
Stearic acid
| 57-11-4 |
|
Starch, Soluble and Hydrolysed
| 9005-25-8 |
|
2-Chloro-3,5-Dinitropyridine, 99%
| 2578-45-2 |
|
Phosphorous acid, 98%
| 10294-56-1 |
|
Poly(Methyl Methacrylate) (Pract)
| 9011-14-7 |
|
Octadecyltrichlorosilane, 95%
| 112-04-9 |
|
Ethyl Propionate, 97+% (gc)
| 105-37-3 |
|
4,4'-Diaminooctafluorobiphenyl, 98%
| 1038-66-0 |
|
Poly(4-methyl-1-pentene), high molecular weight
| 25068-26-2 |
|
Exo-2-Bromo-5-Oxo-Bicyclo(2.2.1)Heptane-Syn-7-Carboxylic Acid, 99%
| 63377-25-3 |
|
3-Methylsulphonylaniline Hydrochloride , 95+%
| 80213-28-1 |
|
Aminoreductone precursor
| |
|
Propyl Red, 98% (UV-Vis)
| 2641-01-2 |
|
5-Chloro-2-Mercaptobenzothiazole, 98%
| 5331-91-9 |
|
Strontium Chloride Hexahydrate
| 10025-70-4 |
|
3-Hydroxypyridine, 98%
| 109-00-2 |
|
N-Methyl-1,3-propanediamine, 99%
| 6291-84-5 |
|
Perfluoro-compound FC-72
| 355-42-0 |
|
2,4,4-Trimethyl-1-pentene (pract), 95% (gc)
| 107-39-1 |
|
2,6-Dimethoxypyridine, 99%
| 6231-18-1 |
|
Strontium nitrate
| 10042-76-9 |
|
2-Fluoroanisole, 98%
| 321-28-8 |
|
Cholic acid, 99+% (titr.)
| 81-25-4 |
|
1-Amino-1-cyclopentanecarboxylic acid, 97%
| 52-52-8 |
|
Dipentylamine, 99%
| 2050-92-2 |
|
Trioctylpropylammonium bromide, 99% (titr.)
| 24298-17-7 |
|
Styrene monomer, inhibited
| 100-42-5 |
|
p-Nitrocinnamic acid, 97%,predominantly trans
| 619-89-6 |
|
3,4-Dimethoxyphenethyl Alcohol
| 7417-21-2 |
|
Succinic acid
| 110-15-6 |
|
D(+)-Sucrose
| 57-50-1 |
|
2-Chlorothiophene, 98+%
| 96-43-5 |
|
Terephthalic-D4 Acid, 98 Atom % D
| 60088-54-2 |
|
|