**** SECTION 2 - COMPOSITION, INFORMATION ON INGREDIENTS ****
+----------------+--------------------------------------+----------+-----------+
| CAS# | Chemical Name | % | EINECS# |
|----------------|--------------------------------------|----------|-----------|
| 355-42-0 |Perfluoro-n-hexane | 100 | 206-585-0 |
+----------------+--------------------------------------+----------+-----------+
Hazard Symbols: None Listed.
Risk Phrases: None Listed.
**** SECTION 3 - HAZARDS IDENTIFICATION ****
EMERGENCY OVERVIEW
Not available.
Potential Health Effects
Eye:
May cause eye irritation.
Skin:
May cause skin irritation.
Ingestion:
May cause gastrointestinal irritation with nausea, vomiting and
diarrhea.
Inhalation:
May cause respiratory tract irritation.
Chronic:
No information found.
**** SECTION 4 - FIRST AID MEASURES ****
Eyes:
Flush eyes with plenty of water for at least 15 minutes,
occasionally lifting the upper and lower eyelids. Get medical aid
immediately.
Skin:
Get medical aid. Flush skin with plenty of water for at least 15
minutes while removing contaminated clothing and shoes. Wash clothing
before reuse.
Ingestion:
If victim is conscious and alert, give 2-4 cupfuls of milk or water.
Never give anything by mouth to an unconscious person. Get medical
aid immediately.
Inhalation:
Remove from exposure and move to fresh air immediately. If not
breathing, give artificial respiration. If breathing is difficult,
give oxygen. Get medical aid.
Notes to Physician:
**** SECTION 5 - FIRE FIGHTING MEASURES ****
General Information:
As in any fire, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH (approved or equivalent), and full
protective gear. During a fire, irritating and highly toxic gases
may be generated by thermal decomposition or combustion. Use water
spray to keep fire-exposed containers cool. Containers may explode in
the heat of a fire. Vapors may be heavier than air. They can spread
along the ground and collect in low or confined areas.
Extinguishing Media:
Use agent most appropriate to extinguish fire. Cool containers with
flooding quantities of water until well after fire is out. Use water
spray, dry chemical, carbon dioxide, or appropriate foam.
**** SECTION 6 - ACCIDENTAL RELEASE MEASURES ****
General Information: Use proper personal protective equipment as indicated
in Section 8.
Spills/Leaks:
Absorb spill with inert material (e.g. vermiculite, sand or earth),
then place in suitable container. Clean up spills immediately,
observing precautions in the Protective Equipment section. Provide
ventilation.
**** SECTION 7 - HANDLING and STORAGE ****
Handling:
Wash thoroughly after handling. Remove contaminated clothing and
wash before reuse. Use with adequate ventilation. Avoid contact with
eyes, skin, and clothing. Keep container tightly closed. Avoid
ingestion and inhalation.
Storage:
Keep container closed when not in use. Store in a tightly closed
container. Store in a cool, dry, well-ventilated area away from
incompatible substances.
**** SECTION 8 - EXPOSURE CONTROLS, PERSONAL PROTECTION ****
Engineering Controls:
Use adequate ventilation to keep airborne concentrations low.
Exposure Limits
CAS# 355-42-0:
Personal Protective Equipment
Eyes:
Wear appropriate protective eyeglasses or chemical
safety goggles as described by OSHA's eye and face
protection regulations in 29 CFR 1910.133 or European
Standard EN166.
Skin:
Wear appropriate protective gloves to prevent skin
exposure.
Clothing:
Wear appropriate protective clothing to prevent skin
exposure.
Respirators:
Follow the OSHA respirator regulations found in 29
CFR 1910.134 or European Standard EN 149. Use a
NIOSH/MSHA or European Standard EN 149 approved
respirator if exposure limits are exceeded or if
irritation or other symptoms are experienced.
**** SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES ****
Physical State: Liquid
Color: clear, colorless
Odor: None reported.
pH: Not available.
Vapor Pressure: 232 mmHg @ 25 C
Viscosity: 0.4 cSt 25 deg C
Boiling Point: 51-59 deg C @ 760 mm Hg
Freezing/Melting Point: -90 deg C
Autoignition Temperature: Not available.
Flash Point: Not available.
Explosion Limits, lower: N/A
Explosion Limits, upper: N/A
Decomposition Temperature:
Solubility in water: practically insoluble in water
Specific Gravity/Density: 1.6800 g/cm3
Molecular Formula: C6F14
Molecular Weight: 340.00
**** SECTION 10 - STABILITY AND REACTIVITY ****
Chemical Stability:
Stable under normal temperatures and pressures.
Conditions to Avoid:
Excess heat.
Incompatibilities with Other Materials:
Strong oxidizing agents.
Hazardous Decomposition Products:
Carbon monoxide, carbon dioxide, hydrogen fluoride gas.
Hazardous Polymerization: Has not been reported.
**** SECTION 11 - TOXICOLOGICAL INFORMATION ****
RTECS#:
CAS# 355-42-0: MO4310000
LD50/LC50:
CAS# 355-42-0: Oral, rat: LD50 = >5 gm/kg.
Inhalation, rat: LC50 >40000 ppm/6H
Carcinogenicity:
Perfluoro-n-hexane -
Not listed by ACGIH, IARC, or NTP.
Other:
See actual entry in RTECS for complete information.
**** SECTION 12 - ECOLOGICAL INFORMATION ****
Other
No information available.
**** SECTION 13 - DISPOSAL CONSIDERATIONS ****
Dispose of in a manner consistent with federal, state, and local regulations.
**** SECTION 14 - TRANSPORT INFORMATION ****
IATA
Shipping Name: Not regulated.
Hazard Class:
UN Number:
Packing Group:
IMO
Shipping Name: Not regulated.
Hazard Class:
UN Number:
Packing Group:
RID/ADR
Shipping Name: Not regulated.
Hazard Class:
UN Number:
Packing group:
**** SECTION 15 - REGULATORY INFORMATION ****
European/International Regulations
European Labeling in Accordance with EC Directives
Hazard Symbols: Not available.
Risk Phrases:
Safety Phrases:
S 24/25 Avoid contact with skin and eyes.
S 28A After contact with skin, wash immediately with
plenty of water.
S 37 Wear suitable gloves.
S 45 In case of accident or if you feel unwell, seek
medical advice immediately (show the label where
possible).
WGK (Water Danger/Protection)
CAS# 355-42-0: 2
Canada
CAS# 355-42-0 is listed on Canada's NDSL List.
CAS# 355-42-0 is not listed on Canada's Ingredient Disclosure List.
US FEDERAL
TSCA
CAS# 355-42-0 is listed on the TSCA inventory.
**** SECTION 16 - ADDITIONAL INFORMATION ****
MSDS Creation Date: 6/08/1998 Revision #3 Date: 4/02/2003
The information above is believed to be accurate and represents the best
information currently available to us. However, we make no warranty of
merchantability or any other warranty, express or implied, with respect to
such information, and we assume no liability resulting from its use. Users
should make their own investigations to determine the suitability of the
information for their particular purposes. In no way shall the company be
liable for any claims, losses, or damages of any third party or for lost
profits or any special, indirect, incidental, consequential or exemplary
damages, howsoever arising, even if the company has been advised of
the possibility of such damages.
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
|
|
|
| ALL MSDS PAGES IN THIS GROUP
| | NAME | CAS |
|
Tin(IV) Chloride Anhydrous
| 7646-78-8 |
|
Tin(IV) Chloride Pentahydrate
| 7646-78-8 |
|
2,5-Dimethyl-3-Pyrroline, 75% Remainder 2,5-Dimethyl-1-Pyrroline
| 59480-92-1 |
|
Ruthenium on 1/8-inch alumina pellets (0.5% ru)
| |
|
6-Fluorotryptamine hydrochloride, 99%
| 55206-24-1 |
|
3-Phenyl-1-propylamine, 98%
| 2038-57-5 |
|
Tin (IV) Oxide
| 18282-10-5 |
|
Isethionic Acid Potassium Salt, 98% (Titr.)
| 1561-99-5 |
|
Tin (II) Chloride Anhydrous
| 7772-99-8 |
|
Tubocurarine Chloride, 98.0 - 102.0%
| 6989-98-6 |
|
Tin (II) Chloride Dihydrate
| 10025-69-1 |
|
Rhodium on srtio3 , 0.5 wt% rh
| |
|
Cochineal, extract powder
| |
|
Dimethyl trans-1,2-cyclopropanedicarboxylate, 99+%
| 826-35-7 |
|
3-Aminocrotonamide, Tech. 85%
| 15846-25-0 |
|
Normal-butyl sulfoxide, tech., 93%
| 2168-93-6 |
|
Tin (II) Oxide
| 21651-19-4 |
|
Stearic acid
| 57-11-4 |
|
Starch, Soluble and Hydrolysed
| 9005-25-8 |
|
2-Chloro-3,5-Dinitropyridine, 99%
| 2578-45-2 |
|
Phosphorous acid, 98%
| 10294-56-1 |
|
Poly(Methyl Methacrylate) (Pract)
| 9011-14-7 |
|
Octadecyltrichlorosilane, 95%
| 112-04-9 |
|
Ethyl Propionate, 97+% (gc)
| 105-37-3 |
|
4,4'-Diaminooctafluorobiphenyl, 98%
| 1038-66-0 |
|
Poly(4-methyl-1-pentene), high molecular weight
| 25068-26-2 |
|
Exo-2-Bromo-5-Oxo-Bicyclo(2.2.1)Heptane-Syn-7-Carboxylic Acid, 99%
| 63377-25-3 |
|
3-Methylsulphonylaniline Hydrochloride , 95+%
| 80213-28-1 |
|
Aminoreductone precursor
| |
|
Propyl Red, 98% (UV-Vis)
| 2641-01-2 |
|
5-Chloro-2-Mercaptobenzothiazole, 98%
| 5331-91-9 |
|
Strontium Chloride Hexahydrate
| 10025-70-4 |
|
3-Hydroxypyridine, 98%
| 109-00-2 |
|
N-Methyl-1,3-propanediamine, 99%
| 6291-84-5 |
|
Perfluoro-compound FC-72
| 355-42-0 |
|
2,4,4-Trimethyl-1-pentene (pract), 95% (gc)
| 107-39-1 |
|
2,6-Dimethoxypyridine, 99%
| 6231-18-1 |
|
Strontium nitrate
| 10042-76-9 |
|
2-Fluoroanisole, 98%
| 321-28-8 |
|
Cholic acid, 99+% (titr.)
| 81-25-4 |
|
1-Amino-1-cyclopentanecarboxylic acid, 97%
| 52-52-8 |
|
Dipentylamine, 99%
| 2050-92-2 |
|
Trioctylpropylammonium bromide, 99% (titr.)
| 24298-17-7 |
|
Styrene monomer, inhibited
| 100-42-5 |
|
p-Nitrocinnamic acid, 97%,predominantly trans
| 619-89-6 |
|
3,4-Dimethoxyphenethyl Alcohol
| 7417-21-2 |
|
Succinic acid
| 110-15-6 |
|
D(+)-Sucrose
| 57-50-1 |
|
2-Chlorothiophene, 98+%
| 96-43-5 |
|
Terephthalic-D4 Acid, 98 Atom % D
| 60088-54-2 |
|
|