Material Safety Data Sheet (MSDS)
Quat Plus
Liquid Disinfectant
Germicides
Section i 鈻? PRoDUct iDentiFicAtion
Product Name Product Type WHMIS Classification
Quat Plus Liquid Disinfectant Exempt
Section ii 鈻? HAzARDoUS ingReDientS
Chemical Name Cas Registry No. % Toxicity
N,N-DIALKYL-N,N-dimethyl ammonium chloride 68424-95-3 1-5 LD50ORAL (RAT) 455 mg/kg
Section iii 鈻? PHySicAl DAtA
Appearance Odour pH Boiling Point Specific Gravity Solubility in Water
Clear colourless liquid Unscented 10.5 100 OC 1.0 100 %
Section iV 鈻? FiRe AnD exPloSion HAzARD DAtA
Flash Point (oC): None Extinguising media: Not Applicable
Special fire fighting procedures: None
Unusual fire and explosion hazards: None
Section V 鈻? toxicologicAl PRoPeRtieS
HAzArd rAtInG: Health = 1 Flammability = 0 Reactivity = 0
rating System
Swallowing: Slightly Toxic
0 = Insignificant
Inhalation: Not Applicable
1 = Slight
Skin Absortion: Unknown 2 = Moderate
Skin Contact: May cause slight irritation 3 = High
Eye Contact: Irritant 4 = Extreme
Special Warning: None
Section Vi 鈻? FiRSt AiD MeASUReS
Ingestion: Promptly drink large quantities of milk, egg whites, gelatin or water. Avoid alcohol. Call a physician immediately.
Inhalation: Not Applicable
Skin: Flush thoroughly with water for at least 15 minutes. Remove and wash contaminated clothing.
Eyes: Flush thoroughly with water for at least 15 minutes. Call a physician.
Section Vii 鈻? ReActiVity DAtA
Stable: Yes
Conditions to avoid: None
Incompatibility with other materials: None
Hazardous decomposition products: None
Hazardous polymerization: Will not occur.
Section Viii 鈻? PReVentiVe MeASUReS
Hand protection: Yes (for concentrate)
Eye protection: Yes (for concentrate)
Ventilation: General
respiratory protection: None
Other protective equipment: In case of spills, wear chemical resistant apron and boots.
Steps to be taken in case material is released or spilled: Mop up spillage. Rinse spill area with water and allow to dry.
Waste disposal method: Flush with water into waste systems in accordance with municipal, provincial and federal regulations.
Precautions to be taken in handling and storage: Normal handling processes. Inside storage at 4-40 OC recommended.
Other precautions: Follow label use instructions.
UN: Not Applicable tdG Class: None Packing Group: Not Applicable
tdG Emergency telephone number: 613-996-666 (COLLECT)
Section ix 鈻? PRePeRAtion DAtA
Prepared by: D.R. Dunlop Last updated: September 1, 2007
Location: Dustbane Products Limited, 25 Pickering Place, Ottawa, Ontario, K1G 5P4 鈥? 613-745-6861
Quat Plus
Liquid Disinfectant
鈥淓CP approved liquid disinfectant
(Pseudomonacidal, Staphylocidal, Salmonellacidal, Fungicidal, Virucidal).鈥?
FeAtUReS AnD BeneFitS
Environmentally Friendly: ECP Approved - CCD-166 鈥淒isinfectants and Disinfectant Cleaners鈥?
Multiple Claims: effectively destroys a broad range of bacteria, fungi and viruses including: Pseudomonas aeruginosa,
Salmonella choleraesuis, Staphyloccoccus aureus, HIV-1 and Trichophyton mentagrophytes.
Dual Purpose: Also meets CCD-146 鈥淕eneral Purpose Hard Surface Cleaners鈥?.
WHeRe to USe
Quat Plus was formulated for use in health care and food processing facilities. It may be used to disinfect all hard,
non-porous surfaces including walls, floors, tubs, sinks, countertops, garbage pails, furniture etc.
HoW to USe
recommended dillution rates:
Heavy Cleaning ................................................1:40 (CCD-146)
All Purpose .....................................................1:120 (CCD-146)
Regular Cleaning ............................................. 1:256 (CCD-146)
Automatic Scrubber ......................................... 1:256 (CCD-146)
disinfection ............................................. 1:80 (CCd-166)
Note: Adjust dilution rates to suit your cleaning needs.
Apply with a mop, sponge or cloth.
Mold and Mildew: When mixed at a rate of 1:80, QUAT PLUS effectively inhibits the growth of odour-causing mold
and mildew. Apply the solution and allow it to dry on the treated surface. Repeat treatment when mold or mildew
returns.
disinfecting: Allow a minimum contact time of 10 minutes in a single application. Surfaces subject to direct food
contact should be adequately rinsed with potable water. Heavily soiled surfaces must be precleaned.
HIV-1: When mixed at a rate of 1:80, QUAT PLUS may be used to disinfect and decontaminate hard surfaces exposed
to blood or other body fluids that contain the HIV-1 virus. Thoroughly clean all hard surfaces removing blood and
body fluids prior to disinfection. Allow surfaces to remain wet for a minimum of 4 minutes. Wear protective clothing
including latex gloves, gown, mask and eye goggles. Blood, body fluids, cleaning materials and clothing should be
autoclaved and disposed of according to local regulations. [Note: efficacy testing was done in the presence of hard
water (400 ppm as CaCO3) and a soil load (5% blood serum)].
SPeciFicAtionS
n,n-dIALKYL-n,n-dimethyl ammonium chloride: 4.8%
Inert Ingredients: 95.2%
pH, concentrate @ 25OC: 10.5
pH, at 1:80 @ 25OC: 9.0-9.5
Colour: Colourless
Odour: Unscented
DIN#: 02298694
CFIA Approval: Pending
Quat Plus is an effective bactericide, fungicide and virucide as demonstrated by the following support data:
a) CLAIM - DISINFECTANT - AOAC USE - DILUTION TEST AT 600 ppm (dilution ratio of 1:80 in 250 ppm hard water).
Pseudomonas aeruginosa ATTC# 15542 10 0/10
Staphylococcus aureus ATTC# 6538 10 0/10
b) CLAIM - DISINFECTANT - AOAC USE - DILUTION TEST AT 600 ppm (dilution ratio of 1:80 in 250 ppm hard water and 5% organic soil).
Salmonella enterica ATTC# 10708 10 0/10
c) CLAIM - FUNGICIDE - AOAC FUNGICIDAL USE - DILUTION TEST AT 600 ppm (dilution ratio of 1:80 in 250 ppm hard water and 5% organic soil).
Trichophyton mentagrophytes ATTC# 9533 10 0/10
d) CLAIM - VIRUCIDE - EPA VIRUCIDAL EFFICACY OF A DISINFECTANT FOR USE ON INANIMATE ENVIRONMENTAL SURFACES AT 600 ppm
(dilution ratio of 1:80 in 250 ppm hard water and 5% organic soil).
HIV type 1 Strain HTLV III Titer reduction > 3.5 log10
|