FORMPOLY Plastics Raw Material
SAEFTY DATA SHEET
FPL offers a wide range of technical Slipping hazard 鈥? Granules are of
compounds such as impact modified, flame slipping nature if spilled on the floor.
retardant, glass reinforced, mineral They are cylindrical in shape and have
reinforced etc., in polypropylene, low coefficient of friction. Any spillage to
Polyamide, Polyacetal, Polycarbonate, be swept away.
ABS, SAN, Alloys and Blends. Storage 鈥? No hazard during storage at
All the products are offered in cylindrical room temperature. Certain products like
pellets form unless specifically mentioned ABS, SAN may form lumps if stored at
in moisture proof bags of 25 Kgs. On higher temperature continuously.
request sea worthy and jambo bags of 500 Ignition 鈥? Spontaneous ignition is
Kgs are offered. possible is involved in mass at or near
Material Safety Data includes health melting point / softening point and in the
hazard, emergency & first aid procedures, presence of air. Water quenching of such
Disposal procedures and storage masses recommended.
information鈥檚. Special grades major Hot melt 鈥? Dropping of hot melt may
cautions are issued separately. cause high degree burns on the skin.
All products are intended for Industrial use Avoid direct contact. Treat after cold
only. water wash.
Special care for certain grades and materials on MSD
Polyacetal When exposed to high temperature, generation of formaldehyde will
Grades cause irritation to eyes. Max. ventilation and water wash for eyes
recommended
Glass Fibre May cause irritation to skin when in contact. Avoid exposure and avoid
reinforced loose packing of GF reinforced grades
Grades
Alloys Certain alloys contain maleic anhydrides and which causes irritation to
eyes and cause headache if exposed to continuously.
Coloured High heat stable pigments used are not evaluated for its contents. Avoid
Grades direct contacts.
FORMPOLY
The information present here is for general guidance. It is given in good faith but no warrant is attached
FORMULATED POLYMERS LIMITED
Works: 59, SIDCO Industrial Estate, Thirumazhisai - 602107, India. Ph: 0091 44 26811275
Office: Old No,AH-135, New AH-37, Shanthi Colony, Annanagar, Chennai 600 040, India.
Phone : 0091 44 26280171 :: Fax : 0091 44 26280174 :: E Mail : formpoly@vsnl.com.
Web Site : http://www.formulatedpolymers.com
" A QS9000, ISO 9001 & ISO 14001 CERTIFIED COMPANY "
|