FLOOR COATING AND FINISHING MATERIAL
AS TO SLIP RESISTANCE ONLY
17SU
Flashback
Floor Maintainers
SB
For Use On:
Sealed Wood
Linoleum
Vinyl Tile
Quarry Tile
Rubber Tile
Vinyl Asbestos
Marble
Terrazzo
Asphalt Tile
Spray Buff DESCRIPTION
This product removes all black heel marks and dirt, replacing
them with a brilliant shine that will actually upgrade the original
gloss of the finish. Saves time and money because less frequent
recoating is necessary, as well as extending time spans
between stripping.
DIRECTIONS
FOR SPRAY BUFFING: Remove all tar, gum, and excess soil
from the floor. Spray a fine mist of concentrate onto the floor just
prior to buffing. DO NOT OVERWET. Use a spray buff pad and
buff to a high shine. Turn pad over or replace as necessary.
This product meets the maximum content requirements for
Volatile Organic Compounds (VOCs) as established by state
and Federal regulations.
PRODUCT SPECIFICATIONS
Active Ingredients: 14.0 卤 0.5% Flash Point: None
Color: Milky white Solubility: Complete with water
Odor: Lemon-lime Black Mark Resistance: Excellent
Base: Polymers, waxes, sur- Sediment: 0.01% max.
factants and mild solvents Buffability: Excellent
pH: 9.0 -9.5 Storage/Stability: 2 years
Viscosity: Water thin Weight per Gallon: 8.43 lbs./gal.
Slip Resistance: Will not increase slip Freeze/Thaw Stability: Keep from freezing
Abrasives: None
Misco Products Corporation Reading, PA (800) 548-4568 FAX (610) 926-1194
www.miscoprod.com
FLS MATERIAL SAFETY DATA SHEET N/A=Not Applicable
Prepared by: Regulatory Affairs Dept. Effective Date: 5/99 Revision: 1/01
(Prepared According to 29 CFR 1910.1200)
SECTION 1-PRODUCT IDENTIFICATION AND SUPPLIER INFORMATION
Product Name: Flashback FS
Manufacturer's Name:
Misco Products Corporation Generic Name: Spray Buff
Manufacturer's Address: Chemical Family: Polymer/Detergent Blend
1048 Stinson Drive Reading, PA 19605 Formula: Proprietary
Manufacturer's Phone #: (610) 926-4106
SECTION 2-INGREDIENT INFORMATION
CHEMICAL NAME CAS NO. WT. % PEL TWA-TLV STEL-TLV
Water 7732-18-5 to 100
Acrylic Copolymer Dispersion 63744-68-3 5 to 10
Polyethylene Wax Emulsion N/A 5 to 10
Petroleum Distillates 64741-65-7 0 to 5 500 ppm 100 ppm N/A
Anionic Surfactant N/A 0 to 5
Perfume Oils N/A 0 to 5
SECTION 3-PHYSICAL DATA SECTION 4-FIRE AND EXPLOSION HAZARD DATA
Flash Point (Method Used): N/A
Boiling Point (掳F): 212 F. Specific Gravity: 1.012
Upper Explosion Limit: N/A Lower Explosion Limit: N/A
Vapor Pressure: 20mm Hg @ 68 F. Vapor Density (Air=1): >1
Extinguishing Media: N/A
% Volatile: 85+ pH: 9.0-9.5
Special Firefighting Procedures: Non Flammable
Solubility in Water: Complete Evaporation Rate (Water=1): <1
Unusual Fire and Explosion Hazards: N/A
Physical Description: Thin milky white liquid with pleasant odor.
SECTION 5-REACTIVITY DATA
Stability: Stable Hazardous Polymerization: None
Hazards Decomposition Products: Will not occur. Incompatibility (Materials to Avoid): None
SECTION 6-STORAGE AND HANDLING INFORMATION
Keep out of reach of children. For use by trained personnel only. Keep unauthorized personnel away when applying to floor. Keep container closed during storage. For
institutional and industrial use only. Avoid contact with eyes, skin and clothing. Avoid breathing of vapors. Use in well-ventilated area.
SECTION 7-HEALTH HAZARDS AND FIRST AID SECTION 8-SPECIAL PROTECTION INFORMATION
Effects of Overexposure: Respiratory Protection: No special requirements.
Skin: Prolonged or repeated contact may cause dermatitis. Ventilation Requirements: Provide local exhaust to keep TLV of Section 2 in-
Eyes: Eye irritant. May cause redness or swelling. gredients below acceptable limit.
Inhalation: Mist may irritate nose, throat and lungs. Protective Gloves: Chemical resistant rubber or neoprene.
Ingestion: May be irritating to the mouth, throat, and gastrointestinal system. Eye Protection: Safety glasses or chemical splash goggles.
Vomiting and diarrhea expected with large doses. Other Protective Equipment: N/A
First Aid Procedures: SECTION 9-SPILL OR LEAK PROCEDURES
Skin: Flush with water. Seek medical attention if irritation persists. Steps to be taken in Case Material is Released or Spilled: Floors will become
slippery. Avoid walking in product. Keep unessential personnel away. Mop up or
Eyes: Flush with large quantities of water, holding eyelids open. Seek medical
otherwise absorb and hold disposal. Avoid discharge to sewer or open waterways.
attention.
Waste Disposal Method: Any method in accordance with local, state and federal
Inhalation: Remove victim to fresh air and monitor.
laws. Best method is to recycle or reuse for intended purpose. Consult local
Ingestion: Dilute with 2 glasses of water. Seek medical attention if symptoms
authorities for disposal in public sewer. Do not dispose of into storm drain,
persist.
stream, river or to ground. Rinse container thoroughly before discarding in trash.
SECTION 10-REGULATORY INFORMATION
HMIS Hazardous Materials
SARA Title III - Section 311/312 -Hazard Categories: Shipping Information:
No - Fire Hazard FOR CONTAINERS > 1 Gallon : Cleaning Compound Identification System
No - Sudden Release of Pressure Hazard Health 1
No - Reactivity Hazard FOR 1 GALLON CONTAINERS : Cleaning Compound Flammability 0
Yes - Immediate (acute) Health Hazard Reactivity 0
No - Delayed (chronic) Health Hazard FOR CONTAINERS < 1 GALLON : Cleaning Compound Personal Protection A
FOR EMERGENCY MEDICAL OR TRANSPORT INFORMATION: CHEM-TEL, Inc. @ 800-255-3924 (24 hours, 7 days per week)
This product contains the following toxic chemical(s) subject to the reporting requirements of section 313 of the Emergency Planning and Community Right-To-Know Act
of 1986 and of 40 CFR 372.
CAS# Chemical Name Percent by Weight
None
This product contains the following chemical(s) which have been established to be either a carcinogen or suspected carcinogen.
CAS# Chemical Name Percent by Weight
None
SECTION 11-OTHER INFORMATION
This company cannot anticipate all conditions of handling and use of this product. Therefore, this company accepts no responsibility for results obtained by the
application of this information, or the safety and suitability of our products either alone or in combination with other products. It is the responsibility of the user to
provide a safe workplace, using the health and safety information contained herein as a guide. This company will accept no liability for damages or loss incurred from
the improper handling and use of this product
|